3500dpi Razer Inferno Viper Upgrade Mouse Issue

I've been playing cf for a while, Viper MX518 G1 Golden Snake has Viper hair fluttering because his induction is too good The old version of the brush firmware may have lowered the induction brush 3500 version of the Viper has not yet been out of the firmware, but even if it comes out, the estimated effect is not so ideal Play CF games, I recommend using or mx518 This is what I just replied to someone else's 3500 version of the Viper There is also heat This may be the reason for his double-layer circuit board You can also choose MX518 There are side buttons that can be programmed independently Ergonomics is stronger than that of a viper.

Eh,I just bought it.,It's a bit of a problem.,Mine is a combo.。。。 Hehe, it's hard to say, hey.

It's really comfortable to use the feel.,And in the driver, you can adjust the interval between double-clicks.,It should be able to solve the problem of double-click you said.,The side button is also very good.,In addition to being able to set different buttons, you can also set it to a combination of several keys.。

The upgraded driver software of the Purgatory Viper can be found on the official website of Razer, and there is no Chinese version yet, but we have received official news that the Chinese version of the driver will be launched in the near future. After installation, you can see that the interface of the software uses Razer's characteristic green and black colors. On the main interface, you can set the function of the buttons, the light on and off, the return rate, the DPI and *.

It can be seen that there are three kinds of return rates and 1000hz, the higher the cursor positioning, the more accurate the positioning, but at the same time, the requirements for computer performance are also higher. In terms of DPI, there are four DPIs to choose from, but it's a pity that you can't set DPI at will. Different profiles can save different settings, for example, profile1 is set to normal use, profile2 is the setting required to play CS, and then press the profile key at the bottom to switch it.

Then let's see what functions the keys can be changed to. The above 5 buttons can be replaced with double clicks, change DPI, cancel buttons, etc., and the scroll wheel provides fewer options to scroll up and down. However, the most important macro function is still supported, and after selecting the macro in the "Advanced Functions", you can set the macro and provide a delay of 50 milliseconds.

If you select singlekey, you can directly select functions such as copy, paste, switch windows, mute, etc. below.

Finally, the green arrow on the left side of the interface can open the settings of the sensor and other aspects, where you can adjust the sensing rate, click speed, cursor acceleration, etc. In addition, it is possible to adjust the rate of the x-axis and y-axis separately, which is very practical.