-
You can click on it.
Begin. Run.
Enter "dxdiag" to check the version of the DirectX driver you are currently using. If you don't have a DX9C version, then use DX to uninstall the red slip to roll back the original DX9B and then install DX9C.
Remarks: Yes - use DX to unload the original at will, and then reload.
Entering the game said that it was not found called reinstallation, and the situation that it was reinstalled or could not be entered was because it must be used for running! Some are installed or, but there will be problems with direct overwriting and installation, so you first need to uninstall the installed or b, you can go to pchome** special uninstall software, here is the official **link.
-
It often happens when playing games, direct9 is not installed or is not supported.
-
Try reinstalling direct, or maybe the version isn't high enough.
-
Not enough graphics card! Go to the next one.,I used to run the official website to have the next!
Now you go to Huajun Sky, and other software stations should have them!
-
Go to the next one.,I used to run the official website to have the next!
Now you go to Huajun Sky, and other software stations should have them!
-
When installing, change the disk partition, just change to d or f.
-
It could be that DX isn't updated or isn't installed.
-
Yes, your 3D acceleration DX version is a little low, first of all, you can see if you are the version!
Method: Start-Run-Enter DXDIAG-OK-Tune to Display! See if you are!
This is the configuration required for the run:
By the way, I don't know if your graphics card supports this, you'd better check it online!!
If you can, then install it!!
If you still have questions, you can send me a message!!
Good luck!!
-
I guess it may be a problem with your graphics card, you go to the next and lower graphics card drivers, and go to the official website
-
There is a problem with the game, delete it, repress it.
-
hello. this is captain of running service centre of wenwen team. my pleasure to answer your question:
Falling in Calling Direct3Dcreate9" can - use DX to unload the original at will, and then reinstall it into the game and say that it is not found called reinstallation, and the situation that it is reinstalled or cannot be entered is because it must be used for running! Some are installed or, but there will be problems with direct overwriting and installation, so you first need to uninstall the installed or b, you can go to pchome** special uninstall software, here is the link.
After uninstalling it, you won't have a problem reinstalling it.
-
(Registration code: name:crsky code:6747439) using the software you can uninstall the current DX version and restore to.
Let it be used again"DirectX is unloaded at will"Upgrading is fine.
Note for this method: The uninstall may not be successful at one time, it can be tried multiple times, the uninstall is complete, and it must be ready to be installed using the software.
Method 2: Uninstall your SP2 patch and upgrade it.
You can press"Start Run by entering DXDIAG"Check your version of DirectX.
Please try the above method many times, because it took me a while to install it, really, quite a lot!
……Error Prompt 2:
If you run the game and there is a problem that reflects the conflict of the system process, it is due to the existence of viruses in the operating system, such as system files, please do anti-virus or reinstall the system.
……Error prompt 3:
Attention players with ATI graphics cards:
When executing the state, an error may occur.
This is caused by a saver, which has been resolved, as long as the ATI tray is terminated in the system process, the game will run normally.
……Error message 4
If you come across; When you have a problem with "network settings in progress", please pay attention to whether there is a firewall or something like a firewall in front of the PC machine, or play in the intranet, the reason for this problem is that some companies, or have multiple computers at home, and players who use routers or ** gateways to access the Internet cannot play the game.
Please modify the settings of the router or gateway, it is recommended to remove the rules of the firewall, because it may restrict the transmission of UDP data, resulting in such a situation.
-
At the beginning, there is a dialogue mine in the upper right corner, you just don't click on the one inside, and you can do it a little more.