How to operate a tumbling kite

1. The first step is to open the rocker of the kite runner, as shown in the figure below.

<>3. In the third step, pass the dead knot wire through the wire hole on the runner, as shown in the figure below.

4. In the fourth step, wrap the wire twice on the runner, as shown in the figure below.

5. In the fifth step, pick up the second line on the runner, as shown in the figure below.

6. In the sixth step, as shown in the figure below, tie another knot with the second line on the runner.

7. In the seventh step, tighten the thread, as shown in the figure below.

8. Finally, turn the rocker on the runner to wrap the wire.

How to tie the kite string, the reel to tie the line teaching.

1. First find the air eye on the kite, use a thicker ** through the air eye, tie a half knot and tie it tightly, forming a ** circle with a half knot. 2. Then fold the kite string back to a section, and tie it tightly with a half knot to form a **circle 3. Finally, tie the ** circle of the kite flying line to the ** circle on the kite and tighten it. Kite Flying Tips:

1. First of all, you must choose a kite that suits you, novices can choose some simple kites with low difficulty coefficients, and good skills can choose some challenging kites; 2. Wear non-slip gloves before flying a kite, which can not only protect your hands from being scratched by the kite line, but also better control the kite; 3. Understand the direction of the wind, the kite is against the wind, and it is easier to fly at the tuyere; 4. Before taking off, you can pull out a line of dozens of meters, and quickly rewind when the wind comes, and the kite can take off; 5. After the kite takes off, the line should maintain a certain pulling force, and the line should be paid off when the pulling force increases, and the line should be closed when the vertical line is perpendicular; 6. When collecting the kite, the line also needs to maintain a certain tension, the tension is large and slow, and the line is quickly closed when the vertical line is closed.

Summary. The first step is to turn on the joystick of the kite wheel. The second step is to tie a dead knot at the beginning of **. In the third step, the dead knotted thread is threaded through the wire hole in the runner. In the fourth step, wrap the thread twice around the runner.

The first step is to turn on the joystick of the kite wheel. The second step is to tie a dead knot at the beginning of **. In the third step, pass the dead knotted thread through the wire hole in the runner. The fourth step is to wrap the thread twice around the lead sunflower wheel.

The front with three wheels.

Thread the kite string through the center hole of the roller, then go around the outside of the roller, then pass through another hole in the roller, and finally tie the kite string to the outside of the roller, you can tie the Sun San kite string to the roller with three wheels in front.