How do you make a wish after the paper stars are folded? Origami of stars that you can make a wish o

Write your wishes down on paper and fold them into stars.

<>< a 15*15cm square piece of colored paper, folded in half along the middle.

Fold in half on the left.

Fold the right side to the center of the left cross.

Fold it in half on the back.

The top part is cut out.

The five petals are pulled outward, and the petals and the petals are pinched inward, and the beautiful star flower is ready.

Today I would like to share with you a wishing star practice, this kind of little star is used by many girls to write their wishes and secrets in it, a very cute origami. It's easy, learn it.

Tools Raw materials: long strips of paper.

Prepare a narrow strip of paper, and then tie a flat knot like a rope knot, and try to have as few extra strips of paper at one end as possible.

The knot is pressed according to the tiling direction of the paper, and a pentagonal shape with a plane outline can be basically seen. But you can't press it very firmly, if you press it too much, you won't be able to pinch it later.

Fold the strip of paper at the longer end along the outline of the pentagon, the first step is to fold the strip to the side of the opposite side that has no extra strips.

Continue to flip the pentagon, so that the long strip of paper wraps around the pentagon, and the folding direction after the first step is unique, so don't worry about the poor finger winding, the long strip of paper will overlap with the extra short strip of paper during the winding process, ignore the short strip of paper, just continue to wind.

After the paper strip is wrapped, the flat pentagonal shape is very obvious, and the end of the paper strip is tucked into the paper seam, and if the end end is long, cut off.

The last step is the most critical, pinch the five corners of the car's pentagonal shape with your fingernails and squeeze it in the middle to make the pentagonal shape bulge, so that the three-dimensional little star is completed.

If you want the stars to be bigger, you can increase the width of the strip, and of course, the length of the strip should also be increased accordingly.

<> "Beautiful Wishing Fortune Cave Star Origami.

A square piece of colored paper, folded in half along the middle.

2.Fold in half on the left.

3.Fold the right side to the center of the left cross.

5.Turn to the back and quietly turn back to the state.

6.The top part is cut out.

12.Pull the five petals outward, pinch the petals inward between the petals, and the beautiful star flower is ready.

We will use markers, colored paper and A4 paper, and the next thing to do is to fold the lucky wishing star, which is divided into 3 steps:

First, take a rectangular piece of paper and fold it in half, then go over it, and then fold it diagonally along the edges. Then fold one more to make a triangle-like shape.

<> then cut off the excess with scissors, leaving a triangle. Open is a little star. Then take a long strip of paper and stand on the double-sided tape and glue it to the stars.

<> Finally, use a comic pen to draw a star along the edge of the star, and then write a blessing on the wishing note below. Such a lucky wishing star is folded.

You can also write the text as you like.

Stacking: 1 Fold a pentagon at one end of the strip of paper (knot, tighten, flatten – and make sure each side is as wide as the strip).

2. Fold the paper in the direction that is easy to fold (always keep the pentagon, try not to pinch the middle when winding, so that the success rate is high when the back is raised).

3 After folding layer by layer, finally stuff the end end of the paper strip into it (not long enough to cut it shorter, retreat to the place where it can be stuffed in the previous circle).

4 Puff up the line between the pentagons and the corners, and you're good to go! (Pinch one corner with your index finger and thumb, and then pinch it little by little along the edge of the two corners with your fingers).

<> wishing star meaning.

1 star represents love and the only love.

2 stars represent love for each other.

3 stars represent I love you.

5 stars represent I love you to death.

The 11 stars represent favorites.

The 36 stars represent the promise of two loves.

55 stars represent love you without regrets.

The 66 stars represent that may your and my love be smooth and never separated.

The 99 stars represent a long time with you.

101 stars represent eternal love and you are my only one.

129 stars represent May you love me forever.

365 stars represent wishes come true.

548 stars represent May you love me so much that you can't help yourself.

999 stars represent Eternal Guard.

1000 stars represent unapologetic love and 10,000 stars represent 10,000 years of love for you.

Cut the paper into strips 2 5 cm wide, fold the short end inward along the edge of the star so that it does not get pulled out, go around the edge of the star and stuff the tail into the star.

1. Prepare star paper.

2. Tie a knot and tie it like a scarf.

3. Thread the tail through the middle.

<>5. Complete the beginning, this is the prototype of the little star, very important.

6. Pick up the paper strip and fold it along the prototype until the paper is wrapped.

7. Finally, insert the rest into the gap.

8. Use your thumb and index finger to pick up the star-shaped corners.

PrecautionsModern origami is not just an art, but has developed into a new science, and the mathematics of origami, which has been applied to parachutes, solar panels on artificial satellites, airbags in cars, and even the structural design of the Hubble Space Telescope, has benefited in part from origami mathematics.