Why does playing PSP games show UMD read error

The landlord will encounter a request for others in the future, it is better to ask for oneself to play more psp channels and watch tutorials to ensure that you can solve this problem.

I've had a lot of problems after reading them there.

What it means in English is: your display format is not compatible with JPCSP or your monitor does not support anti-aliasing settings, you should be able to adjust the settings of these two again.

Ref. 17Don't cry in front of my grave, it will dirty my path of reincarnation!

I don't know if you still use PSP.

Just cut off the protrusion next to the back lid with scissors. It's not below to remember. Open the UND lid and you'll see it. There is a clasp on the upper right side of the umd lid.

Another is to install a umd shielding plug-in to solve it.,In this hair** will be swallowed....Search for PSP PSP3000 in the PSP PSP3000 discussion forum of the game bus and the PSP will pop up automatically"Whether or not to quit the game"The solution can be seen.

Either the bald head is dirty, find a master to take a look. Either the cable of the optical drive on the motherboard is not in good contact, just tighten it. Either the optical drive is broken, and it will be replaced by more than 200 oceans. Can I read other disks? Maybe the plate is broken....

The mobile phone code word is so tired....Hope it helps.

Either the disk is broken, or your UUDD disk is not set up well, so reset it again.

Because you don't have a boot disk, there are some games to boot that you can't be 10,000.

1. These games cannot be read directly, and need to be guided by a UMD disk.

2. If the system version is too long, you need to upgrade to a newer version. (The latest is M33-4 at the moment).

3. The machine has been used for too long, and there are too many junk files in Flash 1, please refresh Flash 1.

Wrong version? Genuine can only use the official system. If the version is incorrect, click Run and it will prompt an upgrade. Could it be that there is something wrong with UMD?

The problem with ISO is that it can't be read.

Go to the next cracked one on the Internet.

If you think it's troublesome, upgrade the system.

Is WQSG up to date?

It's useless to break the contact switch in the umd compartment directly (pay attention to the convex switch, that is, press the motor will turn the head on), if you don't want to break it, disassemble the machine and remove the optical drive cable.

Open the homebrew system and select Disable UUD in the Recovery menu

settings——system settings——umd auto-start——off

Settings - host settings + umd auto-start - off.

UMD by region! Different regions have different standards! It can't be used universally!

My 3000 is in the same situation as yours, it should be a broken head.