-
Anonymous users2024-02-05The computer always rings when the host is turned on, "this description is too general.,Guess it should be the BIOS error sound.,You have to listen to how the error is reported.,The following information you look at it almost knows that it's a problem.。
Award's BIOS Alarm Sound:
Number of times connotation.
1 Short: The system starts normally. This is something we hear every day and it also shows that there is nothing wrong with the machine.
2 Short: General error, please go to CMOS setup and reset the incorrect option.
1 Long 1 Short: There is an error with the RAM or motherboard. Try to change the memory, if it still doesn't work, you have to change the motherboard.
1 Long 2 Short: Wrong monitor or graphics card.
1 Long 3 Short: Keyboard controller error. Check the motherboard.
1 Long 9 Short: Motherboard flash RAM or EPROM error, BIOS corruption. Try a different block of flash ram.
Constant ringing (long sound): The memory module is not plugged in tightly or damaged. If it still doesn't work, you can only replace a memory module.
Ringing: The power supply and monitor are not properly connected to the graphics card. Check all the plugs.
Repeated short rings: Power supply issues.
No sound, no display: Power issue.
AMI BIOS Alarm Sound:
Number of times connotation.
1 Short: There is a problem with memory refresh.
2. Short: Memory synchronization check error, internal ECC check error, in CMOS setup, set the memory about ECC check option to disabled, it can be solved, or the memory can be replaced.
3. Short first 64kb memory segment check failed.
4. Short: The system timer fails.
5 Short Processor Error.
6 Short Keyboard Controller 8024, A20 address line is wrong.
7. Short Processor Abnormal Interrupt.
8. Short Poor contact of the graphics card or wrong video access.
9 Short ROM BIOS check error.
10 Short CMOS shutdown scratchpad access error.
11. Short external cache error.
1 long 3 short memory error. If the memory is corrupted, just update it.
1 long 8 short shows test errors. The monitor cable is not plugged in properly or the graphics card is not plugged in properly.
-
Anonymous users2024-02-04How to make a sound, if it doesn't work, open the case first, check to see if it's the fan reason, and hopefully it's not the sound of the hard disk.
Is there a problem with the BIOS settings?
-
Anonymous users2024-02-03The memory is not loose. Each interface is plugged in a little tighter.
That's your BIOS alarm tone.
First of all, you should be clear about what your motherboard's BIOS type is, you can check it by reading the manual or through the POST. >>>More
There is a problem with the system, and the system needs to be reinstalled.
You try this method first:1Click Start, and then click Control Panel. >>>More
...When this happens. Hold down the fan.
The last thing I found was the graphics card fan. If you're not the kind of problem. Pay attention to listen to it, it is sent out**. >>>More
1. Memory problems, solutions.
1. Use an eraser to wipe both sides of the gold finger of the memory and blow off the dust of the memory slot. >>>More