Router sharing Internet access, how to share Internet access on the router at home

To put it simply, the router is used for automatic dialing, as long as your router has a few jacks, it will work, if there are only 2 jacks (one is ** line, one is network cable) then it is terrible.

If you want several machines to share a cat (today's cats generally have routing functions), then buy a switch to practice the cat, and then divide several network cables from the switch to connect to the computer.

As long as your router supports your dial-up method, it's fine. Generally speaking, it is now more than the ADSL method, and this is definitely supported.

Yes, that's what routers are used for. The cable of the bar Netcom is plugged into a separate interface (WAN interface), and the other 4 machines are connected to their respective machines with the other 4 ports, and then open the web page and enter it in the address bar.

Or the general router uses this as the default login address) and then press enter to set the password point connection, okay, now 4 machines can access the Internet, and you can also play CS Diablo 2 and other games on the LAN.

No way. You figure out how it works.

A router is to establish a local area network and must have a gateway.

If the router can, what else does the production switch do.

Merchants are not fools.

It won't save money.

1. Prepare a network cable. One end of the network cable is connected to any of the LAN (1,2,3,4) of router 2, and the other end of the network cable is connected to the computer as shown in the figure below. Note: Router 2 does not need to be connected to Router 1 for the time being, please note this.

If the IP address of Router 1 is, the IP address of Router 2 is modified to.

Tip: After modifying the IP rights of the LAN port, you will be prompted to restart the router. After restarting, you will need to enter the changed IP address in your browser to log in to the Router 2 settings screen, such as or.

3. Prepare another network cable, one end is connected to the LAN (1 2 3 4) interface of router 1, and the other end is connected to any LAN (1 2 3 4) interface of router 2. Be careful not to connect to the WAN interface of Router 2.

4. Turn off the DHCP server on router 2: Click "DHCP Server" - >DHCP Service" - >DHCP Server" and select: Not enabled > click "Save".

After completing the four appeal steps, Router 2 has access to the internet. If you want to use wireless wifi on router 2, just set the wireless wifi name and password on router 2 without any other settings.

Theoretically possible.

After connecting to WiFi with a wireless network card, in the Control Panel Network and Internet Network Connection, find your wireless network card, right-click, Properties.

Click on the Share tab, check "Allow other network users to connect through this computer's Internet connection", and then select your wired network card from the drop-down box below.

Pay attention to the IP address of the prompt box, this IP is the gateway to be configured on the router, remember this IP. Click OK.

ip: subnet mask:

Gateway: dns1:

DNS2: Be aware that your computer may be using a different IP. If it is 122, then the IP address configured on the router and the 137 of the gateway will be changed to 122).

After the configuration is complete, the network port of the computer is connected to the WAN port of your router (note that it is a WAN port, not a LAN port).

Then as long as your computer can access the Internet normally, your router's wifi can also access the Internet normally!

Turn off the firewall and you can ping each other.