How to unclog the drain hole in the refrigerator compartment

How to unblock the clogged drain hole in the refrigerator compartment.

Power off method: The easiest way to unclog the refrigerator drain hole is to let the ice in the drain melt. The specific method is to disconnect the power of the refrigerator, empty the items placed in the refrigerator compartment, open the door of the refrigerator, and let it stand for a period of time.

When the temperature inside the refrigerator rises, the ice in the drain will naturally melt, thus achieving the effect of dredging.

Pump method: If it is not the ice that clogs the drain hole of the refrigerator, but some food or vegetable residue that has not been cleaned in time has entered the drain pipe, then the first method is useless. We can find a pump to pump up the bicycle, the diameter of the air tube of this pump should be close to the size of the refrigerator drain hole, and the drain hole of the refrigerator can be dredged naturally.

Precautions for refrigerator use.

1. When using the refrigerator, try to minimize the number of times you open the refrigerator door, and at the same time, you need to close the refrigerator door in time after opening the refrigerator door and taking out the food.

2. When refrigerating food, there needs to be a certain gap between the food and the food, and special attention should be paid not to lean the food against the back wall of the refrigerator.

3. Hot food needs to wait until it cools before it can be placed in the refrigerator, which can not only reduce the workload of the refrigerator compressor, but also reduce the moisture in the refrigerator.

4. Use the thermostat of the refrigerator appropriately, and adjust the stall of the thermostat of the refrigerator in time in different seasons.

The above content refers to People's Daily Online-What should I do if the refrigerator freezes in the refrigerator? Spring Festival cleaning is the easiest.

Hunan Jusheng Drilling Company can drill deep-water wells, Hunan Changde, Jishou No. 1:

1.If the drain hole of the refrigerator is blocked by ice accumulation and cannot drain water, disconnect the refrigerator from the power supply first when cleaning. After emptying the contents of the refrigerator compartment, open the door of the refrigerator compartment and let it sit for a period of time to allow the ice in the drain pipe to melt.

2.The drain pipe of the refrigerator was clogged with accumulated ice. Generally, the low temperature inside the refrigerator causes the refrigerator drain hole to be blocked by frost, or some food or vegetable residues that have not been cleaned up in time inside the refrigerator enter the drain pipe and block the pipe.

When cleaning, look for a bike pump. The diameter of the air tube of this pump can be close to the size of the refrigerator drain hole.

3.When using this pump, the upper fitting is removed to expose the trachea.

4.Insert the air pipe of the water pump into the drain hole of the refrigerator, then pump the water hard to make the drain pipe of the refrigerator through, then inject a small amount of clean water into the drain hole of the refrigerator, and then rinse the water pump repeatedly to pour out the water in the water supply tray of the refrigerator. Simply install the fridge's baffle.

II: 1When food debris enters the refrigerator and causes the refrigerator leak hole to be blocked, we need to cut off the power of the refrigerator first when cleaning.

2.After that, the long plastic plug is removed from the refrigerator drain hole, and then inserted into the refrigerator freezer drain hole with a long strip for unclogging.

3.After the above steps are completed, take a glass of water and pour it into the refrigerator drain hole. If water easily enters the drain hole of the refrigerator, the drain hole of the refrigerator has been unblocked.

A geothermal well was drilled on Fengcheng 5th Road before. Now most of them are digging wells in Inner Mongolia and northern Shaanxi. Like you said, there are certainly no plastic tube wells in Xi'an, not even in the whole country.

First of all, you have to open the drain hole of the refrigerator yourself, and then use a hook to hook out the blockage inside, so that you can dredge it.

If it is not serious, it can be dredged with thin wire; If it is serious, you need to cut off the power first, open the back wall of the refrigerator, find the location of the drainage hole, and directly use something to pass it.

There are specialized unclogging tools available online. Use a drained iron coil to pump out foreign objects that are blocking the drainage hole while injecting water.

1. Power off and boil water.

The location of the drain hole in each refrigerator is basically the same, so if you want to clear the problem of the drain hole blockage, you must turn off the power first, so as to ensure safety, and you need to prepare a pot of hot water.

2. Clean the refrigerator room and find the drainage holes.

Take all the things that should be in the refrigerator, use a small shovel to cut all the ice cubes, and shovel all the frost away, and you can clearly see the drainage holes.

3. Open the back lid of the refrigerator.

The next thing you need to do is to find the location of the compressor on the back cover of the refrigerator, which should be a white plastic box with a very distinct drainage hole next to it.

4. Use iron wire to dredge.

Poke the prepared wire from the drain hole of the refrigerator inward, if you can't do it, you can make it into the shape of an ear scoop, dig out some sundries, so slowly dig, according to the length of the drain hole, increase the length of the wire appropriately, this is a method of dredging.

5. Pump inflat.

This step is mainly to completely clean out the debris in the drainage hole, the pump is not too big, and it must be able to put it in the refrigerator. After finding the exhaust hole, connect the pump and pump it inside, during which you can use various tools to plug the gap, it is best to connect the other end of the exhaust hole with the water basin, if there will be bubbles in the exhaust hole connected to the water basin every time, this means that it has been completely unobstructed, and you can play a few more times.

6. Hot water irrigation.

You can use a large needle or a plastic funnel, and pour water into the drain hole in the refrigerator along the street, and the hot water can soften the blockage inside, and then it can be easily discharged, and it is better if you have an air pressure water gun.

Refrigerator drain hole syringe.

This product is specially designed to clean the drain hole of the refrigerator blocked, in fact, it is a large needle tube connected to a very long and thin tube, but it is very practical, and it will be of great help to prepare one at home.

Refrigerator de-icer.

The main form of this product is in the form of spray, when the refrigerator is powered off when it is used, the spray is sprayed on the ice and frost and wait for a few minutes to see the signs of melting, which is very useful.

1.Unplug the refrigerator and turn off the power and heat up a pot of hot water.

2.Clean the refrigerator and you'll see the drain holes.

3.When you open the back cover of the refrigerator with a Phillips screwdriver, you will see a white plastic box (the inside is dry and without water) and a 1 cm long white drain hole.

4.Wrap the compressor in a plastic bag and seal the bag.

5.Bend the wire at one end (required), poke the drain hole inside the refrigerator, if the blockage is not serious, it will pass in a while, if not, you can determine the height of the blockage, and poke it from the drainage hole below, you can determine the length of the blockage. Hold on to a hole in the corner under the drain hole, and connect a basin under the hole.

6.Unscrew the head of the pump, wipe it into the drain hole of the refrigerator to pump in, plug the gap with a rag, otherwise there will be water spurs, wipe the water dry with a rag at any time. If all goes well, the drain will also go through (this step is online to find, but it doesn't work for me).

7.For me, the pump is to remove all the water from the drain pipe in the drain hole, and its practical long plastic hose or other absorbent tools are better. Wipe the water off with a rag at all times.

8.Cool the hot water to about 50 degrees (just drink it slightly), pour it into the drain hole, wait for about 10 minutes, and poke it with a wire 9Repeatedly use the seventh step to absorb water, pour hot water in the eighth step, and poke it with wire, and it will definitely be poked within an hour.

Hello, it's a pleasure to serve you, I've seen your problem. Due to the large number of inquiries now, I will answer them one by one and query and summarize the data for you, so please be patient. Please do not close the order too early, and provide more effective information in order to better answer you, thank you for your understanding and support!

1.Turn off the power of the refrigerator, empty the contents of the refrigerator, open the door of the refrigerator and let it sit for a while to allow the ice in the drain to melt away.

2.Remove the baffle at the back of the refrigerator and prepare a bicycle pump with a diameter similar to the size of the refrigerator's drain hole.

3.Remove the air hose head from the pump, insert the air tube of the pump into the drain hole of the refrigerator, and inflate the air repeatedly to make the drain pipe through.

4.Pour a small amount of water into the drain hole, rinse it several times with a pump, pour out the things and water that have been washed down in the water tray, and install the baffle.

Hope it helps! Have a great day! If you think it is helpful to you, please give it a thumbs up!

After the partition is removed, wipe the stagnant water inside with a rag, and then use the through-hole pin of the refrigerator to dredge the drainage hole.

If there is no through-hole pin, you can choose a relatively soft plastic pipe or a soft and easily deformed plastic strip for dredging, and do not use a relatively hard wire to dredge. Because the drainage hole is generally curved, it is easy to break the drainage hole if it is dredged hard.

You can go to ** or Pinduoduo to search, and you can find it by dredging the refrigerator artifact. Very easy to use.

Pinduoduo sells refrigerator drain hole dredgers online, and you can operate and deal with it by yourself if you buy one.

When the water outlet hole in the refrigerator is blocked, then it will cause a large amount of water to be left in the refrigerator, to solve this problem, you need to dredge the water outlet hole that has been blocked in the refrigerator first, if you don't know the water outlet hole in the refrigerator room, the drainage hole of the refrigerator is in the back.

Tools Ingredients: a cotton swab or chopsticks.

1. In the daily use of the refrigerator, when it is found that a large amount of water is often generated on the bottom plate of the refrigerator fresh-keeping cabinet, then it is possible that the water outlet hole of the refrigerator is blocked.

2. At this time, you can use a dry rag to absorb the stagnant water in the refrigerator first, so that it will not get the water everywhere in the next step.

3. After drying the stagnant water, you can find out the water outlet hole of the refrigerator, generally the water outlet hole of the refrigerator is in the fresh-keeping cabinet above the refrigerator, when the fresh-keeping cabinet is opened, you can find it in the back of the middle layer inside.

4. As shown in the figure below, when the fresh-keeping cabinet of the refrigerator is opened, and then the items on the middle layer of the fresh-keeping cabinet are removed, this water outlet hole is found in the rear, and there is a water guide tank at the position of the drainage hole.

5. Wipe the inside of the water guide tank first, if the water outlet hole is blocked, then slowly use cotton swabs or chopsticks to get the blockage out, and then wipe the hole clean, so that the blockage of the water outlet hole of the refrigerator is solved.

6. The water outlet hole of the refrigerator should be checked from time to time to avoid too many blockages, and it will be very troublesome to dredge it after getting under the hole; In addition, in order to reduce the situation that there is too much condensation in the refrigerator and the moisture is too high, which causes mold and clogs the water outlet hole, those items that usually have residual water should be drained and poured before putting them in.

There is a drain hole in the refrigerator compartment (near the sink), and you can use the pump you usually use as a tool to pump air into the drain hole, so that you can dredge it. Next the burning chain is the detailed steps or contains:

1. Prepare a pump.

There is a drain hole in the refrigerator compartment (near the sink), and you can use the pump you usually use as a tool to pump air into the drain hole, so that you can dredge it. Here are the detailed steps:

There is a drain hole in the refrigerator compartment (near the sink), and you can use the pump you usually use as a tool to pump air into the drain hole, so that you can dredge it. Here are the detailed steps:

4. Take out the pump with the valve and insert it into this hole.

5. Then press hard to pump and discharge.

Notes:

1. Dredging the drain hole of the refrigerator If the drain hole is not seriously blocked, you can also simply use a thin shirt to laugh at the wire. The diameter of the wire is sufficient, too thick can not automatically turn, too thin is easy to deform and forceless.

2. If the blockage is more serious, turn off the power of the refrigerator first, open the door of the freezer and refrigerator room, pull out all the drawers in the freezer, increase the temperature of the box, and slowly dissolve the drain pipe.