Should the 1 5m fish tank be filtered with a filter bucket or a bottom?

The bottom filtration effect is the best, the upper consideration + high-power filter barrel is also OK, the filter material is with a glass ring, the more the better, don't forget to let the water flow through the filter cotton first, and then through the glass ring. (Personal opinion).

It is best to use a vacuum filter box, good water quality to ensure the health of your Arowana, keep the water temperature at about 28 degrees, and do not change the water more than 5 points each time

It is best to feed it so that it does not cause the eyes to fall.

It is recommended to use a diving tube, which is helpful for the coloring of the dragon.

The bottom is generally divided into four grids, the first grid of white cotton biochemical cotton (or Japanese Teng cotton), the second grid of ceramic rings, the third grid of bacterial houses, and the fourth grid of water pumps.

If you have a new tank, you don't need to add coral stone for the time being, and you will have to add some coral stone after a few months, because it will naturally fall sour after a long time, and the coral stone can be neutralized.

Bottom filtering!This won't affect your dragon's living space, but it won't filter it very well. Change the water in 1 week.

Outer filter bucket!It's a bit hard to say, I haven't used it either! Expensive! However, the filtration effect is better. You can do it without changing the water for 2 weeks!

.I know how much it is. May I ask you what your dragon is?Haven't seen it! Just curious

"Submersible filter", convenient, beautiful, quiet enough. There are shops that sell ornamental fish, remember to help your dragon add a "thermos stick" in winter, your own family is selling ornamental fish, I hope to help you, ha!

Filter buckets, you don't keep crystals.

Allow water to flow through the entire filter media. Reed stare band.

Increase the space for additional filter media.

The order of the filter media must be the beginning of the filter cotton, which is used to block large impurities, followed by the bacterial house pottery ring, stones and the like (to nitrifying bacteria.

survival), with stable water quality, you can also add ultraviolet rays.

Algae with reed control).

It is estimated that it is an integrated filter cylinder, I have used one before, which is quite good, but I feel that the filtration is not enough.

Oxygenation and oil removal film are good.

The original stream of water passes through the pipes and then breaks up on the filter cotton.

Change to go straight from right to left, with all water going through all the filter media.

The original with the addition of the filter box.

The added water flow path is lengthened.

Summary. 1. Drip filtration is a kind of filtration on the fish tank, this filtration method is very good, the disadvantage is not beautiful, and the water outlet and the water surface are easy to produce water flow sound. 2. Bottom filtration, this regular way is strong for water quality cleaning, because it is hidden in the cabinet, it is very beautiful, the disadvantage is that the maintenance cost is high, and the filter material is expensive.

3. Filter cartridge filtration, this kind of filtration is beautiful and silent, the disadvantage is that because of its limited filtration effect, one meter and two cylinders need to be connected in series with a filter cartridge. The above three types of filtration can be selected, and you can choose the filter that suits your fish tank. If you use filtration, you can buy a three-in-one filter pump, which can be more than 40 watts, including filtration, so that oxygen suction and filtration can be done at one time, and it does not take up space.

What is the best way to filter the rice fish tank.

What is the best way to filter the rice fish tank.

1. Drip filtration is a kind of filtration on the fish tank, this filtration method is very good, the disadvantage is not beautiful, and the water outlet and the water surface are easy to produce water flow sound. 2. Bottom filtration, this regular way is strong for water quality cleaning, because it is hidden in the cabinet, it is very beautiful, the disadvantage is that the maintenance cost is high, and the filter material is expensive. 3. Filter cartridge filtration, this kind of filtration is beautiful and silent, the disadvantage is that because of its limited filtration effect, one meter and two cylinders need to be connected in series with a filter cartridge.

The above three types of filtration can be selected, and you can choose the filter that suits your fish tank. If you use filtration, you can buy a three-in-one filter pump, which can be more than 40 watts, including filtration, so that oxygen suction and filtration can be done at one time, and it does not take up space.

It's okay to kiss these things.

What brand is better.

Which brand of fish tank filter ***1Ihan eheim2Hanhan Paradise 3Minjiang minjiang4Sen Sen sunsun5Jubaoyuan

Okay thank you. Is the bottom filter the filter barrel?

Is it still there? The working principle of the fish tank filter barrel: the bottom filtration is placed at the bottom of the aquarium, it is composed of many mesh plates, the water inlet pipe of the water pump can be connected on the mesh plate, when the water pump works, the water flows through the diversion groove at the bottom of the mesh plate into the filter tank, and the filtered water returns to the aquarium to carry out a good water circulation, which is the best filtration for cultivating nitrifying bacteria and the strongest filtration for treatment.

Is it there? In, look at the design, this filter can be chosen by yourself.

Household fish tanks generally choose bottom filtration, which has a good water purification effect and can stabilize the water quality, so it is not a problem to raise small fish or large fish. 20 watts for a one-meter five-meter fish tank is enough, and stones and other decorations should be padded under the fish tank, that is, there should be a void layer below to allow the water to flow well. If the stones are not erected, you will not be able to flush them clean with any amount of power, unless the fish tank flows like a stream.

The amount of power of the pump is related to the overall water volume, the required head distance, etc., and a single length size is not enough.

Choose the right pump according to the size of the fish tank, so that you can change the water better. The above is about the 60 fish tank with how big w pump and how to choose the right pump according to the fish tank, you can choose according to your own needs when choosing a fish tank pump.

Fish tank is generally a family to raise some pet fish appliances, in the purchase of the need to choose the size and size of the fish tank according to the type of fish, then 1 meter 5 fish tank with how many W pump, the pump is a very important part, in the purchase of the need to see the size of the fish tank.

For example, if you raise a grass tank, you should appropriately lower the water level to increase the light at the bottom, and increase the thickness to distinguish the front, middle and back scenes. Therefore, if you want to make your own fish tank, first determine the location, then determine the feeding category (small, medium, large), and finally analyze the size. In principle, it can be as large as possible, which is conducive to the stability of water quality.

Single-sided viewing is 60mm*35mm*45mm, double-sided viewing is 60mm*45mm*45mm, glass 8mm. Pay attention to the long package and the short one, and the bottom of the side package.

In addition, depending on the location of the fish tank, its size is also different. Generally speaking, the fish tank will be placed in the living room or the entrance, etc., if it is placed in the living room, the rectangular fish tank can be appropriately expanded under the size, choose the fish tank that is long to one meter or two meters, if it is a round fish tank, but also consider the size of the support behind.

1) Due to the height of the base cabinet, the number of layers of the trickle is limited. Thus limiting the space for the trickle.

2) Although it is a trickle type, the bottom tank should be large enough, and in addition to putting down all the drip boxes, it is necessary to ensure that the excess overflowing water from the fish tank is installed after the pump is stopped.

3) In order to achieve the effect of dripping, the pump should be operated at a low water level, so that the head of the pump is about one meter more than that of the ordinary pump.

When the pump rotates, the water in the pump area will flow along the water.

The BAI pipe flows into the fish tank, and the water level of the fish tank will rise uninterruptedly, and when the water level rises beyond the overflow area, the overflow plate will overflow into the overflow area.

The bottom of the overflow area is connected to the filtered physical area by a sewer pipe, so the water that overflows the fish tank flows to the overflow area and then to the physical area. After passing through the physical zone, the water overflows to the biochemical zone at the bottom of the water level, and then flows back to the pump area after biochemical filtration.

The bottom filter cylinder is generally partitioned, and only the small bottom filter cylinder will not be divided or divided into two compartments due to space constraints. It is generally divided into three areas, physical area, biochemical area, and pump equipment area. And some people have a large space in the base cabinet, so they will divide the filter cylinder into four or five compartments.

The extra number of tiles is generally used as a biochemical area.

The traditional three- and four-corner overflow is to drill two holes (25mm holes in the water and 50mm holes in the water), and the control of the hole position is also difficult, of course, you know that it is not difficult. Since there are two holes, the closer the holes are to each other and the more holes are punched, the higher the chance that the glass will crack under pressure. The advantage of triple overflow is that only one hole (generally 60mm hole) needs to be drilled to complete the water supply and discharge line requirements.

The common size of the upper and lower water pipes is 25 (6 points) for the upper water and 50 for the lower waterThe sizes mentioned here are the conventions of PVC pipes.

size, and this right is conventionally generally used between 3000 and 8000 traffic.

When the flow rate is more than 10,000, 32 (one inch) is used for the upper water pipe and 60 pipes for the sewer. For bottom filters with a flow rate of less than 3000, it can be lowered by one level, using 20 (4 points) for the upper water pipe and 40 for the lower pipe.

Many people know that the sedimentation area is used for poop in the sedimentation tank, and adding a sedimentation zone in front of the bottom filter can reduce the burden of physical filtration of the bottom filter, but there are also other problems.

1. The sedimentation area should be large enough, and the water flow should be slow enough, so that it will occupy the space of the bottom filter, 2. The sedimentation area is to precipitate the garbage, so it is necessary to discharge the garbage regularly.

3. Don't think that there is a sedimentation area, no physical filtration or no need to clean the filter cotton, this is a wrong view, the sedimentation area is just to reduce the physical burden, because the space and water flow can not achieve the effect of complete precipitation, so there will be a certain amount of garbage flowing to the physical filtration.

Excuse me about the bottom cylinder.

What size should I use? Is 4 slots enough?

The size of the bottom cylinder depends on the size of your base cabinet.

Specialized, some of the bottom cabinet has a vertical stall, and the long cylinder looks like it can be put down but can't be stuffed in. In addition, it depends on what you raise, such as raising marine fish in very hot areas, you must leave space for the chiller. 4 grids are enough, but how to divide the space of each grid, whether it is divided equally, or it depends on what you raise, such as raising SPS, LPS, etc., you can set the algae tank a little bigger.

Isn't 1000*400*450 a bit big?

The height of the common base cabinet is generally 750, and the bottom cylinder is 450, and the space above is too small to operate, so it is recommended to be lower than 400.

Is this fish tank suitable for bottom filtration?

There is nothing unsuitable, my cylinder is only 450*300*450, and I still made a 300*300*300 bottom filter cylinder.

Will the cylinder burst after a long time of drilling holes at the bottom of the cylinder?

The punch hole is a place of overflow, not a place of water, and there is no great water pressure. As long as it is non-tempered glass, there is no internal stress, as long as it is used normally, it will not increase the risk of cylinder bursting.

If you put too much amoxicillin <> in the fish tank, it may cause the fish to die. This drug can kill bacteria, although it can cure diseases, but it can also destroy the nitrification system in the fish tank, resulting in a large number of nitrifying bacteria death, so that the water quality can not be maintained, the ammonia nitrogen content in the water body rises, and the health of the fish is also threatened. Therefore, it is better not to pour the medicine into the fish tank, but to put it in another container and soak the fish in it.

Many people will place fish tanks at home to add a touch of vitality, there are many kinds of fish tanks, today pchouse will talk to you about the bottom filter fish tank, and introduce to you what the bottom filter fish tank is!

1. The bottom filter is a kind of fish tank filtration method, which can provide the largest space for the filter material, which is conducive to the cultivation of nitrifying bacteria, and the disadvantage is that the volume is huge, which occupies the space of the fish tank bottom cabinet and has high requirements for the water pump. It is usually equipped with a physical filtration area, a biological filtration area, an equipment area, and a sedimentation bin.

2. The bottom filter cylinder is usually hidden in the bottom cabinet, the overall appearance is beautiful and tidy, and operations such as water change can be carried out in the bottom tank, which can significantly reduce the impact on the fish in the tank.

3. The advantages of the bottom filter: the bottom filter provides the largest space for the filter material, so the processing capacity is the strongest (note not efficiency)!It is beneficial for the cultivation of nitrifying bacteria.

Generally speaking, there are 3 or 4 grids of the bottom filter, and the order of the filter material is as follows: the first grid, white cotton, rattan cotton, and the second grid. Bacterial house, ceramic ring, glass ring, filter ball, etc. (you can choose one or use it together).

In the third square, if it is the last square, you can put a pump and a heating rod, if not, you can also put a bacterium house or a maifan stone. But in the end, you need to leave a space for the pump and the heating rod.