Tengda TEL6608s router, help!! 80

There could be two reasons for this:

1.If there is a problem with your router itself, you can go to the place where you bought the router to check it.

2.The broadband you installed is precisely bound by the operator, which means that your broadband is bound to your computer's own MAC address, resulting in unsuccessful dial-up with other devices.

The line that comes out of the **, first pass the cat, and then the line that comes out of the cat is connected to the WAN port of your router Remember that it is the WAN port, don't make a mistake, you are estimated to have received the LAN port!

Then enter the router, select PPPoE dial-up Internet access, don't change the general attributes, just press the default!

Both PCs opted to get the IP automatically!

If you buy a router, you have to use it.

Of course, you can't use the same account to dial two computers at the same time, and it is impossible for telecom to let one account be dialed multiple times, so you need to use the router to dial the number for you, and then your two computers go to the Internet through the router.

Method: The cat is connected to the WAN port of the router, and the LAN port is connected to your two computers. The computer does not need to dial the number, it can be set to automatically obtain the IP.

Then go to Quick Settings, select ADSL dialing (some routers use the protocol name that is pppoe), and the next step is to fill in the account password and save it. Theoretically, you'll be online in a dozen seconds.

You set both computers to automatically acquire IPs. Don't use dial-up Internet access in the computer, the router already has that function, if you Zen wheel you can delete the broadband connection in the computer!

Then, enter the router, set the dial-up Internet access and password, enter the running status page, click on the Lianhe dry letter, wait a while, see if there is a connection!

If it doesn't work, you power off the cat, then power off the router again, and then re-enter the router, running state, click connect!

I've encountered this too! Get rid of the cat first! If it doesn't work, the router has a reset button behind the router! Press factory reset! It's supposed to go in, or you're going to be this IP

You type it in the address bar on my computer.

There will be a dialog box popping up asking you to enter the password.,The general initial password is admin.,The username is admin.,There's a prompt step by step after you enter.,Even if you don't have to, you can learn it.

How to open the gateway configuration interface of the wireless router:

2.Open the computer browser and enter the gateway IP address of the nameplate on the back of the router (generally, enter the router account password, and the nameplate on the back of the router is usually written.)

3.Go to the gateway configuration page.

Then you enter to try.

Look for the reset button on the router and restore the factory settings to see.

Can a Service Provider Restrict Routing? It's the first time I've heard of it! Learn! I used Telecom 2M! More than 20 machines were brought with the route! No problem! If Netcom will be restricted, then the telecom technicians are all fools, they won't be able to!

Set your IP to be obtained automatically, and then take a look at the local connection, details. You can see the IP address and gateway, and the gateway is the gateway that enters the router.

Open the online game settings and restore the defaults

Are you setting up a router bucket for automatic dialing? That is, after you connect to the computer, you can rent it directly, you can access the Internet, and you can use the empty type without dialing.

Limited or no connection" to add the computer's IP address, gateway, DNS should be fine.