Analysis of the reasons for the stalling of large trucks while driving

1. Circuit failure. This possibility is that the power is cut off due to low voltage during driving. At this time, you can mainly check the ignition and starter switches, as well as the fuse box.

2. The low-voltage line is short-circuited and causes the flameout, in which case it is intermittent flameout. Check your low-voltage lines.

3. Device failure. This problem is generally an ignition coil.

Capacitive, electronic ignition module. It starts at the beginning, turns off after a while, and then starts again and turns off again.

4. Oil circuit failure. The gasoline pump was damaged, the oil line was ruptured, the carburetor inlet was clogged, and the fuel tank ran out of oil. But in this case the car can be restarted, but it is difficult.

5. Ignition system, engine overheating and detonation system will turn off if there is a problem.

Reasons for the sudden stalling of the car while driving:

1. Circuit failure.

2. Flameout caused by short circuit of low-voltage line: intermittent flameout; 3. Device failure: it can start at first, turn off after a while, and then start again, and then turn off again;

4. Oil circuit failure. The gasoline pump was damaged, the oil line was ruptured, the carburetor inlet was clogged, and the fuel tank ran out of oil.

5. There is a problem with the ignition system and the explosion-proof system for engine overheating.

When it is found that after the ignition is turned off, according to the road conditions at the time, if there is no emergency, you can slowly step on the brakes to prevent the tail light, after the speed is reduced, slowly play the direction, drive to the roadside lane, pay attention, the brake should be stepped on all the time, the power from small to large, do not step on it and then loosen, and then go to the pedal, which will lead to the only remaining vacuum is also consumed, and then step on it can not be stepped on, park the car on the side of the road, turn on the four flashing lights, place the tripod, and hit the ** rescue trailer. Hope!

1. Sudden stalling during normal driving should be out of fuel;

2. It may also be that the oil circuit is blocked and no oil is supplied;

3. Including the unstable voltage of the battery;

4. The spark plug is not ignited;

5. Water tank leakage;

6. The cooling fan does not work;

7. Insufficient coolant, etc.

Sudden stalling during normal driving should be out of gas. It may also be that the oil circuit is blocked and no oil is supplied. In other cases, this is very rare. Hope!

Is there no gas, the car's battery is out of power, and it is possible that the oil pipe is not oiled in the cold weather.

What is the reason why the big truck suddenly stops and restarts while driving?

There are many reasons for the sudden shutdown of the truck while driving, first check whether there is a problem with the control circuit, whether there is a problem with the throttle control, whether the throttle control line has fallen off, the old-fashioned truck is the accelerator control of the mechanic, to see if there is any loose to check, and whether the fuel tank fuel supply is broken, these must be checked.

There are seven possible reasons:

Sudden stalling during normal driving should be out of gas.

It may also be that the oil circuit is blocked and no oil is supplied.

Including battery voltage instability;

The spark plug does not ignite;

Leaking water in the water tank; The cooling fan is not working;

insufficient coolant, etc.

Hello, it is recommended that you go to a professional repair shop for inspection and maintenance, you must deal with it in time, travel safely, I hope my help to you.

The truck suddenly stalls while driving, mainly checking the oil circuit and electrical circuit.

1. The phenomenon of automatic transmission stalling is mainly caused by the use of inferior fuel.

2. The reason for the flameout may be that the engine is turned off due to carbon deposit. Another possibility is a problem with the engine or oil circuit.

3. For old models, the reason for turning off may be that the driving skills are not skilled enough and the operation is wrong.

4. It may be caused by adding too much oil grease, blocking the oil path and poor oil attack.

First of all, make sure that you are not running out of oil, and that you are not running out of neutral coasting. Then there is a failure of the power system.

Try to change the repair shop, this can only be determined by seeing the actual situation.

Whoa?? **Yes? Hold the cylinder? Or is it a top cylinder? Or is it not good for the oil you use?

At this time, you should immediately use the inertia of the car to drive away from the main lane, stop next to it, and then set up a roadblock to call the rescue** for rescue treatment.

Summary. It may be due to the following seven reasons: 1. Sudden shutdown during normal driving should be out of fuel; 2. It may also be that the oil circuit is blocked and no oil is supplied; 3. Including the unstable voltage of the battery; 4. The spark plug is not ignited; 5. Water tank leakage; 6. The cooling fan does not work; 7. Insufficient coolant, etc.

What happened when the truck suddenly stalled while driving?

It may be due to the following seven reasons: 1. Sudden stalling during normal driving should be out of fuel; 2. It may also be that the oil circuit is blocked and no oil is supplied; 3. Including the unstable voltage of the battery; 4. The spark plug is not ignited; 5. Water tank leakage; 6. The branches and heat dissipation fans do not work; 7. Insufficient coolant, etc.

Put the key in the ON range and check if the oil level is sufficient, insufficient oil is enough. First of all, turn the key to the ON range to see if the voltage is normal (the pointer of the voltmeter cannot be lower than 24V), and then turn the key to the ACC range (ignition) to check whether the motor is working normally, if the voltage on the instrument is not normal, the power of the motor is insufficient when igniting (motor); Check whether the permanent line of the generator is energized (one end of the test light is connected with the generator harness N, and the other end is connected with the engine frame, whether the test light is lit, and if it is lit, you can see whether there is electricity). If there is no power, whether the fuse is disconnected, if there is no fuse, the oven should be replaced; Check if the belt of the generator is broken or loose, it can be replaced or adjusted when damaged or loose.