Does the Juniper EX8200 support PBR 5

Note that OSPF is a distance vector routing protocol, and all intra-region routes must be completely consistent with LSDB, so Juniper Junior does not allow any policies to be configured in the import direction of the OSPF protocol to ensure that all complete routing information can be received.

Let's take the RIP protocol as an example:

r3:policy-options

then reject;

term permitothers }}protocols

rip }}

Method steps.

Connect WAN cable 1 and WAN cable 2 to the WAN ports 1 and WAN 2 of the router, respectively.

In the case of connecting the LAN port of the router of the router to the default), then log in with the username and password, change the number of WAN ports to 2 in the basic configuration - basic options - WAN port number setting, note: if you want to use 3 channels, change it to 3, and so on. ）

Click OK, restart as prompted, and log in to the router configuration page again as in step 2.

In the basic settings - WAN port configuration, set the connection mode of WAN 1 and WAN 2, in this step, as long as it is set independently, the connection type of WAN 1 and WAN 2 can be the same or different, according to the actual situation, it will not be explained here.

Set the load balancing mode of WAN1 and WAN2 in Advanced Configuration - Policy-Routing - Load Balancer, which is mainly divided into two types, one is balanced by IP address, the other is balanced by the number of sessions, and you can also set the weight of the load.

In Advanced Configuration - Policy-Based Routing - Line Status, you can view the connection status of WAN1 and WAN2, such as the number of sessions, etc.

When the connection status of wan1 and wan2 is normal, after passing the test, you can exit the router, it should be pointed out that due to the use of policy-based load balancing, because there is a line disconnected in wan1 and wan2, then the entire network can still be used, but the network speed will drop significantly, so you should log in to the routing friend device regularly to check whether the two lines are normal.

The problem is that you don't have 2 equal-cost routes, so you only have one exit

It's available on the official website!

SDH port: fe ge xe port:

T3 port: T1 port:

ATM port:

You mentioned the problem of packet loss when accessing the Internet. There are many reasons for this. There are a lot of network reasons that need to be checked.

There are also many policy-based routes. For example, the default routing table. Custom route tables.

BPR routing table. Source routing and much more. can implement different routing tables.

I've been using netscreen for a few years now. If you have any questions, you can ask them. No one knows what you really need.

Sometimes the number of sessions does not represent the traffic of the firewall. It is possible that some clients are in **, so the traffic of a single session may also be large. If you ping packets, the bandwidth may be occupied and the network latency is caused, you can add a traffic statistics to the trust to untrust policy to see the current network bandwidth usage.