How to enter the one click ghost page

Isn't it possible to choose when you turn it on?

There is no harm to the computer, you can use it with confidence, and if you don't want it to start with the computer, you can change the startup item: run msconfig to remove all the ticks in the startup item, if you want to keep other boot start software, you can keep the previous tick, and it's OK to tick after restarting

The ghost system refers to the version of Ghost that is cloned in the installed operating system through Symantec Corporation, which is usually used for backup of the operating system and used for recovery when the system fails to boot normally.

One-click ghost is the first 4 versions of "DOS Home" (hard disk version, CD version, USB disk version, floppy disk version) synchronous release of the boot disk, to meet the needs of various users, can be used independently, but also can cooperate with each other.

The main functions include: one-click backup system, one-click recovery system, ghost, DOS toolbox.

Precautions for using ghost.

1.When backing up the system, it is best not to exceed 2GB for a single backup file.

2.Before backing up the system, it is best to delete some useless files to reduce the size of the ghost file. Files that are usually useless are:

Windows temp folders, IE temp folders, Windows memory swap files. These files typically take up more than 100 megabytes of hard disk space.

3.Before backing up the system, organize the destination and source disks to speed up backup.

4.Before backing up the system and restoring the system, it is a good idea to check the target and source disks and correct disk errors.

5.When restoring the system, it is best to check whether there are important files that have not been transferred to the target disk to be recovered, and do not regret it after the hard disk information is overwritten.

6.When choosing a compression ratio, it is recommended not to choose the highest compression ratio because the highest compression ratio is very time-consuming, and the compression ratio does not improve significantly.

7.After the newly installed software and hardware, it is better to remake the image file, otherwise there is a high chance that there will be some inexplicable errors after recovery.

It doesn't hurt, if you don't want it to start, just type msconfig in the runtime and remove the tick in the startup item. As for the time,This problem is more troublesome.,It's estimated that there's a place where the settings are not very good.,In the device manager.,IDE controller.,The main thing is the properties of what?,Advanced settings.。

Reinstall, reinstall, continue to install the system (the version should be replaced) until you are satisfied.