One click GHOST blurred screen, can t enter

One-click ghost isn't very easy to use, and ghost11's speed isn't very good. You go to the online ** dwarf dos toolbox to use, or directly to the next one, use one key ghost to enter the dos under manual operation, you will find that it is much faster than ghost11. Beg.

I haven't used such a way as one-click ghost.,It is recommended that you use a USB flash drive or CD-ROM to start a system like PE,And then do backup,This method is relatively simple,You don't need to consider the interaction caused by various software。

Is it on the interface of one-click ghost 2003 to enter the imitation dos to carry out one-click ghost operation.

You deserve it, one-click ghost is unstable, the server is still doing that, you're killing yourself.

As long as the system can be backed up and restored normally, the screen will be blurred.

If the system files are corrupted, reinstall the system.

It should be OK to open it with a disc

It should be hardware damage, please use the elimination method to check the hard disk, RAM and other devices such as graphics cards.

It may be a version conflict, but sometimes something happens with such hardware operation tools.

Can you enter the system? If you can enter, delete all the information about ghost.,Then install it.。

Enter the system to uninstall all of this, you uninstall and reinstall before using the optimizer or other registry optimization software to optimize the registry, because some error information is written in the registry, if you can't clean up the new version of the reinstalled will not work and conflict.

You'd better kill the virus first.

I'm using this version as well.

No problem.

I've also encountered it before, and it's caused by memory incompatibility. It is recommended that the landlord go to a professional repair shop and try to change the memory.

Thank you for adopting, and I wish you all the best in using it!

Is it this book?,If you want to go to the BIOS to change the hard disk mode of this book.,If it's a desktop.,Just change a version of the system ghost..

It's caused by the graphics card driver, and it's fine after I changed the driver!

Your motherboard is not N6100 series. Whether you are using an integrated graphics card, if so, then it is a problem with your motherboard Northbridge. Re-welding the north bridge once should be fine. If it can be used, there should be no need to engage in it (maintenance is risky, and the landlord must be cautious).

Computer screen is generally caused by hardware,First of all, the graphics card,Then memory,Finally, the power supply is insufficient,In addition to the above three aspects,It is because the graphics card and the North Bridge chip are not compatible (this point should be noted,Everything is normal when you boot up,After the welcome screen,Enter the desktop to spend,I encountered such a problem last week,It took me two days to solve it,Changed several drivers)! Check them one by one!

Do you have a hardware replacement, if you have, don't enter normally, advanced security mode deletes the driver you changed the hardware and then enters the system to drive.

Let's take a disk and reinstall the system!

If you can enter PE, it means that there is no problem with the CPU, motherboard, and memory, and if you can't see the partition, it is likely that the hard disk is broken, and you will know if you have the conditions to hang a new hard disk and try it.

If you don't have a new hard drive on hand, it's on your PE desktop.

1) Open DiskGenius, in the main interface, right-click on the hard drive on the left side that needs to be repaired 2) Select "Restore Partition Table" in its menu list, as shown in Figure 3 below) Wait for the software to finish repairing.

If you can't fix it, consider replacing the hard drive.

All four disks are dead, and according to what you said, I even wonder if there is a problem with the motherboard. You may not be able to handle it yourself, so hold the repair shop.