I would like to translate a few sentences from English to Chinese 10

Bench comparators are often used for on-top positions that can be shipped and used anywhere as they have their own construction built - on the bench of the bench for the Bench of the Bench Surface Indicator Table, and the Bench Comparator uses a granite surface dish with a vertical post to build into the use of metal within the Bench Their jagged surface will allow dirt or fries to fall between the jagged in the measurement to avoid errors. All bench comparators have a way to make a vertical adjustment and lock it in. Most of the compatators are usually second-hand when fast but highly accurate measurements, thickness, and so made on this valiable that must be made above and foremost can be seen from time to time on the machinest On or the operator measures the part during production or on the bench when the part must be audited, or 100% inspected.

Mention chapter 6 on the inner line. The nomenclature here varies slightly from the inner line in Chapter 6. That crown and root are seen in different ways, as shown in Figure 9, the smaller diameter is actually the original one that was drilled before the main diameter is now in that root degree diameter, line depth, and angle remain the same.

Measurements include the degree of diameter, the smaller diameter and the depth of the line in that hole. Sometimes depth is not a requirement because the hole must be lightly beaten all the way the smaller diameter can be standard just with one plug The degree diameter is usually a proof of weth one line plug specifications similar to that one shown in Figure 9.

Gauge and measuring equipment, part of the function used in the measuring instrument is to compare the function of the standard, used for calibration of the instrument.

The standard rule is to show fifure9 in graduation ceremonies on both inches and fractions.

See Chapter 13 on Statistical Process Control.

Bench comparisons are often used in the field where they can be carried and used anywhere, as they have their own built-in construction reference indicator surface stand, and bench comparisons using granite slabs after the surface is vertical after it is built-in. Others use metals that refer to the surface which has a serrated reference surface, making dirt or serrations between the chips to avoid erroneous measurements. All benches have a method of comparison to make a vertical adjustment and lock it.

Most have the clamp vertically after when loosened, so that the indicator moves up and down when adjusting there is a rack to put the knob action indicator up and down then it can be locked is compatators when generally used, quickly and accurately measure height, thickness etc must be made valiable This can be seen from time to time in the machinest or operator to measure the production process when the part or workbench must be partially screened, or100 percent checked.

See Chapter 6 Internal Threads. The name here is slightly changed, in the internal thread the flood peak and the root is seen in a different way, as shown in Figure 9 the small diameter is actually the original hole, the large diameter before drilling is at the root spacing, the thread depth and angle remain the same.

Measurements include spacing, small diameter, and depth of thread punching into the hole. Sometimes not deep is required, because the hole must be utilized in all the ways that a small diameter can simply be measured by a plug-in spacing is usually proof of weth thread insertion into an instrument like one as shown in Figure 9

In the shadows, I spent a long time balancing on the edge of the bridge, trying to commit suicide by throwing myself into the river, but finally I changed my mind.

For ages means for a long time, and I was balanced=I balanced myself to keep myself steady.

[I am a bridge of balance, in the dark] on the edge of age, trying to make up for my mentality to throw into my own river and drown myself. But now I've changed my mind.