The broadband Internet connection is disconnected, and it is normal after restarting

1. Check whether the network cable is loose.

For most broadband users, ADSL is the most common way to connect to the wireless router, and when the connection is dropped, the first thing we need to consider is the line problem.

Due to the fact that the first line is too long, there are too many connectors, or there are some interference sources, it is likely to cause the line to drop, and the network cable that is inferior and does not meet the standard often causes network instability, so when you find that the line is dropped, you must first check whether the network cable interface is loose.

If you find that the network cable interface is intact, you should check the problem with the power signal light.

Second, whether the power signal light is always on.

If the power signal light is not on, the first thing to check is the power supply. For example, whether the connection is disconnected due to the unstable power supply of the mains, whether there is a problem with the power supply of ADSLMODEM itself, etc.

Touching the ADSLMODEM shell with your hands, it feels very hot, at this time, you may wish to temporarily turn off the ADSLMODEM until it cools down before turning it on, or place it in a more ventilated position, which can also eliminate the disconnection fault.

3. Check whether the data signal is normal.

If the data signal light is not on, it is likely that the line is open, short circuit, etc., and then pass the ** test to see if the line is normal, if not, you can ask the technician of the ADSL service provider to solve this problem.

If the data signal light is flashing, it is likely to be caused by poor line contact, you must check whether the extension is used, whether the connector is firm, whether the ADSL connection line is too long, etc. If the data signal lamp still does not turn on after checking the above steps, the fault is not related to the line, and you can continue to look for other reasons.

Hello, you said that this situation is generally caused by carrier lines, cats, routers, etc.

1 Check the crystal head of the lower network cable, the crystal head of the ** line, whether there is aging and rust, if it does not work, it will be redone, or it will not have an impact.

2 The cat has been left open for a long time, it is very hot and hot, it is recommended to place the cat in a ventilated place as much as possible, and do not overlap with the router. so as not to overheath the temperature. It's really not good to recommend changing a cat with good performance (I hit ** to go to telecom, free to change).

3 Several computers share the network, because the router is too poor, others use P2P to watch movies, etc., it will drag the router to death, restart the router will be better, the long-term solution is to change to a better enterprise-level router.

4. The operator's computer room is far away from your home, beyond the ADSL distance, line failure, etc., then ask them to measure the signal strength and line situation (sometimes two lines, one can be connected to the Internet if one is broken, but the network speed is slow, easy to drop, ordinary people can't find it).

Please find the problem from the above points, I hope it can help you!!

I don't understand hi me, I can teach you to analyze and solve it step by step!!

Is it Wi-Fi? My Tianyi 3G dial-up Internet access often drops, which is normal because there are many factors for this.

You can report this problem to customer service, sometimes our school is like this, and there is a problem with the interface, which should be carefully checked.

The solution to frequent broadband drops is as follows:

1. If you use a router, disconnect the router for stand-alone dial-up test;

2. If you have a modem device, please pay attention to whether the device is overheated, and it is recommended to turn it off for a few minutes before restarting it.

3. If the connection is dropped when running the program alone (such as when playing games), it is recommended to restart the computer or reinstall the program;

4. Check whether the disconnection is caused by computer virus, and it is recommended to scan the whole disk;

5. If there is a server option for the running program, please select China Unicom.

6. If the above methods still cannot solve the problem of disconnection, you can contact the local manual customer service for feedback.

If you have any questions, click here. Consultation.