How to connect a line lighting with a Xiaomi balance car?

Start the headlights and taillights at the same time for 1 second, and then turn off, indicating that the car body has been activated from sleep mode;

2. When the machine is turned on, the headlights and taillights are lit up in the same way as a marquee, indicating that the car body is flexible and can start running;

3. When standby, the headlights and taillights will flash every 3 seconds, indicating that they will enter the standby state;

4. When sending an error, the headlight and tail lights are lit at a frequency of 1Hz, prompting a sending error;

5. When manned, the tail light is half-lit, indicating that it is in manned mode;

6. When braking, the tail light is fully lit (about 1 second), and then the previous tail light is half bright, prompting the brake;

7. When turning, the tail lights in the corresponding direction are flashing, and the headlights are lit in the form of marquee from both sides to the middle, prompting the turning and turning party It is recommended to activate the battery while charging in the future, so that there is no memory of battery charging. 2.Charge with an AC socket, charge to 100% and turn off the battery, then charge in the shutdown mode until the light turns green.

3.Enter the recovery mode, select advancsd advanced mode, select wipe battery, and clear battery traces. 4.

Turn on and charge to 100% so that the battery has no memory, and the charging is much faster after the need to replace the switch, do not connect it directly, so there will be potential safety hazards, it is very likely that the lights in the room can not be extinguished normally after locking the car, safety first, it is not much money to change a switch.

Zhongzheng Xiangrui. 2019-11-26 There is too much complicated information, you have to learn to discern it.

Concern. If it's a bad switch, there are three wires on it, you just cut the three wires together. Because, one of the three wires is an incoming call, and the other two wires are through two bulbs of different wattages.

If there are two wires on the bad switch, there is only one bulb, you cut the two wires and connect them together, and the remaining line is the negative wire, which is connected to the other end of the bulb and the battery needs to know the rated voltage of the battery directly, and then select the corresponding charger to charge. For convenience and safety, it is recommended to repair the charging port. Target.

Hengche introduction. A novel personal service robot is also a new form of electric balance car. The driver can stand on the car, use the movement of the body to control the movement of the car body, and can also use mobile devices such as smart ** to control the robot to drive unmanned.

Sign-in method. 1. Registration can be created, or you can directly use Xiaomi to log in, and you can connect to the device through Bluetooth by logging in. If the Bluetooth icon on the fuselage panel is flashing, it means that the balance bike is not connected, and you can reconnect it on the mobile app.

2. If the device is successfully connected, you will be asked to fill in your basic personal information and a free personal accident insurance (for one year), and you can activate the beginner tutorial after filling in the information.

Hello, you can consider charging lighting gear.

The connection is successful, and everything on the phone shows normal, but it doesn't start?

、The Xiaomi Mi No. 9 balance car can't be charged, first check whether the charger is correct.

Often. Check whether the charging data cable plug is in poor contact with the charging socket of the balance car.

Wait, check whether the battery inside the balance bike is damaged, etc.

First turn on the Bluetooth of the Xiaomi balance car, at this time, the indicator light of the balance car flashes red and blue alternately, open the mobile phone settings, find the Bluetooth search, click to enter the link, connect the balance car, turn off the red light, and flash the blue light once a second, indicating that it has been connected.

To charge the battery directly, you need to know the rated voltage of the battery, and then select the corresponding charger to charge. For convenience and safety, it is recommended to repair the charging port.

It's best not to drive it when charging, safety first, I'm also playing balance bikes, and I'm playing CO1 with today's knowledge

I don't turn on when I'm charging

It's definitely safer to do that.

I hope it will help you.

Method Steps:

2. Connecting lines. You need to find two short wires to connect the charging plug and the battery interface, strip off the protective layer at both ends of the wire, and make a 180-degree hook to ensure that the contact point is firm.

3. Power-on activation. After confirming that the line is connected correctly and the contacts are secure, power on and activate the battery.

4. Charge normally. Insert the charging plug directly into the charging socket of the battery compartment and power it on again.

5. Loading and running. Reinstall the battery box to the balance bike and turn on the power switch of the balance bike.

My Xiaomi Mi No. 9 balance bike is not charged, and it can't be turned on after two years, and the charger shows a green light.

Today just went to Xiaomi after-sales to activate the battery successfully.

Pay the activation fee of 100 yuan.

If the battery is over-discharged, if you connect the charger, the car is intermittently ringing, and the charger flashes alternately with red and green, then try my method and do not disassemble the battery. Plug in the charger, press the on/off key at the same time as the car screen flashes, then the lights will flash, and you can also see that the rechargeable battery will go two bars, and keep pressing it until it can be charged normally.

The battery of the Xiaomi balance car is dead and cannot be flushed into the battery, so you can consult the after-sales customer service or go to the repair shop.

1 and 2 of the charger, connect the wire to the discharge port of the battery, pay attention to measure the positive and negative poles with a universal meter, don't make it the other way around

The battery of the Xiaomi balance car cannot be charged at a loss, so you have to go to the local store to activate it.

1. First of all, consider that the charger is bad, if you change the charger or so, this is a short circuit of the line, the battery is fine, don't be deceived by someone to change the battery;

2. Maybe you drained the battery to the point where it was completely dead. This situation can easily cause the battery to not be charged for a long time. The charger is always plugged in, and I'll look back in a few hours. If it still can't get back to normal, it is estimated that the battery is broken.

3. If you don't know what the problem is, go to the after-sales consultation as soon as possible to solve the problem.

The battery is taken out, and the positive and negative poles of the battery are directly connected to 40v and then put back into the scooter to be charged in the original way.

Go to customer service! Or go to Xiaomi Home to find after-sales.

The counseling fee should be drunk and drunk v needs to be replaced haha dada

Cluck, cluck.

I thoroughly sent out leaflets, familiar with eating big seats, familiar with eating baba, just sent v

Hello, the Mi 9 balance bike can be connected with a mobile phone or not.