How to deal with the problem of apples getting into the water?

How to deal with the water after the iPhone is ingressive.

1.Turn off the phone as soon as possible, cut off the power, and do not try to turn it on again to avoid causing a short circuit in the motherboard.

2.Remove the SIM card and use a tissue or cloth to remove water from the outside and crevices of the phone.

3.If there is light water ingress, you can wrap the phone with a paper towel, put it in a bag and put it in a small bag of desiccant.

4.The mobile phone cannot be turned on after entering the water, most of the chips such as the motherboard and CPU are short-circuited and burned, and it is recommended to send it to the after-sales service center for repair immediately.

Don't try the following wrong methods after your phone gets into water.

1.Don't shake your phone too hard. Because under the constant shaking, the liquid will swim inside the machine, and the moisture may enter deeper and burn the internal chip of the machine.

2.Don't use the hot air of a hair dryer to dry your phone for a long time. iPhones are now all metal bodies, and metal conducts heat easily, which will blow off the solder joints of the motherboard inside the machine, causing the motherboard to malfunction.

3.Do not attempt to charge a phone that has been flooded. An iPhone that gets into the water may have water stains inside, which can burn out the motherboard when it is powered on and cause a more serious failure.

4.Do not leave your phone in water for a long time. In the case that it cannot be used normally after two or three days after general treatment, it should be sent for repair immediately, and long-term placement will cause the motherboard to be corroded, or even unable to be repaired.

Don't turn it on after the water enters, you can be in the sun for two days and then send it to the after-sales maintenance point, it is best to Apple's own after-sales maintenance inspection point, just go over directly after making an appointment on the mobile phone, this problem should be solved quickly.

If there is water, it will not flow out by itself if it is not treated, and it is likely to cause corrosion of parts such as the motherboard and battery within a few days of placement, so it is recommended to go to the repair shop in time after suspecting that water has entered, and disassemble and clean up the water to protect the phone.

First of all, we will turn off the mobile phone to prevent the water in the mobile phone from burning the circuit components. Then we shake the phone vigorously, but be careful not to let the phone fall off.

After the water in the mobile phone is thrown out, the mobile phone is placed under a slight heat source such as a desk lamp, and the mobile phone is baked, and the process of evaporating the water in the mobile phone generally takes about six hours. Finally, we turn on the phone and check if the phone can hear the sound.

Mobile phones, which belong to mobile terminals, are mobile ** machines that can be held in the hand. In the early days, it was commonly known as big brother because of its large size, and it has now developed into the 5G era.

In April 1973, the American engineering technician "Martin Cooper" invented the world's first mobile phone for civilian use, and "Martin Cooper" has since been known as the "father of modern mobile phones". Until now, mobile phones have become a very important tool in people's lives, and like a Swiss army knife, they can be diversified and bring people a better life experience.

Glad to serve you What should I do if the apple gets into the water Get the phone out of the water as soon as possible and turn it off immediately. This is very important, no matter whether the screen turns black or not, please quickly shut down the motherboard to prevent the motherboard from being short-circuited and burned out, if you press and hold the power button to shut down, please press and hold the pure source button and the home button until the system shuts down. Take out the SIM card, remove the phone case and other items, and use tissues, pants or cloth to remove the water outside and in the crevices of the body.

Wipe the SIM card as soon as possible after it is removed. Note that the headphones and power connector can be plugged in and blotted dry with a small cotton swab or paper towel strip. Wrap the body with an absorbent towel or paper towel to absorb moisture.

Step 1: After the iPhone enters the water, try to separate the iPhone from the water, the sooner the better! Hungry Cave Search.

Now the integration of the iPhone is actually very high, and the closure of the fuselage is also very high, so just after entering the water, in a short period of time, the water has not penetrated into the fuselage, so the sooner the iPhone is out of the water, the better!

Step 2: Shut down now! Don't shake the water and avoid getting inside your phone!

In the past, the mobile phone had a removable battery, so after entering the water, there was no doubt that the battery was directly detained, and now the iPhone mobile phone cannot be detached from the battery, so go directly to shut it down! In the boot state, if water slowly seeps into the circuit, it will cause a short circuit, and after the shutdown, it can be a good way to avoid a short circuit and cause damage to the motherboard.

Step 3: Wipe with a towel and wipe the water on the surface of your phone and dry it quickly!

The previous step also mentioned that when there is water on the surface of the mobile phone, do not use the water throwing method, which will accelerate the water into the inside of the mobile phone, but use a dry towel or paper towel to quickly absorb moisture, especially in the open holes such as the interface, try to wash the water trembling plum dry.

Step 4: Dry your iPhone, you can use hair dryer, rice, desiccant, etc. to absorb moisture!

After the water removal on the surface of the mobile phone, in order to ensure that there is no water infiltration inside the mobile phone, you can start the moisture absorption operation, if it is a hair dryer, the temperature should be moderate, and the hot will also damage the mobile phone, at the same time, rice, desiccant, etc. can also be placed together with the mobile phone, through long-term moisture absorption, if the weather is good, ventilation under the sun, it is also a good way to dehumidify.

After the above 4 steps, the general iPhone water problem can be effectively solved, and if the iPhone is flooded for a long time and the water is large, then you can try the following steps:

Step 5: Disassemble the body and dehumidify! Remember not to overheat!

The first thing to do is make sure it's turned off! Then after unscrewing the screws, open the iphone phone bad calendar, and then you can see the internal parts, at this time, use a hair dryer or heat gun, adjust to the appropriate problem, do not burn the internal components of the mobile phone, wait for the dehumidification to complete, and then try to turn on the phone.

Friends who use Apple mobile phones are very clear that the water ingress of the Apple mobile phone is not within the scope of Apple's official warranty, which requires us to deal with it carefully, otherwise Apple's official mobile phone repair ** is really painful to repair, so what should I do if the Apple mobile phone is watered? The following will teach you how to deal with the water ingress of the iPhone, teach you each step of the operation in detail, and check whether there is any abnormality after the water ingress in the front circle of the Apple mobile phone.

iPhone Water Inlet Treatment Method Steps:

Step 1: Shut down the computer in time.

That's right, it's very important to shut down in time! If you still keep your phone on even when water gets into it, it's because you've wanted to change your phone for a long time. Because after the mobile phone enters the water, eddy currents will be formed, causing short circuits, and in serious cases, the mobile phone motherboard will be burned.

The correct way is to remove the phone from the water, quickly dry the water on the surface of the phone, and remember not to try to turn on the phone. Many users will subconsciously press the power button after taking out the mobile phone to see if the mobile phone can still be turned on, which is very wrong, even if the mobile phone itself is not damaged, once turned on, it may cause the result of burning the motherboard. So never turn it on!

Important things to say again

It should be reminded that after the fuselage is flooded, the squire should not shake the fuselage at will to drain the water. When it shakes like this, the water will move around under the force, causing more areas inside the phone to get wet.

Step 2: Remove moisture.

If the phone gets water, of course it will have to be removed. Shouhui can quickly wipe it with a clean towel to ensure that water does not flow into the charging port, headphone jack and other sockets. Many people will use a hair dryer to dry the inside of the mobile phone after the water enters, this method is not impossible, but it is necessary to pay attention to the way of operation, the wind temperature blown out of the hair dryer is still relatively high, which is basically equivalent to the temperature when the mobile phone is most seriously heated, the closer to the tuyere, the higher the temperature, it is not impossible to be scalded by the hair dryer, so when blowing the mobile phone, you must pay attention to the distance between the hair dryer tuyere and the mobile phone, so that the wind temperature blowing on the mobile phone is close to normal temperature.

Remember not to blow the air vent of the hair dryer directly on the phone, too high a temperature is absolutely not good for the phone.

It will stop for a while after a few minutes, and the time for the hair dryer to blow the mobile phone should not be too long, 20 minutes is basically fine. After blowing the phone, you still can't try to turn on the phone, because at this time you don't know if there is water in the phone, for the sake of insurance, you still have to do the next step, that is, dry the phone.

Take Apple 6S as an example, don't try to start the iPhone if it has a black screen in water, once it is opened, it is easy to cause the motherboard to burn, it is recommended to immediately send it to the maintenance point to clean up the water, detect and repair, and reduce losses. After the iPhone is in the water, the general treatment method:

1. Note that the first thing to do at this time is not to turn on the power, if you turn it on before, turn it off immediately.

2. Take all iPhone coverings under the code.

3. Take out the SIM card immediately and dry it, and then wrap it in paper.

4. The headphone jack, tail plug interface, and side button are blotted dry with cotton swabs or paper towels. Both places are equipped with test water labels. The test label will turn red after the self-test water intake. Water can easily remain here. But don't be afraid, you can continue to use it after carefully squirting the water.

5. Wrap the fuselage with a towel or paper towel with good water absorption to absorb the water. Don't use the method of throwing. Shaking will cause the water that has already entered the fuselage to spread, and it will come into contact with elements that cannot touch the water, causing even worse results.

6. Finally, observe the LCD screen and camera to see if there is any fog. If there is, you can wrap the body in a paper towel and put it in a sealed bag, and at the same time fill it with desiccant commonly used in snacks, drain the air as much as possible, and seal it.

7. Then put the whole set of things on your iPhone in a slightly heated place, such as an AC power supply and a heated place on your computer. Be careful not to put it in a high-heat environment, and do not use a hot air dryer to blow all the time, as this will damage the internal components. Wait until there is no fog in Zhishan Mountain, it is best to let it for another half a day, take it out, and naturally restore the room temperature; After taking these measures, if it can be used smoothly.