The network did not generate a network address for this computer, what should I do?

1.Check whether the router is automatically assigned IP addresses or supports DHCP.

2.If it is not supported, select Manually fill in the IP address, manually fill in the Network Connection - Properties - IPv4 option, fill in the IP address must be the address range supported by the router, and fill in the subnet mask. This information can be viewed in the route configuration interface;

3.There is also a possibility that you did not plug in the network cable when you turned on, and the network card could not get the address and assigned an address to yourself, if this is the case, it is recommended to restart the network card after plugging in the network cable, or restart the computer.

Change to automatically obtain or manually bind an address.

1. First of all, check whether the wireless router is correctly connected to the network and connected to the external network;

2. Secondly, check whether the network parameters (subnet mask and gateway) set by the computer are consistent with the network parameters set by the wireless router, and it is best to set it to automatically obtain;

3. Thirdly, check whether the wireless password is entered correctly;

4. Fourth, check whether the dynamic IP segment set by DHCP of the wireless router is sufficient [for example, if 10 dynamic IPs are set but 11 devices are connected (the total number of wired and wireless networks), the address will be insufficient].

Given your situation, there are generally two scenarios.

1. After the repair of the optical cable line of telecommunications, in order to re-test whether the network is repaired, a new IP address will be set up again, and the network you originally established must be re-set and establish a new network, if you are using a router to establish a network, you can change the original computer jack on the router to try.

2. Hardware problems, here is the replacement, wireless routing settings, and computer cables, etc., you can try to reset the wireless router first, if the problem is not solved, then check whether your network cable is faulty.

Hope you like my answer.

Repair the computer is not to dial your router, directly dial up to a computer to access the Internet.

Usually the network assigns an IP address to a computer through DHCP. If you don't have a network address assigned, there can be many scenarios.

2.It may be that your network does not have DHCP to assign an address, and you need to manually set the IP address statically.

3.You may not be authenticated and therefore cannot be assigned a network address.

The specific situation needs to be analyzed on a case-by-case basis.

The problem of the network operator I was like that a few days ago, and then I called**, and the guy said that he forgot about my computer and installed a router for me, and the Internet speed was OK.