Find the partition table file of 80G hard disk with high score, divided into four areas, each area i

It is recommended to score. 10g 20g 20g 30g

This is the most commonly used division C drive to put too much waste

You can partition directly under the prompt of the system.

That's good, you don't need any partition masters.

With the tool, it is easy to appear that the disk display is blue and not good-looking

If the old hard disk has partitions, if you want to achieve the perfect 20G partition, first copy the files inside to other hard disks, and then install the system, delete the partitions when you choose the partitions, delete them one by one, and then re-establish the partitions, 20G to 20556

It's going to cost that tight, *********************************************==

When installing the system, divide 20G to the C disk, regardless of the rest, after the system is installed, directly at the start-》Run the input graphical interface for partitioning, simple and fast.

Just use the partition that comes with the XP system disk.

It's pretty simple. When installing the system.

Delete all the partitions.

Then re-divide it.

10g on C disc 20g on D disk

25g on the E disk, 25g on the F disk

Pay attention to the letters on the screen.

Summary. To partition a disk HDB with a capacity of 20GB and create two primary partitions, the first of which is 5GB in size, you can do this by following these steps:

This question. Partition a 20GB HDB disk and create two primary partitions, the first or primary partition is 5GB in size, you can follow the steps below:

1.Run a disk partitioning tool such as fdisk or Select the disk you want to partition to create the first primary partition: Input"n"Create a new partition.

Select"p"Create a primary partition. Enter the partition number, typically 1. Enter the starting sector, which defaults to 1.

Enter the partition size, which is 5GB in this case. Single-scrambled bits such as GB, MB, or number of sectors can be used. 4.

Create a second primary partition: Input"n"Create a new partition. Select"p"Create a primary partition.

Enter the partition number, usually 2. Enter the start sector, which defaults to the end sector of the previous partition. Enter the partition size, here is the remaining space, i.e. 20GB - 5GB = Confirm and save the partition configuration.

6.Format the partition: Use the appropriate file system tool to format the partition, such as using the Format to ext4 file system.

7.Once the partitions are complete, you can mount the two partitions and start using them.

The specific commands and steps can vary depending on the operating system and disk utility. When partitioning, be cautious and back up important data in case something unexpected happens.

Please write all the commands to partition the 20GB HDB disk (split into two types of primary partitions, the first primary partition is 5G, and the second primary partition is 15GB), format it (file system type is ext4), and mount the first partition HDB1 to the mnt HDB1 directory of Qingtong's current system. This question.

There is an extended partition, you need to use the data recovery wizard software <>, if this hard disk has a system, his partition ** type happens to be GPT again, it is impossible to keep the system, if it is <> MBR format, then use the system's disk management to compress the C disk, and then re-partition, after the partition is completed, use the data recovery wizard to change the partition into a logical partition.

1. Three partitions are described;

2. The three partitions are FAT32, NTFS, and FAT32;

3. The starting offsets of the three partitions are sector 63, sector 16386300, and sector 47102580;

4. The capacity of the three partitions is as follows: