How do you make an egg fall from a height of 1.2 meters without breaking?

An egg protector can be made.

Prepare materials: straws of two colors, scissors, tape, eggs.

1. Take two red straws and cut them together into three sections.

2. Glue the cut red straw into a three-dimensional triangle with tape.

3. Stuff the egg into a three-dimensional triangle.

4. Take out a straw of another color, and then wrap a circle of tape in the middle of the straw, the length of the tape is the same as the red triangle.

5. Put the place where the tape is wrapped on the red triangle, and then fix it with tape.

6. Glue a straw to the edge of the red triangle. Right.

7. Done. <>

Roll the egg in the center with A4 paper, use two rubber bands to hoop it, use four toothpicks to hold the eggs respectively on the outside of the two rubber bands, tie the toothpick with 20cm thin rope, put one end of the transparent glue in your hand, stick one end to the A4 paper tube, overlap and glue the hands at 1 3 places in the paper tube, and pin the two paper clips to one end of the paper tube.

Four toothpicks are attached to each of the sides of the egg, then taped, two paper clips are opened, and a small net is woven together with a rubber band, and the paper strip is torn and stuck inside.

Fold the paper into the shape of putting melon seeds, put the small end of the egg against the bottom of the tip of the paper, and use other tools to add the bottom of the paper, mainly for cushioning.

Wrap the eggs in paper and fold them into a triangular shape. This can act as a buffer.

Roll the paper into a cone, put the eggs in it and fix them with transparent glue.

Fold the eggs with paper and a pair of wings will not break if they fall off.

Fold the paper in half, fold it in half and then fold the tip in half again, then fold the paper yourself, a bit like a small paper bag with a newspaper folded in the inner plant of melon seed skin When I was a child, I then used transparent glue to glue the folded place, which can really put things inside, and then put the egg inside, you can test it! Stand on a high spot and throw the paper containing the eggs vertically to the ground, and try to sprinkle it. It's just that I haven't used anything else you said

Wrap it in paper and wrap it into a pointed one to form a cushion.

Watch a recent show in Happy Camp Ahhhhh

Put a basin of water, or put a sponge in the air under a meter and a square egg, and it won't be long enough.

Use an umbrella to hang the eggs underneath.

Wrap it up, tie it up, and put it down gently.

After boiling the eggs, they will not break if they fall again.

Looking at the happy base camp, Qingfeng said in that episode.

Use foam and bubble wrap for household appliances.

Cooked, put a thick sponge on the ground.

There are several ways:

1. Find an empty carton (to have a certain thickness, preferably the type of packaging box), then punch holes around, sew the eggs with cloth, leave a rope perforation around the place, and then use a thin rope to thread it from all sides of the box, enter the box and pull the eggs up (so that the eggs will hang in the carton, but don't pull too tightly when pulling).

2. Tumbler type: The tumbler type is to make the whole device like a tumbler, and reduce the center of gravity as much as possible, so that the device can maintain a stable state when it falls, and ensure that one side always lands on the ground. Then the protection work only needs to be done on this one side, thus saving materials.

This scheme fully takes into account the phenomenon of the previous scheme that may roll in the air, and has been improved.

3. Polyhedron type: Polyhedron type is to make the whole device into a polyhedron, and fix the egg on the polyhedron with a strong rope to make the whole egg suspended. After the device lands, no matter which side hits the ground, the egg will not hit the ground, and the egg will be intact.

4. Salt water type: The salt water type is equipped with a very dense sodium chloride solution to float the eggs on it, and the salt water acts as a buffer material after landing to ensure that the eggs are not broken. This scheme is novel and unique, using salt water as a buffer, which is safer, less affected by air resistance, and has higher accuracy.

However, the device is not easy to control, if the device rolls in the air and the salt water spills, it will not play a protective role, so it is necessary to ensure that the center of gravity of the device is stable and as low as possible. The weight of such a device should not be overlooked, after all, brine is much denser than foam.

5. Prepare two thick pieces"Shock-absorbing foam", each digging out the outline of half an egg in the middle, it is the most critical place to protect the egg, there should be no gaps, and it is best to be stuck tightly. Put the eggs in it If it is multiple eggs, then don't rush and dig one by one. But to ensure two tablets"Shock-absorbing foam"It should be a certain length larger than the lower surface after the egg is placed (to reduce pressure).

Finally, it is tied with wide tape (the process is to convert the gravitational force generated by the falling egg into elastic potential energy to a certain extent).

6. Parachute method: you can connect the egg with the parachute, and then use the principle that the parachute will increase the air resistance, and finally let the egg land smoothly.

7. Frozen egg sponge method, freeze the egg hard and wrap it with sponge.

Eggs fall from a high altitude, how can I ensure that they do not break? The guy's method is absolutely amazing.

Find a piece of A4 paper, roll it into a cone, place the egg in the middle of the cone, and seal it. When throwing, pay attention to the tip pointing down.

We did this experiment, and we could just use corrugated paper to make a structure that crosses each other.

The last time I saw someone doing an experiment, he used tape to fix N disposable chopsticks on the egg in a spherical radial shape, which is equivalent to making a "landing rod" around the egg, so that the force on the egg is almost all on those "landing rods", and ideally, the egg is almost completely forceless.

Fill it in a bag, stuff the bag with that hard foam, and stuff the egg in the middle, you should be fine, right? ~

I've seen paper made into the shape of an ice cream wrapper, put the egg in it, seal it, and throw it away without breaking, I've seen it on the bus, but I haven't tried it if it works.

You can take a thicker piece of cardboard, fold it into an ice cream cone, (like a cone), and put the egg in the cone so it won't break. [It was mentioned in the "Science Experiment Station" in the Happy Camp!] It's a fact].

Make a tripod with 4 chopsticks.

Dip the eggs in the middle

The legs of the shelves are wrapped in plasticine!

Put it in a plastic bag and fill it with air, so it shouldn't break, I think.

Do you want to throw it on the ground, you can think about whether to change the grounding. For example, cotton, sponge, water or something is connected to the bottom.

The eggs have not yet fallen in the sky.

Let the eggs fall vertically, so you should be fine.

If you throw the egg in the water, it won't break.

Experimental. 1. Find an empty carton (to have a certain thickness, preferably which type of packaging box), then punch holes around after the noise, sew the eggs with cloth, leave a rope perforated position around them, and then use a thin rope to wear them from all sides of the box, enter the box and pull the eggs up (so that the eggs will be suspended in the carton, but don't pull too tightly when pulling,) In this way, falling from a high altitude, the air resistance of the carton itself plus the suspension, the probability of breaking the eggs is greatly reduced.

2. You can use A4 paper to fold into a cone, apply foam or sponge or cotton, and seal the egg in the middle (it is best to fix the egg), so that the egg can land safely.

3. You can put the eggs into a slightly thicker balloon, and fill it with two-thirds of the bridge air, and then put a balloon on the outside, and fill it with air, so that the egg socks can land safely.

4. The principle of increasing air resistance by parachute can be used to make the egg land smoothly.