What is the reason why the Gree air conditioner can t be turned on?

The reasons are as follows: low battery;

The battery is low;

Protection is turned on.

Insufficient battery solution: the receiver head is bad or cannot work normally due to moisture, check the transmission of the remote control signal, point at the transmitter port with a digital camera (mobile phone can also be used), press any button to see if there is an infrared signal emitted. The mode is incorrect, or the temperature setting does not meet the conditions for powering on.

When cooling, the set temperature should be less than the indoor temperature, and when heating, the set temperature should be greater than the indoor temperature. The low battery of Gree air conditioner will cause the remote control distance to be short or impossible to remotely control. It is recommended to remove the battery when the air conditioner is not in use, and reinstall or replace it when in use.

Solution to the cause of the power supply: the power supply of the Gree air conditioner is not connected well or out of power, the power conductor socket is not in good contact, or the power conductor wire diameter is thin or aging. The power supply voltage is low.

Starting voltage of fixed frequency air conditioner:,Voltage fluctuation range:,Starting voltage of inverter air conditioner:

Voltage fluctuation range: It is recommended to install a voltage regulator in the home.

It is the remote control receiver or display screen on the host that is faulty, most of which are cable and connector problems, resulting in the inability to remote control, which has nothing to do with the remote control. Repairs are required.

There is a problem with the circuit board and needs to be replaced.

Gree air conditioner turned on and did not respond, what is the reason? Appliance maintenance technology sharing.

It's a problem with the remote control.

Is it a cabinet or hang-up.

If the air conditioner won't power on (turn on), follow the steps below to solve it:

2. Plug the power plug back in, turn on and observe.

3. Confirm whether to turn on the remote control or the [Power] button on the fuselage to turn on the computer.

5. Check whether the remote control display is normal, replace the new battery (even if the battery is not long after the battery is replaced, it must be replaced), and re-control the machine. (Note: The remote control needs to be remotely controlled against the machine, and the distance is within 7 meters.) ）

If the machine still does not power on after trying all the above operations, you can contact the maintenance unit to report for repair, and the engineer will come to deal with it for you.

What's going on with the Gree air conditioner not turning on.

1. The remote control is out of power and needs to be replaced with a new battery.

2. The current power supply is too low, because the starting voltage of the air conditioner has to reach 220 volts.

3. If there is a fault in the wires or plug strips at home, it will also cause the air conditioner to have no power.

4. The internal components of the air conditioner are faulty, such as the compressor has problems, which will cause the air conditioner to fail to start.

1. Compressor failure: The air conditioner that has been used for a long time has different degrees of compressor aging, so it is found that it cannot be turned on; 2. Refrigerant defect: once the compressor of the air conditioner lacks fluoride, it will cause the air conditioner compressor to fail to start; 3. Frost on some pipes

At this time, it is often because when the master installs the air conditioner, the original air inside is not discharged and unclean, and over time there is ice in this position.

1. Compressor failure.

If the air conditioner can't be turned on, it's often because there is a problem with the compressor of the air conditioner. In particular, the air conditioner that has been used for a long time has different degrees of compressor aging, so it is found that it cannot be turned on.

Second, the refrigerant defect.

As we all know, fluoride plays a role in refrigeration. Once there is a lack of fluoride in the compressor of the air conditioner, it will cause the air conditioner compressor to fail to start. But people don't know that if you let the air conditioner run all the time, it will not only cause the air conditioner compressor to fail to start, but also the air conditioner will not turn on.

3. Frost on part of the pipeline.

There are also air conditioners that have compressors that are in good condition, but they cannot be turned on yet. At this time, it is often because when the master installs the air conditioner, the original air inside is not discharged and unclean, and over time there is ice in this position. In this case, it is easy to increase the load on the compressor of the air conditioner.