How to make your own electronic rat killer? How to make an electronic mousetrap

How to make it? The method I said is dangerous, and it is necessary to ensure safety.

1. Use a current transformer to turn the current into 12 volts.

2. Lay the line in a place where rats often pass.

3. Personnel must pay attention to the power supply after connecting it.

4. After linking the delivery seat, be sure to install the trip to prevent injuries!

Precautions: Be sure to install the disconnector to prevent personnel from being injured, especially for "children". Don't hurt people because of this. Remember to install the disconnector well to prevent electric shock!!

Produced by Guangzhou Xinkewei Electronics Factory

I think it's better to buy one.

There are decoys, and then with mechanical ones can also be biological.

Let's buy one, can you make it homemade?

If you also v yellow-crowned grass suit good or bad.

Preparation materials: AC power supply, connecting wire, iron sheet, insulating screws, aluminum wire, electric drill.

1. First use an electric drill to drill two holes on both sides of the iron sheet, and then connect the iron sheet with screws.

2. The length of the splicing is determined according to the actual site.

3. Tie the aluminum wire to the screws.

4. Connect the red line of the connecting wire to the red hole of the power supply, and connect the black wire to the black hole.

5. After the preparation is done, put the electric mouse device in the place where the rat is infested, and then clamp the red clip of the connecting wire to the aluminum wire, and the black clip to the iron sheet.

6. Connect the AC power supply and wait for the mouse to fall into the net.

A simple and easy-to-know homemade mouse repellent device, one catches one accurately, and the rats are going to suffer.

Preparation materials: iron wire, insulating screws, iron sheets, AC power supply, wires.

1. Use insulating screws to connect the iron sheets together.

2. According to the actual situation, connect to the appropriate length with absolute screws and iron sheets.

4. Cut the wire after connection, and pay attention to tighten the wire.

6. Clamp the black wire on the iron plate and the red wire on the wire.

7. Finally, turn on the power supply.

Sharing a simple way to make a mousetrap, in order to catch mice, it is really painstaking.

The main working principle is to turn the output voltage into pulse high voltage through the built-in transformer, which is generally about 2000 volts; The current is converted into a current of less than 36 mA that meets the safety standard, which is generally around 20 mA. and two wires are drawn from the rat exterminator, which work similarly to the electric batons used by the police.

As long as the rat touches these two wires at the same time, it will be stunned by the high pressure of the positive object width. Because it has a small current, it is relatively safe for all living things except rodents. On the original ant track, these two wires can be stretched one kilometer long, in other words, a one-kilometer electric baton is used to deal with mice.

It is important to install the electronic rodent exterminator in the right way.

The working principle of most electric rat killers on the Internet is that the transformer is boosted, the primary is 220 volts, the secondary is boosted to 2000 volts, and the output is limited by 50nf capacitance, and the electric mouse network cable is connected. At 3K load, the voltage at both ends is 110 volts, and the current is 30 mA.

It turns out that the working principle of the autoclave rat exterminator is so simple? I learned how to make it myself.