How to paste wallpaper on windows, how to paste wallpaper on the edge of windows

Step 1: 1> ruler measure the circumference of the wall from the yin corner to the other yin corner, leave a little leeway, cut the wall cloth, paint the stirred glue on the wall, paint evenly from the middle to the corners, and never paint the glue on the wall cloth.

2> Check whether there is a quality problem with the wall covering, calculate whether the purchased products are sufficient, and check whether there are still the same batch of products.

3> Check whether the wall surface is well treated (dry, flat, hard).

4. > glue: special glue for strong, environmentally friendly wall cloth must be used.

5. > cutting: the construction cutting environment should be clean, and attention should be paid to the good flowers when cutting the flower wall cloth.

6> The wall covering should not be soaked in water before pasting.

Step 2: All flower matching products are overlapping edge tailor construction, and the flower should be started from the middle of the wall to achieve the best flower effect.

2> Brush glue on the wall to avoid glue sticking to the surface of the wallcovering. If it spills, wipe it clean with a damp cloth.

3> In order to obtain a good joint effect, the side seams must be pressed with a pressure wheel, otherwise the wall cloth is easy to show joints after drying.

4> Ensure that the surface of the wall cloth is clean when pasting, and the hands of the construction personnel should also be kept clean.

5> Do not allow oil to stain the surface of the wallcovering.

6> Close doors and windows during construction and within 2 days after construction. Let the wall cloth dry naturally, and prohibit the use of air conditioners and dryers, otherwise it is easy to warp and crack.

7> The utility knife should be kept sharp when trimming, and the blade should be kept at an angle of 25 degrees with the wall, and the force should be even, otherwise it is easy to have burrs.

8> After pasting, wipe off the excess glue with a wet towel and carefully check again if there are air bubbles, if there is a needle to deflate or use a needle to inject glue to scrape flat, and finally use a wall cloth knife to cut the left and right sides.

Step 3: 1> If there is a warping phenomenon, it needs to be reworked and repaired, usually with wallcloth joint repair glue filler, and press and roll to fix, if the edge is hardened and bounced, you can use water to wet and soft after filling and pressing.

2> If there are bubbles or hollow drums, you can use a wall cloth knife to separate a small opening, release air, inject glue and compress tablets.

3> A little stain can be wiped with a clean sponge living wipe; The dust can be cleaned with a vacuum cleaner and puffed clean with a feather duster; Ink marks can be cleaned with a small mixture of ethanol, water, and detergent; Oil stains can be cleaned with turpentine or mixed with 50% water and water.

Translucent stickers can be attached to the bathroom windows, and other places are not conducive to lighting!!

Other windows are not recommended to be pasted. To take into account the long-term problem, at the beginning of the new home when I think it looks good, but after a long time, it will lead to a lot of annoying problems, such as: there are cracks, Huangmeitian is damp and causes the wallpaper to roll up, etc., when you want to tear it off, it will leave traces, so try not to stick.

Wallpaper on windows? Is it on glass? All I know is that I use adhesive tape, and it's easy to take it off when the time comes.

It doesn't seem to be able to be pasted, I know that the new Silk Road seamless wall cloth can be pasted.

How to paste window wallpaper 1Fill the hole in the glass surface with putty and level the wall with a scraper. Measure the size of the wall, and then measure the wallpaper based on the glass area, pay attention to the length of the wallpaper, which is 5cm more than the actual veneer.

Use a pencil to mark 19 inches from the top corner of the glass so that the wallpaper is wide enough to repost from this wall to the wall with windows. 2.Hang a plumb line along the glass at the marker, and draw a marker line along the plumb line with a pencil.

Check that the distance between the marking line and the corner of the glass is consistent. If the corners of the wall are not straight, in some places the distance is greater than 19 inches, and the wallpaper will not be wide enough to be reposted to the adjacent wall. You can move the plumb line closer to the corner of the wall and redraw the marker line.

3.Hold the adhesive-coated wallpaper to the edge of the glass, gently uncover the top folded part, and hold both sides with your hands. Don't let the bottom half of the wallpaper fall suddenly, lest it crack or elongate and not align with other wallpapers.

4.Lift the top right corner of the wallpaper so that the right side of the wallpaper is aligned with the marker line. Note:

Leave about 2 inches or 50 mm of length at the top of the wallpaper for trimming. 5.Align the right half of the wallpaper with the marker so that the edge of the left half of the wall does not touch the wall.

Window grille on the glass method:

1. Prepare the window grilles and separate them one by one.

2. In the divided window grille, take out a pattern to confirm the window grille.

3. Put one side of the window grille on the tap water and dip it in water.

4. On the selected glass window, confirm the position of pasting.

5. Put the window grille on the glass first and adjust the position of the window grille.

6. Clean the other door according to the same position and prepare the window grille.

7. Paste the window grille on the door and compare the position of the two window grilles.

8. This kind of window grille is best pasted on the transparent glass on both sides, so that the pattern of the window grille can be seen on both sides.

1. Before the window film, you need to wash the windows with detergent mixed with water.

2. Separate the main membrane from the protective membrane.

3. After spraying dish soap with aqueous solution on the mucus side of the main film, stick the main film on the cleaned window glass and cover it with a protective film.

4. Use a scraper to scrape out the water stains and bubbles under the main film, tear off the protective film and trim the edge with a utility knife.

In order to make their interior space more beautiful, many people will put a layer of window paper on the window, which can not only make the window more beautiful, but also block the sunlight outside, making the indoor space more comfortable. So how to paste the window paper, the following article will introduce it to you.

How to paste window paper

1. First of all, you need to measure the size of the glass, and then cut the cellophane of the same size as the glass on the whole cellophane.

2. Wipe the window clean with clean water, pay attention to the corners of the window also need to be wiped, so that the window paper can move on the glass, if it is not pasted well, it can also be torn off and re-pasted.

3. Tear a small corner of the window paper, then align the glass, and gradually paste the cellophane on the window.

4. After the final pasting, use a ruler to drive the stagnant water between the window paper and the window to the edge, and then level the corners so that there are no bubbles on the window paper.

How to remove window paper from windows

1. Blow with a hair dryer.

We can use a hair dryer to blow on the window paper, because there is usually a certain amount of glue on the window paper, and the glue usually softens after preheating, so that we can slowly tear the window paper off.

2. Apply alcohol or wind oil essence.

If the window paper is difficult to tear off, we can apply some alcohol or wind oil essence on the window paper, because alcohol and wind oil essence have a certain dissolving effect on the glue on the window paper, which can make the window paper fall off quickly.

3. Use a special adhesive remover.

If the window paper is difficult to remove, we can also go to the market to buy a special adhesive remover, we only need to follow the instructions to remove the window paper.

4. Pasted window paper.

If it is the kind of window paper that we use paste paste in our home, it is easier to tear it off, we can first wet the window paper with a rag dipped in water, and then tear it off, if there are traces left on the window, wipe it with a steel wool ball.

Dear, hello, Chenxu is happy to answer for youA: Wallpaper and window tenant stickers are not a kind of wallpaper, as the earliest wall decoration materials occupy the main share of wall decoration materials. However, wallpaper is not as decorative as wallpaper stickers.

Moreover, the construction work of wallpaper is large, and the cost is much larger than that of wallpaper stickers. And when replacing the wallpaper, it is not so easy to tear off the wallpaper, and sometimes it can even damage the wall. Wallpaper stickers, also known as sticky notes, have the characteristics of being casual and highlighting personality.

A simple wallpaper sticker is a monochrome pattern sticker that is carved out of a pattern on a sticky note with a cutting plotter. It is different from traditional wallpaper, it is just a set of hollow patterns or patterns, which appear simple and generous. The wallpaper sticker is made of PVC material with glue on the back.

It is not only simple and convenient and very casual, the decorative effect is also very intuitive, suitable for modern home decoration, as long as the choice is matched with the overall home color, as well as the owner's personal temperament, choose a good pattern to stick at home, not only shows the personality of the owner, but also injects a new vitality into the home.

Dear, hello, I'm glad to answer for you You don't need to make window covers, window covers generally play a role in protecting windows, and it is not necessary to make window covers for wallpaper. Window casing: 1. The main function of the window casing is to protect the window edge.

Because long-term use is easy to cause damage to the window edge, and the window cover is mostly made of wood, which can play a good role in anti-collision protection. 2. To a certain extent, the design of the window sleeve also plays a role in echoing the door sleeve and baseboard, because it shares the role of edge closure with the whole space. 3. The window cover is the form of the window sill, and when a marble or something like that is laid on the window sill, it often feels more monotonous and abrupt than the Qing file.

1. How to paste window stickers 1. Use a rag to clean the glass to avoid leaving more stains; 2. Measure the size of the window and cut the sticker, which is 1cm larger than the window; 3. Tear off the corner of the sticker protective film, align it with the glass and tear it off; 4. After the construction is completed, cut off the extra stickers.

The window stickers are applied as follows:1. First of all, use a scraper to remove the dirt on the glass.

2. Then measure the size of the window and cut the glass window paper.

<>5. Then use a scraper to scrape off the bubbles on the window paper.

6. Finally, the window paper is pasted, as shown in the figure below.