Subject 2: Can the front of the right angle turn sweep the line, is it a deduction or death?

Subject 2Right-angle turnsThe front of the car is swept and 100 points will be deducted.

Subject 2: When the front of the car crosses the line at a right angle, if it is induced by the electronic instrument, it is directly hung up, because it has been hit in real life. In addition, either wheel is pressed against the edge of the road while driving.

100 points will be deducted for stopovers.

Right-angle turns

First, the essentials of operation.

The car starts in low gear.

The car enters a right-angled corner.

Previously drive on the right, with the right wheel at a distance of about one metre from the right-hand sideline of the road.

When the car is in line with the driver and the inside right-angle protrusion, quickly turn the steering wheel to the left to the limit position.

When the left rear wheel crosses the inside right-angle protrusion, it begins to gradually drive out of the road in the direction of the right return.

Straighten the car and drive off the road.

Second, the operation skills.

1st gear idling. Before entering a right-angle turn, keep the car as far away from the protrusion as possible within the side of the road.

When the center of the triangular window on the front window near the protrusion coincides with the protrusion, hit the steering wheel to the side of the protrusion. When the front of the car turns to a new direction, pay special attention to the right front wheel not to press against the right-hand side of the road.

Try to stick to the right sideline when turning at a right angle.

When you see the front of the car aligning with the exit, you quickly turn back to the right direction.

It is necessary to pay attention to the difference of the inner wheel, correctly estimate the trajectory of the inner rear wheel, and shall not press the inner right-angle protrusion point and sideline, and shall not stop and reverse.

The above content refers to Encyclopedia - Subject 2

Deduct points. Subject 2: When turning at a right angle, the front line sweep deducts 100 points. Right turns are judged according to the following rules:

a) The wheel rolls on the edge of the road, which is unqualified;

b) 10 points will be deducted if the turn signal is not used or used incorrectly when turning, and the turn signal is not turned off after turning;

c) If you stop in the middle of the road, 5 points will be deducted each time. Subject 2 right-angle turning operation skills: park the vehicle at the starting position of right-angle turning, engage in first gear, release the handbrake, slowly lift the clutch and maintain a semi-linkage state to start moving at a constant speed, and keep the body 20 cm away from the left edge of the road.

100 points will be deducted directly from reversing into the garage and parking on the side.

100 points will be deducted directly from right-angle turning, curved driving, and the wheels rolling on the edge of the road. There is no line sweeping in the steering judgment of subject 2, only the line is out and the wheel line is pressed, so we can basically understand the line sweep line as the situation that the body is not out of the line and the wheel is not pressed.

The special evaluation of subject 2 only stipulates that the body is not allowed to go out of the line, and there is no such thing as the body sweeping the line. Basically, as long as the body does not go out of the line, it will be fine, but it depends on the judgment of the test computer, after all, the sideline is not very wide.

The teaching objective of Module 2 is to require students to master the basic driving operation essentials and have the basic ability to control vehicles. Proficient in the basic methods of driving on the site and the road in the field, with the ability to reasonably use the vehicle control parts, correctly control the spatial position of the vehicle movement, and be able to accurately control the driving position, speed and route of the vehicle.

Right Angle Turns: Correct Demonstration and Scoring Criteria.

Subject 2: Right-angle turning front sweep line, 100 points will be deducted.

Subject 2 Exam Deduction Criteria:

1.Reversing into storage:

1. Not driving according to the prescribed route, unqualified; 2. The warehouse is not in the warehouse, and it is unqualified; 3. The edge line of the body is unqualified; 4. Stopping halfway, unqualified; 5. If the reloading time exceeds 4 minutes, it is unqualified.

2.Ramp fixed-point parking and starting:

1. There is no fixed-point parking, which is unqualified; 2. After the fixed point, the front bumper of the car is located within the dotted line and outside the solid line, and 10 points will be deducted; 3. If the front bumper of the car is located outside the dotted line, 100 points will be deducted; 4. If the left turn signal is not turned on at the start, 10 points will be deducted; 5. If the back slip is greater than 30cm at the start, 100 points will be deducted; 6. The back slip is less than 30cm at the start', 10 points will be deducted; 7. If the starting time exceeds 30 seconds, 100 points will be deducted. 8. The vehicle presses the edge line during the driving process and is unqualified.

3.Side Parking:

1. 100 points will be deducted for body crimping; 2. Stopping halfway, 100 points will be deducted; 3. If you do not turn on the left turn signal at the start, 10 points will be deducted.

4.Right-angle turns

1. During the drive, the wheel presses the edge line, and 100 points will be deducted; 2. Stopping halfway, 100 points will be deducted;

5.Curve driving:

1. 100 points will be deducted for wheel crimping during driving; 2. Stopping halfway, 100 points will be deducted;

You can't sweep the line, you have to practice more. I can teach you a trick, first control the speed, the right quarter of the front of the car is aligned with the right white line to drive into a right-angle turn, and then look at the left front door handle along the edge of the right-angle library when the left white line coincides, kill the steering wheel, the car is turning the steering wheel back to the right, pay attention to the speed of the steering wheel to match the speed, hope!

To deduct points, the current five items except for curve driving and right-angle turning front line are fine, as long as the tires do not press the line, the remaining three bumper tires can not sweep the line.

Now the new driving test regulations clearly point out that if you stop halfway during a right-angle turn, you will be deducted 5 points each time, you must pay special attention to this in the test, you must not turn off the engine, and you must not forget to turn the turn signal when turning, if you forget to turn the signal or the light time does not exceed 3 seconds, it will also hang up directly.

Essentials of right-angle turning: the car starts in low gear; Drive on the right side of the car before entering a right-angle bend, and keep the right wheel at a distance of about one meter from the right side of the road; When the car is in line with the driver and the inside right-angle protrusion, quickly turn the steering wheel to the left to the limit position. When the left rear wheel crosses the inside right-angle protrusion, it begins to gradually drive out of the road in the direction of the right return. Straighten the car and drive off the road.

Section IIRight-angle turnsThe front line sweep is hung up. Subject 2

Right-angle turning head sweep line, deduct 100 points, right-angle turning head sweep line is not allowed, subject two right-angle turn when the front of the car crosses the line, if it is induced by electronic instruments, it is directly hung up, because in real life it has been hit, in addition, any wheel in the driving pressure road edge line, halfway parking is deducted 100 points.

Section 2 right-angle turning precautionsBefore entering a right-angle corner, the speed of this tong must be slowed down, and the key is to correct the body. When the vehicle is aligned, the vehicle should slowly drive close to the outer edge of the road, and the lateral spacing should be controlled, and it is advisable to keep a distance of about 30 cm between the outer wheels and the outer edge line, and keep moving in parallel. The front of the car is close to the turning point, and there is no delay in making a sharp turn.

Wait for the pre-safety stuffy lap pole.

When it is level with the point of the protrusion, quickly turn the steering wheel to the left (right) to the limit position. Do not slam on the throttle. Pedal.

Subject 2: Right-angle turning front sweep line, 100 points will be deducted. Subject 2 exam deduction criteria: 1. Reversing and warehousing:

Failure to follow the prescribed route is unqualified; 2. The warehouse is not in the warehouse, and it is unqualified; 3. The edge line of the body is unqualified; 4. Stopping halfway, unqualified; 5. If the reloading time exceeds 4 minutes, it is unqualified. 2. Ramp fixed-point parking and starting: there is no fixed-point parking, which is unqualified; After the orange suspicion is fixed, the front bumper of the car is located within the virtual vertical line and outside the solid line, and 10 points will be deducted; If the front bumper of the car is located outside the dotted line, 100 points will be deducted; If the left turn signal is not turned on at the start, 10 points will be deducted; If the back slip is greater than 30cm at the start, 100 points will be deducted; If the back slip is less than 30cm at the start, 10 points will be deducted; If the starting time exceeds 30 seconds, 100 points will be deducted. On the way, the vehicle presses the edge line and is unqualified; 3. Side parking:

100 points will be deducted for body crimping; 2. Stopping halfway, 100 points will be deducted; 3. If you do not turn on the left turn signal at the start, 10 points will be deducted. 4. Right-angle turning: 100 points will be deducted if the wheel presses the edge line during driving; 2. Stopping halfway, 100 points will be deducted; 5. Curve driving: 100 points will be deducted if the wheel is pressed during driving; 2. If you stop the circular fiber handcar halfway, 100 points will be deducted.

When making a right-angle turn in subject 2, 100 points will be deducted for the front line sweep.

According to the "Content and Method of Motor Vehicle Driver Test":

Right-angle turnsRight-angle turns are judged according to the following stool reed regulations:

a) The wheel rolls on the edge of the road, which is unqualified;

b) 10 points will be deducted if the turn signal is not used or used incorrectly when turning, and the turn signal is not turned off after turning;

c) If you stop in the middle of the road, 5 points will be deducted each time.

Subject 2: No points will be deducted if the right-angle turning head sweep line is scanned. The right-angle turn of subject 2 is an important assessment point of subject 2 in the driver's license test, which assesses the ability of motor vehicle drivers to correctly control the steering and accurately judge the difference between the inner and outer wheels of the vehicle when driving a vehicle in a rapidly changing road section. The following are the test tips for the driver's license test subject 2 right angle turn:

1. When the front of the engine cover is buried just to block the line in front, quickly kill the steering wheel to the left. Observe the rearview mirror, when the body is parallel to the sideline, return to the steering wheel, and drive out at a constant speed;

2. When the center of the triangular window on the side of the car near the turning point coincides with the turning point, it is necessary to hit the direction to the side of the turning point. When the body is parallel to the sideline, it quickly returns to the right direction through the rearview mirror. Just drive out at a constant speed;

3. When the left shoulder coincides with the horizontal edge of the corner, quickly hit the direction to the left, observe the rearview mirror when the body is parallel to the sideline, return to the steering wheel, and drive out at a constant speed.

Subject 2: Right angle turning head sweep line, as long as the wheel is not pressed on the **, theoretically no points will be deducted. In the exam, those solid lines are equivalent to a wall, and sweeping the line at the front of the car is equivalent to hitting the wall, so if you can not sweep the line, try not to sweep the line, so as not to cause unnecessary trouble. In the first bend exam of subject 2, you must pay attention to the following points.

1. When driving the vehicle into a right-angle turn, the speed of the vehicle must slow down to give yourself a chance to react and correct.

2. During the test, you must be calm, not panic, and pay attention to the changes in the movement of the vehicle at any time.

3. The vehicle should drive close to the outer edge of the road and control the lateral spacing. It is best to control the outside of the tire and the outside edge line at about 30 cm.

4. Maintain a smooth and uniform speed throughout the driving process.

5. Observe the rearview mirror at any time to avoid the possibility of the rear wheel being pressed.

6. When the wheel is close to the right-angle turning point, it is necessary to return to the steering wheel in time, and when the head of the car turns to a new direction, it is necessary to slowly let the car return to the right and continue to move forward.

In the subject 2 test, you must drive carefully, keep in mind the key points of each item given by the instructor, especially the elements of a right-angle turn, so that you can pass it smoothly.