If the computer suddenly crashes, is it caused by the hard disk overheating, is it a hardware proble

In terms of probability, any kind of hardware (CPU, graphics card, memory, north-south bridge on the motherboard, hard disk) is a killer that will cause a computer to crash.

Let's talk about how to deal with my computer overheating and crashing, I hope it can help you!

There is no air conditioning in my room, and an electric fan can only basically solve my own heat dissipation problem, and I am depressed when I look at the computer and often freeze. So do it yourself and take all the parts that are heating (disassemble the case and touch it with your hands; A lot of software can't measure accurately. As long as you feel that your hands are hot, there is a problem) all install cooling fans.

The specific method is to connect it there if it can be led out of the fan pins of the motherboard. If you don't have too many ports (usually two, one is the CPU fan connector, and the other is the fan connector reserved on the motherboard for cooling the case), connect the extra wires from the host power cable. The motherboard I use now is a Foxconn 848, the CPU is a PD hard drive is an old Seagate with an IDE interface, and the graphics card is an MX4000 remarked to 5200 (only a good large heat sink, no fan).

After disassembling the case, touch them without being hot to the hand. They are the ones that cause the temperature of my case to keep rising.

In particular, the heatsink on the south bridge of the motherboard is the hottest, and I tied a fan to it with thin wire. Hehe, do you understand when you talk about it? Find a way to fan them to cool them down.

In the end, I found a case fan for hard disk cooling, and then found a thick little square to squeeze on the hard drive bracket. I tried the tightness and thought it was ideal. Connect its power cord with the power cord of the South Bridge fan, and then connect it to the host floppy drive (there is no floppy drive anymore, why do you need that cable?!).

power cord. Specifically, you can check the wiring method on the Internet; The fan added to the graphics card heatsink is directly removed from the discarded CPU cooling fan, and it can be tightened with a suitable long-leg screw to the heatsink.

God, it's hot! Hope mine can help you a little.

Overheating of the hardware has the potential to cause the computer to freeze. You can use Master Lu or other software to test the temperature to see, there is a lot of dust in the case, and fan failures will cause the CPU and graphics card to be too hot. It may also be that there are too many processes running or that are using a lot of resources (possibly due to malware).

Clean up the dust in the case, check whether the fan is noisy, clean up system junk, plug-ins, unnecessary software, and disable unnecessary startup items.

What you say is too general to judge.

It shouldn't be the hard drive. It's normal for the hard disk to be 51 degrees, why does it prompt that the temperature is too high?

There are many reasons for the crash, and I will give you a few ways to find the problem, you can try it.

1。If the temperature is too high, it means that the CPU cooling conditions are not good enough, and the heat dissipation environment needs to be improved. (Most of the crashes are due to this issue).

2。The driver selection is not stable enough. It is recommended that all your drivers choose a WHQL-certified version to ensure that your machine runs stably.

3。Software conflict, if you are in the process of use, suddenly crashed, you have to pay attention to whether it is caused by the application of a certain software, such as games, QQ, word, etc. Switching to a different version will solve the problem.

4。For hardware problems, open the box to see if the capacitors on the motherboard are bulging or bursting; whether the bare metal crashes often when it is running; After running for a period of time, touch the graphics card and CPU cooler with your hands, whether it is hot, if it is hot, you should find a way to improve the heat dissipation conditions; Remove all the accessories, wipe the gold finger with an eraser, and then put it in; Check whether the memory burning is complete, whether there are hanging marks or other missing corners; Replace a power supply with better quality and higher power. Check the hard disk for bad sectors with the Efficiency Source Disk Bad Sector Detector.

In general, the cause can be found through the above checks.

Do not install the hard drive too close to the chassis. Affects heat dissipation.

If the hard disk itself heats abnormally, just find someone to replace it-

That thing doesn't usually come to you.

Your computer's cooling may not be very good.

You can get a bigger fan.

The hard drive should probably be fine.

But frequent automatic shutdown will reduce the service life of the hard drive!

The heat generated by the hard drive itself is negligible, and if the hard drive will overheat, if there is a hardware failure, it is most likely that there is a problem with the cooling air duct of your case, which discharges the heat to the hard drive.

One is that the heat dissipation is not good, the second is that the power supply is insufficient, and the third is the hardware conflict, the memory may also have problems, and the hardware is incompatible. These are the three general directions.

Disk defragmentation and disk cleanup are recommended.

1: When playing a large game, there will be a lot of data to be read in the hard disk constantly, so it will heat up.

2: A copy of a large amount of data will be used on the hard disk.

3: The heat dissipation of the computer is not very good, and the heat of the hard disk cannot be dissipated when it is working.

4: The quality of the hard disk itself is not good enough, and the internal structure of the computer is not reasonable, which will also lead to this problem.

5: To solve the problem, it is recommended to clean up the dust and add a radiator.

The operating temperature limit of the hard drive should be around 70.

The circuit board is the same as other electronic products, the limit temperature can reach about 100 degrees, but the platter can't stand it, and the magnetic material is easy to lose magnetism at high temperatures.

Under normal circumstances, the temperature of the hard disk is generally 10---20 degrees higher than the room temperature, which has little to do with the size of the hard disk. Summer is different from winter, summer can reach up to 60-70 degrees, SCSI hard disk temperature is higher, serious can burn your hands. Generally, the normal working temperature of IDE hard disk is about 30-50 degrees, and the temperature of your hand is about 35 degrees, so it is normal to have hot hands.

That's because the computer is frequently reading data from the hard disk, which will cause the hard disk to generate heat, and the air duct of the case is not smooth, which is not conducive to heat discharge.

The temperature of the hard drive is really high. Normal.

I think that you can increase the memory and let the BT software use the memory as a buffer, which can greatly reduce the number of reads and writes to the hard disk, which is also a way

I think that you can increase the memory and let the BT software use the memory as a buffer, which can greatly reduce the number of reads and writes to the hard disk, which is also a way

Not necessarily, it could also be a system issue.

The problem with the system is relatively large, and in the absence of a virus, trying to reinstall the system is the best option. If there are still frequent crashes after reinstallation, it may be a hardware problem.

Since some applications require a large amount of memory to run, disk space is needed to provide virtual memory, and if the remaining space of the hard disk is too small to meet the running needs of the software, it is easy to cause crashes. The solution to this problem is to divide the disk space reasonably, use the "disk defragmenter" to regularly organize the hard disk, and clean the hard disk of junk files.

Poor heat dissipation will also cause this situation, it is recommended to clean up the dust, if you don't understand, disassemble the host, don't cover, but keep the environment clean. CPUs, movies, graphics cards, and other fans can be replaced. It is better to add new solder paste.

It is not recommended to dismantle because it is easy to break. It is recommended to change.