HUAWEI Enjoy 7Plus how to connect to a computer tutorial

The following is the following guide for inserting a card into a Huawei mobile phone:

1. Take the card tray.

In the shutdown state, find the card slot at the top of the left side of the phone, insert the card pick-up pin vertically into the small hole on the side of the card tray, and press hard to make the card tray pop out.

Second, look at Cato.

3. Insert the card. Place the nano-SIM card and microSD card into the tray in the direction indicated, noting the direction of the notch.

Note: 1. Only one card can be inserted in card slot 2 at a time.

2. The mobile phone can insert 2 nano-SIM cards at the same time, or 1 nano-SIM card and 1 microSD card at the same time.

Fourth, insert the card tray back.

The phone screen pushes the card tray flat back into the card holder.

Finally, press and hold the power button to turn it on, and you can use the Huawei Enjoy 7 Plus.

HUAWEI Enjoy 7 Plus is a dual-tray-in-one design that supports the insertion of 2 nano-SIM cards, or 1 nano-SIM card and 1 microSD card at the same time.

Note: The SIM card slot only supports nano-SIM cards. Check with your network operator to replace or purchase a standard nano-SIM card.

Please use a standard nano-SIM card, inserting a non-standard card may cause damage to the card holder.

Pay attention to the direction of the notch, and keep the card tray level when inserting the card.

Pay attention to safety when using the pick-up needle to prevent fingers from being punctured or damage to the device.

The pick-up pin is only used to insert the small hole on the edge of the tray and eject the tray. Inserting a pin into a hole or part other than the pin may damage the device.

The steps are as follows:2. Use the randomly distributed card pick-up needle to insert the small hole on the side of the card tray and eject the card tray.

3. Put a nano-SIM card or microSD card into the card tray.

4. Insert the card tray back into the phone in the direction of taking it out.

Use the Huawei standard card pick-up pin, insert the card tray hole vertically, and push the card tray out with a little force, and then you can pull the card tray out of the phone. Then install the mobile phone card in the card tray, and then install the card tray in the mobile phone.

How to solve the problem of not being able to connect to the wireless network:

01. Turn off the wifi and try to reconnect.

02. Restart the wireless router.

03. Turn on the wifi, find the wifi you want to connect to, and click on the back"Exclamation point"。

04. Open"Static IP", manually enter the IP address (the IP address of the mobile phone, generally can be between 1-255). Then click"Connect to a network"。

Here's how to switch it:

1. First, use your finger to pull down from the top of the screen to bring up the notification bar.

2. After opening the notification bar, pull down from the notification bar with your finger to make it complete.

3. After the notification bar, tap the "4G Switch" icon in it to turn it on.

4. When you turn on the switch, a very small 4G message will appear at the top of the screen, indicating that you have switched to 4G network mode.

There is a dual SIM management in the phone settings, just set it as needed.