How do you wax a car? Where to buy wax?

Car wax is available in 4S stores and car supply stores, as well as online. The specific procedures and methods of waxing are explained in detail below.

Procedure for waxing cars: ].

1.Car washing.

In order to ensure the waxing effect, the vehicle must be thoroughly cleaned before waxing.

2.Waxing. Waxing can be divided into manual waxing and mechanical waxing, manual waxing is simple and easy, mechanical waxing efficiency is high.

Whether waxed by hand or mechanically, it is important to ensure that the paint is evenly applied. When waxing by hand, first apply an appropriate amount of car wax on the sponge (special polyurethane waxing sponge, such as 3m polyurethane waxing sponge, use an inappropriate sponge, if the texture is too hard, it may cause scratches on the paint surface), and then apply in a circle in a certain order, each application should have a degree of overlap with the upper application area of 1 5-1 4, to prevent missing coating and ensure uniform application. When the machine waxes, the car wax is applied to the sponge of the waxing machine, and the specific application process is similar to that of the hand, it is worth noting that the application at the edges, corners and edges should avoid exceeding the paint surface, and it is easier to grasp the manual application in this regard.

3.Clean. According to the instructions of different car waxes, it can be wiped 3-5 minutes after application. Usually non-woven or microfiber cloth is used to reciprocate in a straight line, and press appropriately to remove the remaining wax and improve the gloss of the paint.

Pay attention to the following issues:

1. The waxing environment is clean, there is good ventilation, and a special waxing workshop can be set up if possible.

2. The car should be waxed in a cool place, otherwise the temperature of the car surface will be high, and the adhesion ability of the car wax will decrease, which will affect the waxing effect.

3. Before waxing, the non-construction area should be protected, such as rubber parts and plastic parts are non-construction areas that do not need to be smeared, and attention should be glued with paper tape to prevent the wax from being coated on it, so as not to be easily removed after the wax is dried.

4. When waxing, the running route of the manual sponge and the sponge of the waxing machine should be carried out in a circle, so that it can be applied to the paint surface more evenly and ensure the combination with the paint surface.

5. When waxing, the principle of first up and then down should be followed, that is, the roof, front and rear covers, and sides of the body should be applied first.

6. When waxing, if the sponge has the same color as the car paint, it may be that the paint surface has been damaged, and the waxing should be stopped immediately and repaired.

7. After wiping, carefully inspect and remove the residual car wax from the license plate, headlights, door edges, etc., so as not to affect the appearance.

8. After waxing, the equipment and supplies should be properly cleaned and stored properly.

9. To master the frequency of waxing, due to the different driving and parking environments of the car, the waxing interval can not be done step by step, and the normal waxing cycle is about 2-4 weeks.

There are three types of car waxing: manual waxing, pneumatic tool waxing and electric equipment waxing. It depends on the paint of the vehicle to determine which way to work.

It is recommended to go to a professional car beauty shop for waxing maintenance. This is because the paint surface needs to be deeply cleaned before waxing, and then waxed and cured. Personal deep cleaning is not very well done, so that the paint dirt will also be sealed under the wax layer.

It doesn't serve the purpose of protecting the paint.

I can go to both the 4S shop and the car repair shop, I go to the repair shop of a friend, the 4S shop is too expensive.

Car waxing is divided into two categories: manual and machine, and manual waxing can be done from top to bottom by drawing circles.

Steps for waxing:

1.Use tape to separate the parts that need to be waxed;

2.Pour an appropriate amount of polish on the green sponge block (if the scratches are light, use the green sponge directly, if the scratches are deep, use the gray side with a fine frost);

3.Wipe back and forth in a straight line along the scratched area;

4.After a few minutes, wipe clean with a soft cloth;

5.After wiping, check the waxing effect.

Step 1: Car Wash.

The first step is, of course, to rinse your car well, and it is best to wash it thoroughly with a special car wash liquid.

Step 2: Wipe dry.

After the car is rinsed, the car should be thoroughly dried with a car cloth, it is not good to wax the paint surface with water, and then drive the car to a cool place and prepare for waxing.

Step 3: Waxing.

Use a round sponge for solid wax to dip it in wax and evenly apply it to the surface of the paint, without applying too thick, a thin layer. During the application process, you can use a sponge to evenly draw circles on the body to make the wax appear like a fish scale on the paint surface.

Step 4: Drying.

After application, wait 5-10 minutes for the wax to dry thoroughly. At the same time, cover the rest of the wax for next time.

Step 5: Polishing.

Use a microfiber towel to polish the paint surface like a shoeshine on the paint surface, that is, wipe off the excess car wax until your car is as bright as new, and the whole waxing process is over. In fact, it is similar to the process of shoe polish, but the area is much larger.

Car waxing is a hard work, no need for special tools, there are clean towels on the line, as long as you have the ability to play yourself, as for how to play in the text is difficult to express clearly, I suggest you drive to the car beauty shop to wax once, you will watch them play on the spot, the whole process will be learned after reading. The wax is a special wax for automobiles, all large supermarkets and car accessories stores have **, I have been raising a car for more than ten years, and my car has always been waxed by itself.

Generally speaking, there are only benefits to waxing, and there is no harm, unless the wax you use is not good, and the chemical reaction damages the paint, which generally does not exist.

1.Wash your car. The first step in waxing a car is to wash it, as it doesn't make sense to wax a car covered in dust, pollen, and bird droppings. Before you start waxing, make sure it's dry.

2.Find a shaded place. We don't recommend waxing your car in direct sunlight as the sun will quickly dry the wax while you're waxing. Also, if it's hot outside, you'll be more comfortable in the shade.

3.A thin layer of wax is formed on the surface of the car in circular motions. Avoid applying wax to headlamps, windows, and plastic trim.

You may feel tempted to add more wax to make the application process faster, but don't do that. If you add too much wax, it won't dry out properly and you'll end up with a lot of residue and you may have to re-wash your car to get rid of it.

4.Allow the wax to dry and wipe it off with a microfiber towel in circular motions. By the time you're done waxing, the first part you've waxed should be dry and ready to grind off.

When the wax has a matte, chalky appearance, you know it's ready to be worn off. Once you've worn it off completely, your car paint will have a nice finish that will be very shiny and shiny.

The process of waxing is tedious, but dividing the operation into several parts can make it easier to complete. Work on the hood, fenders, doors, trunk, and other panels in a certain order to make sure you don't miss a single place. If you need a little motivation to keep going, grind off a small portion of the wax to see the results.

If you want to wax the car, you must repaint the car, and then when it is dry, apply the wax evenly on top of the car. He waxes in circles. This will keep the wax even, and finally rub it again with deerskin.

Under normal circumstances, I just ride, if you want to wax this year, this can go directly to the local 4S shop and go directly to the house to fight, which is a very good behavior, you can go here directly to have a look!

How do you wax a car? You can go to a professional car four-s shop. and let him wax your car.

It's professional. You need to come to the store and learn the process well.

Try it yourself.

Wishing you health and happiness.

The right steps for car waxing It is recommended to wax and wash the car on a cloudy day, and it is also possible indoors.

Wait another 30 minutes after washing and drying.

Polishing: According to the instructions of different waxes, polishing can be carried out in 5 to 10 minutes after application. When polishing, follow the principle of waxing first and polishing first to ensure that the polished car surface is not polluted, and the polishing operation usually uses a non-woven towel to reciprocate in a straight line, and press it appropriately to remove the remaining wax.

Air-drying: If you use wax like shoe polish, it will take 2 to 4 hours to dry, and the wax water will be much faster than 1 hour.

Polish: Use a dry cloth to wipe off the wax and polish.

The steps for waxing car paint are as follows:

1. The body needs to be washed and dried before waxing. Waxing in the sun will cause the softener in the wax to volatilize rapidly, resulting in the rapid solidification of the active ingredients in the wax, which is not conducive to full penetration.

2. Waxing should be carried out block by block according to the sand board area of the body.

3. Do not wax glass, black unpainted plastic parts and tire rubber.

4. Wax with a sponge or soft cotton cloth dipped in a small amount of wax, dot a whole row with the dot ellipsis technique, and then use the wrist to draw a small circle in the whole line. The dynamics should be even and smooth. You have to order a row and wipe a row immediately.

Draw circles and rows as neatly as possible, and do not repeatedly wipe the parts that have dried up. If you encounter stubborn marks such as scratches and paint marks left by foreign objects, you can rub them appropriately to remove them.

5. After the waxing of the whole body, open the door and supplement the door frame. There is no need to wax the inside of the cabin cover and tail box cover. Cover the used wax jar tightly in time to prevent volatile deterioration. Approach the chassis of the car last so that no sand and gravel can get mixed in.

6. About half an hour after the wax surface dries, wipe it clean with a soft towel in the order of waxing. Be sure to close all doors and windows when wiping to prevent dust from drifting into the car. When wiping is done, use a feather duster to remove the dust.

Step 1: Car Wash.

The second step is waxing, when waxing by hand, first apply an appropriate amount of car wax to the sponge, and then apply it in a circular circle in a certain order;

The third step is wiping, generally 3 to 5 minutes after waxing, wipe it evenly, and wipe it in a straight line with the textile or microfiber cloth we have prepared, and be sure to remove the wax on the surface of the paint to improve the gloss of the paint.

Steps for waxing:

1.Use tape to separate the parts that need to be waxed;

2.Pour an appropriate amount of polish on the green sponge block (if the scratches are light, use the green sponge directly, if the scratches are deep, use the gray side with a fine frost);

3.Wipe back and forth in a straight line along the scratched area;

4.After a few minutes, wipe clean with a soft cloth;

5.After wiping, check the waxing effect.