How to solve the problem that direct3D acceleration is not available?

The solution for you is as follows:

1.This problem is usually the one posed by the graphics card. So you don't have to think about other hardware.

2.Solve the problem after confirming it: Generally, the hardware acceleration in the driver of the integrated graphics card is directly defaulted, but some do not directly 3D hardware acceleration, which is described on the motherboard.

3.How to set up 3D hardware acceleration for a discrete graphics card: Right-click to open my computer--- Properties--- Device Manager - find the item about the graphics card--- double-click to observe the properties ---to see if the graphics card device is driven, and there is also an exclamation mark showing the driver description, indicating that the driver is wrong.

4.Solution: Reinstall the graphics card driver, if it was wrong, uninstall it first. Let's install it again. For the graphics card on your motherboard, look at the model clearly and then go to the driver, you must not use the universal driver, not to mention the shortcomings.

5.After the driver is successfully installed, re-drive the computer.

6.When you enter the win system again, you can see a tray of graphics drivers in the lower right corner of the computer. Turn it on and set it in the properties to turn on 3D acceleration, textures, etc.

Good luck in the end!

In fact, I have been in this situation myself, and I have been looking for answers! But there is no cure!

Later I found out that I was a little negligent!

The details are as follows: Click on the desktop: Properties - Settings - Advanced - Troubleshooting - Put"Hardware acceleration"Just turn it up to the highest!

If it still doesn't work!

Point Start-Run-Enter:

Click"Display"Inside, take a look"Accelerate the hardware"Is it all disabled If so, just enable it all!

That's all I know, or I'll start all over again"directx"Upgrade to try I think: this is not the case in general!

Some strip cards do not have this function.

The driver does not drive up Direct3D acceleration.

You determine for yourself.

Which of the above questions?

What version of your DirectX is there? The new version of DorectX9C is not very stable, you can consider using DX9B to see if there is still such a problem.

In addition, there may be a problem with the graphics card driver, uninstall the graphics card driver first, then restart, and then reinstall the driver after the system detects the graphics card.

If the problem persists, it is recommended that you format the C drive and reinstall the system.

Go to the official ** latest driver of the graphics card, install it and try it, and maybe your memory is too small. If the funds allow for an additional memory.