After the data recovery is completed, how can the recovered data not be opened?

Let me tell you why: no file is kept together on a hard drive. It's chained storage, and that's where the FAT table comes in!

If your hard drive has a lot of disk fragmentation. Then the data of a file, that is, the file cluster, will be distributed in several sectors of the hard disk, when you use data recovery software to recover, only the first cluster of files can be found, and the back part can not be found due to disk fragmentation, or file chain corruption! So can't open or **!

Of course, file header corruption is not ruled out. So the smaller the file data, the better it is to recover! For example, txt documents!

Of course, the data cannot be overwritten before recovery!! I'm talking more professionally, I hope you can understand

The landlord must have written new content to the deleted area, and the easy-me software will only recover the incomplete in this case, and if the data is important, you can find a professional or company, which is very likely to succeed.

Deleting a file does not erase the data on the hard drive, but allows other data to be written and overwritten.

It is likely that part of the data cannot be opened after the recovery is overwritten.

It is recommended to cut off the network cable of the computer immediately when the data is mistakenly deleted, and prohibit other personnel from using the computer until the data recovery work is completed.

After the file is deleted, there must be other files copied on it

Caused a disk overwrite

The data cannot be restored completely

Easy Wake Data Recovery is a powerful data recovery software.

It is suitable for a variety of data loss scenarios, such as deletion, grid differentialization, disk partition RAW, system crash, partial virus infection, etc. Support from desktop computers, laptops, portable hard drives.

USB flash drive, SD TF card.

and other types of storage devices to quickly retrieve lost data, and support the recovery of many different types of files.

Easy Self Data Recovery.

It's okay, depending on personal preference.

If the scanned ** file can be previewed normally, it can be successfully recovered. It should be noted that files should be recovered as soon as possible after being mistakenly deleted, so as to avoid data destruction and overwriting, and once the data is overwritten, it will be difficult to recover.

When the storage medium is out of the core, the bridge is damaged, or the data is invisible, unreadable, or lost due to personnel misoperation or the failure of the operating system itself.

Engineers use special means to read and eliminate data that is invisible, unreadable, and unreadable under normal conditions.

Data recovery refers to the technology of rescuing and recovering electronic data lost on desktop hard disks, notebook hard disks, server hard disks, storage tape libraries, mobile hard disks, USB flash drives, digital memory cards, *** and other devices through technical means.

The computer disk mistakenly deleted the file or the disk was formatted by mistake and the file was lost, and the recovered word file, image and other files could not be opened by data recovery software

1. After the file is deleted, other data is written in the disk where the file is located, the more data is written, the smaller the possibility of recovery, and the worse the integrity of the recovered file; If a file is deleted by mistake, do not write any file to the disk and restore it as soon as possible, so that the chance of successful recovery will be greater.

2. When recovering data, you should use authoritative data recovery software, and the success rate of recovery is relatively large.

3. Recommended data recovery software.

Recovery software can not be completely recovered, some files may be damaged, it can not be opened normally, you can leave an email, I will send you a recovery software, you try again.

Try not to write anything new to the disk before recovering the data.

One: There is a prerequisite for using software to recover data - that is, after you delete the data, you must ensure that you do not continue to save or delete data in the disk, because most of the original data software works to find data in the disk tunnel, so once you save a new file or delete the file, the disk tunnel will be rearranged, the tunnel will be destroyed, and you will not be in the memory of the file, which is the second.

Three: Pay attention to the backup of valuables!

The file that can't be opened is sent to me to take a look.

Your recovery method is wrong, you need to re-recover the data, I hope you did not destroy the data loss "site" in order to avoid the wrong operation to destroy the data again, increase the difficulty of recovering the data. It is recommended to refer to the article here to understand the situation before deciding how to operate. If you still need assistance, please contact me with the information.

What kind of bird is this asking?