Where is the Chevrolet Jingcheng starting solenoid valve?

1. Before installing the natural gas solenoid valve, the pipeline must be cleaned. It is recommended to install a filter in front of the valve and a trap in the steam pipe.

2. The working medium of the natural gas solenoid valve should be clean and free of particle impurities, and the dirt and filter on the surface of the solenoid valve inner part should be cleaned regularly.

3. When installing, the coil of the natural gas solenoid valve is upward, and the vertical position is maintained, and the arrow or mark on the solenoid valve should be consistent with the flow direction of the pipeline, and should not be installed in a place where there is splashing or leaking.

4. In the pipeline system, the diameter of the solenoid valve installed on the branch should be smaller than the diameter of the main pipe valve.

5. Hangzhou Hanxin Technology specializes in the sales of imported solenoid valves, in the event of a solenoid valve failure, in order to isolate the solenoid valve in time and ensure the normal operation of the system, it is best to install a bypass device.

6. The natural gas solenoid valve should not be installed in the low recess of the pipeline, so as not to hinder the operation due to the precipitation of steam condensate and impurities in the valve.

7. It cannot be used in dangerous occasions.

8. In the case of insufficient rigidity of the pipeline, it is recommended to fix the pipeline in front of the valve with a bracket to avoid vibration caused by the solenoid valve when working.

9. Before installation, pay attention to the product signage, carefully read the instruction manual, and judge whether the product meets the conditions of use.

10. Pressure gauges need to be installed on the pipeline before and after the solenoid valve to observe the pipeline pressure.

Follow the 50 line on the starter and look for the thin line.

The P0700 is a gearbox shift fault, usually due to an oil leak that causes insufficient oil pressure.

In the event of a malfunction, you can immediately go to the nearest repair shop to refill the transmission oil.

Fault code: P0011 Chinese meaning: a camshaft position actuator - timing before or system performance (group 1) English meaning:

a camshaft position - timing over-advanced or system performance (bank 1) Category: Fuel, Air or Emission Control Meaning: The role of the camshaft is to control the opening and closing of the valves.

Let you know that you can't solve it yourself, pull it over and help you deal with it.

If you are a car owner, the easiest way is to call the Chevrolet 4S shop ** and ask him to help you find it.

After removing some of the sensors, the engine must be started before the engine is lit. There are also some sensors that are removed and do not light up the fault light. Source disadvantage but will store failures down**.

Is it a separate solenoid valve?

Is the lock solenoid valve done? I have the same problem as you.

Control the camshaft to complete the valve timing. If that thing is broken, it is equivalent to the timing system when it is furnished, which affects the realization of power.

Hello, the intake and exhaust are not normal, the landlord can make a reference.

The electronic valve is broken, and it is recommended to replace it as soon as possible.

Your intake valve is the intake valve of the trouser brother, you did not explain, if the solenoid valve does not move, the reason is generally that the relay can not be pure rock engagement, you find the control circuit of the solenoid valve according to the circuit diagram, and the upper level should be a relay contact connection Qingqing. If there is nothing wrong with the relay, then look to the upper level for the contact that controls the power supply of the relay.