How to solve the blue screen after the computer reinstalls the system

Today, I will share a common problem when installing the system, that is, the computer blue screen cannot be turned on after the system is installed! What is the reason for the blue screen of a computer to reinstall the system?

The blue screen 0x0000007b the computer reinstalled system, most of the reasons are driver problems, because the newly installed system does not have an AHCI driver, and the BIOS hard disk mode is in AHCI mode.

Long story short two ways:

1.As mentioned earlier, the blue screen problem caused by the hard disk mode in AHCI, then go to the motherboard BIOS to change back to IDE mode or compatibility mode, but if the hard disk is SATA interface, I don't recommend using the IDE working mode, which affects the performance of the hard disk:

2.Since the AHCI mode is because there is no driver, then we can inject the AHCI driver into the computer, enter our own USB flash drive PE system, run the SkyIAR software, this software can only run in the PE system environment, you can go to WeChat to enter AHCI**, click to run the software will automatically scan the driver needed by the system, and inject the matching AHCI driver into the system:

3.Restart the computer and the system has booted normally.

Software Repair: 1. Press F8 immediately after booting until the advanced option appears and then let go, and select "The latest correct configuration" Enter to repair.

2. If it doesn't work, press F8 to enter the safe mode to restore the system or reinstall the system, or use [U to start the U disk boot disk] to install it.

Hardware repair: 1. First detect the bad sectors of the hard disk, if there are a large number of bad sectors in the hard disk, it is recommended to replace the hard disk with backup data. If it is less bad, it is recommended to back up the data, reformat the partitioned disk, and friends who understand computer hard disks can also isolate the bad to the hard disk area.

After that, you can reinstall the system.

2. One of the main reasons is the blue screen failure of the computer after installing or updating the graphics card driver incorrectly. Restart the computer and press F8 to enter the safe mode, add and delete the graphics card driver in the control panel of the safe mode: then restart the normal system to enter the system, reinstall the graphics card driver or change to another version of the graphics card driver.

3. Overclocking is a major hardware issue that causes blue screens. Only if you take good heat dissipation measures, change to a powerful fan, and add some heat dissipation materials such as silicone. In addition, overclocking in moderation or not overclocking at all is also one of the solutions.

Most users don't usually overclock, so this is generally not practical.

4. In actual work, the most common phenomenon of computer blue screen encountered by the author is poor contact of memory modules (mainly caused by too much dust inside the computer, which often occurs in old computers) and the blue screen of computers caused by hard disk failures. Try opening the computer case, unplugging the memory module, cleaning the lower slot, and cleaning the gold finger of the memory module before installing it back. If the problem is not resolved, determine that it is a memory fault and replace the memory module.

5. Hardware compatibility problems: Please check the latest hardware compatibility list to see if all hardware is included in the list. Or use the appropriate Windows Upgrade Assistant to check the hardware requirements.