The problem of increasing the memory of the computer, how to expand the computer memory is not enoug

It is better to use the same brand, preferably in the same batch.

If not, it is recommended that you can choose Kingston, which has good compatibility.

It doesn't matter if the main frequency of the memory is not the same, he will automatically reduce the clock to choose.

As for the different particles you said, that's not a big deal. Again, compatibility chooses Kingston.

Your computer with this configuration, it is recommended to use the Pure Edition of Ghost in the Rain Forest Wood Wind.

OK. Preferably Samsung particles. Modern is OK, I added a strip that is modern granules, and it is no problem after using it for a few years.

At that time, the graphics card A card was better than the N card. Let's change it.

I told you about Kingston, compatibility is absolutely good, as long as you don't buy parallel goods.

Don't use the junk memory in modern times. I burned it once.

Just change the graphics card. If you look at the workmanship materials of that graphics card, it's OK if it's okay

You can add it, preferably the same strip as your original memory, so as to ensure the best compatibility.

It doesn't matter if it's different brands, the same particles can be used with confidence, and the quality and compatibility of each batch are different, so it's best to take the host to the computer city to buy a memory and try it out for 3 hours.

There are many ways to increase your computer's memory, and the common ones are as follows:

First, increase the memory module. Buy a memory module that matches your computer and find someone to install it.

Second, increase the computer's virtual memory. Right-click on the dot properties, and then tap Advanced System Settings. Under "Advanced" in the system properties, click "Advanced", and then click Advanced in "Performance Properties", and then select "Change" below. Finally, set the size of the virtual memory.

Third, increase the efficiency of your computer's memory. Monitor memory for collapsing wheel usage and release unnecessary memory.

Fourth, delete the software that is not commonly used, and often send a letter to the computer physical examination team.

Other ways to expand the computer's memory are as follows:Operating environment: Lenovo Legion Y7000, Windows10 system, settings.

1. Right-click on My Computer and select Properties.

2. Find the settings under Performance in Advanced System Settings.

3. Find Virtual Memory in Advanced in Performance Options.

4. Select the memory you want to change and click OK.

5. Restart the computer to expand the memory.

<>b.Align the memory notch with the socket bump and push the memory vertically down into the socket.

c.When the snap locks automatically, the memory is ready to be installed.

The solution to the increase in the computer's low memory is:

1. Shut down. Before dealing with any hardware inside the computer, you should always turn off the system and unplug the power cord from the wall, from the monitor cable on the back of the tower.

2. To access the inside of the system memory, remove the screws on the back of the side panel held in place in the case of the computer. Once the screws are removed, the side panel slides out effortlessly.

3. It is necessary to determine the type of memory that has been installed, how many have been in the wheel of the jujube, and if there are available slots. There are tabs, hug into memory and remove just slide the tabs and straighten out the chip. The chip tells the type as well as the scale and speed.

If you want to replace the chip, make sure you have taken the smallest chip out before replacing it with a new larger one. If there is an open slot, you can leave the existing memory installation and simply install a new chip.

4. The memory itself will only go into the slot for one-way seats. Make sure there is a correct line and push it in until you hear or feel it snap into place.

5. Run. When replacing the case, restore the power supply and optically dismantle the cable, and boot the system, you should see that the memory is automatically started to read on the screen. There is no software installed, no Zheng driver required, and no necessary modifications are configured.

The memory is plug and play and after the actual installation, there will be no need for any further installation.