A GHOSTERR TXT APPEARS WHEN INSTALLING THE SYSTEM

This is a reading and writing error in the process of copying data by GHOST software, and a dialog box will pop up, to the effect that the error information is saved to disk A. Since it is a mistake in reading and writing, since everyone has their own.

1.When using ghost, try not to overclock.

3.Optical drive performance: The optical drive used for installation has a problem with the performance of the optical drive.

4.disc quality; The burning quality of the burner is not good or the quality of the burning disc is faulty.

5.Incorrect burning method: When burning a disc, select Burn Image File, and then select Burn Disk as Burning Mode, and use a final burn of less than 24x.

6.Ultra-engraving: Disks over 700m are very dangerous, and almost all of them will have such problems.

Version issues. 8.Hard disk problem: Format the C drive completely, do not add Q

9.Recently I encountered this situation was an error in the boot area, and running fdisk mbr solved it when I asked the master of the xtzj forum. The answer they gave. Hope it works for you.

1. The ghost disc is not burned well;

2. The ghost version is too low: For example, if you use it when backing up the ghost image, and you are using it to restore the image file, then the above problems will occur;

3. There is a problem with the disk, such as a partition error;

4. The partition capacity of the C drive is small (many people ignore this problem).

To solve the above problems, we recommend that you take the following steps to try to solve them:

1. Use ghost to check the image file or disk to see if there is a problem, as shown in the following figure (if you want to use a professional tool to detect, you can use the efficiency source hard disk detection and repair tool).

Usage] Select local check image file to check whether the ghost (gho) image file is correct. Or select local check disk to check if there is a problem with the disk.

Ghost 2: Use PQ (PQMAGIC) to check whether there is a problem with the partition.

attachment=8451]

3. Use PQMAGIC to adjust the capacity of the C drive, and the adjusted capacity should be greater than 10G.

4. If none of the above methods work, try to re-burn the disc. (It is recommended to use clonecd burning, the integrity of the software burning is quite good, and you can burn encrypted discs).

You are prompted to enter the PE system and then run ghost to manually clone.

This is just two problems: 1, CD 2, CD drive.

Your disc or optical drive is broken.

Change the disc first, and if it doesn't work, the disc will break.

This problem often occurs when making a system, which means that this system disk is not good, and it is recommended to try a different system disk.

Try changing the memory, I have encountered this kind of problem, after changing the memory, ghost succeeds.