The computer cannot be connected to the Internet for half a day, and the broadband connection cannot

Net Neighbor --Right-click --Properties There is a local connection and broadband connection Right-click Local Connection --- Properties -- General Internet Protocol Double-click Automatically get IP address changed to manual Fill in IP address: Subnet mask: Default gateway:

The following is selected to use the following DNS server address, and then you don't need to fill in the double-click OK The main thing that causes the slow response is that the computer automatically obtains the IP when it is turned on, but you are not connected to the Internet, he will keep getting it until it times out, and it will stop automatically until it times out, and your network connection will jump out of the online neighbor - right-click - attribute There is a local connection and broadband connection Right-click the local connection --- attribute - regular Internet protocol double-click to automatically get the IP address and change it to manual Fill in IP Address: Subnet Mask: Default Gateway:

Select the following DNS server address, and then you don't need to fill in the double-click OK The main thing that causes the slow response is that the computer automatically obtains the IP when it is turned on, but you are not connected to the Internet, he will keep getting it until it times out, and as soon as it times out, it will automatically stop, and your network connection will jump out.

The computer network switch is not turned on.

What should I do if the broadband connection on my desktop cannot be opened? Some netizens reported that when they turned on the computer and were about to surf the Internet, they suddenly found that the broadband connection could not be opened. Double-clicking on the desktop broadband connection shortcut does not respond and cannot be opened, probably due to the shortcut invalid and a problem with the driver.

Later, after repeated searches, I finally found a solution, for friends who also encountered the problem of desktop broadband connection not opening, you can take a look at the following tutorial, I hope it will help you.

Reasons and solutions for the inability to open the broadband connection on the computer desktop.

Steps. 1. If there is a shortcut key for broadband connection on the desktop, we delete it first, then right-click on the online neighbor on the desktop, in the drop-down menu, we select the [Properties] option, in the pop-up window, we will delete the [Broadband Connection], and then click the [Create a new connection] option on the left, as shown in the figure:

Then we click Next, and a shortcut to a broadband connection will be automatically created on the desktop, and then we can connect normally.

With the steps above, we've created a new broadband connection, and then we've created a new shortcut for the broadband connection.

Possible reasons why the computer broadband connection is not working:

1. Perform stand-alone dial-up, if you use a router, please temporarily disconnect the router for testing;

2. Check whether the network cable or ** cable is loose;

3. Check whether the network equipment such as modem is overheated, and try again after restarting.

4. Perform a full-disk virus scan on the computer.

This question is too general.,It's better for the landlord to say specific.,Or grab a picture and send it.,Or send the error prompt.

If you are unable to connect to the broadband issue, you can do the following:

1. Perform stand-alone dial-up, if you use a router, please temporarily disconnect the router for testing;

2. Check whether the network cable or ** cable is loose;

3. Check whether the network equipment such as modem is overheated, and try again after restarting.

4. It is recommended that you perform a full virus scan on your computer.