VISTA NETWORK DIAGNOSTICS CANNOT BE RUN NETWORK CONNECTION 50 CANNOT BE SET

I think it's easier for you to reload.

Suggested Method:

1.Check if the router is set to: "Connect when needed". If so, change to "Always connected".

2.In the Device Manager, turn off the power saving mode of the network card.

3.Delete the old connection and create a new one.

There are four common causes of disconnection.

1. Do you use Kaspersky Antivirus or Kaspersky Firewall, or something like Kaba?

Is there a stealth mode feature in the software? If yes, then you just have to turn off this incognito mode.

Don't be incognito on the network, this situation will not occur after the invisibility will sometimes affect BT.

load speed, as well as P2P IPTV. A reboot of the machine or cat can sometimes be fine, but it can't solve the problem fundamentally.

Issue. The root cause of this situation is that you use a broadband network (such as telecom, Netcom, Tietong, etc.).

You often have to probe your computer, and this happens when the other party can't detect your computer's network card.

In addition, when this happens, your network card does not get the IP address at that time, so this situation will occur.

Condition. It's not a big problem, though. Generally not prone to this problem, unless you are using a broadband network to enter.

This will only happen when the line network is adjusted.

2. Check whether there is strong magnetic field interference in the place where the network cable passes.

Third, the cause of static electricity, friction has static electricity, let alone the computer. Computer source conversion and display for computers.

Static electricity will be generated, especially when the power conversion of the computer is in a high-frequency oscillation state of 500kHz.

The most important person with electricity, find a piece of wire, connect it to the ground wire on the power outlet, and connect it to the other end.

On the iron post of the windowsill. You can measure the voltage change of the front and rear chassis, which is not small. Normal chassis voltage should.

Around 3 volts (I haven't measured it myself, my friend said, there should be no problem).

Fourth, use ADSL in addition

modem Internet access has certain requirements for the first line, one is to connect each joint of the line.

Well, the second is in ADSL

The modem separator cannot be connected to any device before, such as: ** extension, anti-theft.

beaters, etc. When reconnecting the binding post of the junction box, it is best to wipe the ** wire and the binding post with fine sandpaper.

Wipe, when wiring, wrap the ** wire on the binding post a few more times, and then tighten the screws, so as to ensure good contact.

Remove the *** socket at home, use direct wiring, and connect wires to wires is the best.

Welding, and then wrapping with insulating tape, anyway, you can't connect any equipment before the separator, so as to protect it.

Certified junction box to ADSL

The good line contact between the modem splitters ensures the quality of signal transmission.

Now you only need to use PV4 to surf the Internet, but you don't need PV6.