How to make every room have a network, how to make every room in the home network interface availabl

It depends on the environment of your current housing

Ordinary low-rise self-built houses, without steel mixing. No interference with wireless signals.

Within a radius of 15 meters, buy a domestic 3-antenna wireless router in the center to achieve full coverage.

Of course, it is also possible to buy 4,6 antennas, but 6 antennas are intended for small and medium-sized offices, ** above 200.

If it is an ordinary building, within 100 square meters, the same reason, put a 6 antenna in the living room, it can be fully covered.

If it is, duplexes, villas, extra-large floor houses, or the power of the router is not covered, or the steel bar will interfere with the signal, so that the signal cannot be connected after the corner or 3 walls (3 or more of the 5 grid of the general signal icon can be connected normally).

In this case, you need to buy two dual antennas of the same model as relays to realize the roaming between the two devices. The principle is the same as walking through a wireless base station in an urban area with a mobile phone. So the cost is also 100-150The larger the area, and so on.

The other is that brands like netgear (netgear) sell packages, a wireless router is the main device, plus AP (signal expansion), the basic package is 1+1, and the latter can be connected to up to 4. Theoretically, a 200-square-meter house upstairs and downstairs can be fully covered.

That's it.

1. Wireless router in the hall...

2. If the operator's access point is far away from the hall, you can buy a wireless router and put it in the hall as a bridge or relay.

You don't need a network cable, you need to turn on WDS

Most wireless routers now support WDS

Try to use the same brand of routing, and there may be no bridges between different brands in many cases.

3. How to bridge the router, you can see the router manual.

Wireless routers, or wireless power cats.

1. Pull the net cable, but the bright line is more ugly.

2. The ITV set-top box is connected to a wireless network card, and the wireless cat is generally given by Telecom.

3. It should be noted that the ITV set-top box can only support the specified model of wireless network card, and the specific model is forgotten to be a certain model of ZTE, so go to the business hall to see the instruction manual of the set-top box.

Installation Notes:

1. A broadband cable is connected to the wireless router, and the wireless router is then separated, so that there can be both wired and wireless Internet access. Wired Internet access is available at a fixed location on the desktop.

2. It is recommended to buy two antennas for the enhanced type.

3. The general route has 4 interfaces, 1 is used in the master bedroom, and the other 3 are used in other rooms, which should be enough, if it is not enough, you can add a switch.

The dial-up cat router, the router generally has 4 intranet interfaces, connect the network interface lines at home to it, and use the router to dial up. If there are more than 4, add switches.

Buy a router with strong penetration!

Place your router in the center of the house as much as possible!

A dual-band wireless router can be used. Yes and 5G. Then on the other hand, if you choose one with two frequencies. This will allow every house in the house to have Wi-Fi.

How to make the wireless network cover the whole home:

1. If the room has a reserved line, the wireless router can be connected to the reserved wire box (referred to as the weak current box). There is a network port corresponding to each room in the wire box. Connect all of these network ports.

Then connect the network port of the wall to a wireless router in their respective rooms.

2. Relay wireless signal. If you want to use it sometimes, don't use it sometimes, don't turn on the SSID signal. Then you can choose to route a wireless signal to relay.

3. Ceiling AP. This thing is more expensive. But it works. Basically, install one in the center corridor of the room to cover the room at home.

4. Multi-antenna routers. Although I don't think the impact is very big. But it's still a little bit of a starting point.

Avoid places with walls and place them in the center of several rooms, and a wireless router is a little better.

Summary. You can buy a router with a wireless signal amplifier so that the coverage area will be wide.

You can buy a router with a wireless signal amplifier so that the coverage area will be wide.

If the home is too large, it is recommended to use a switch. Link multiple routers for use.

Hello, how to make every room have wireless Internet at home.

You can buy a router with a wireless signal amplifier so that the coverage area will be wide.

If the home is too large, it is recommended to use a switch. Link multiple routers for use.

Is there an additional charge.

There is a fee for the equipment to be purchased.

How much is one, and do you need other expenses every month?

l You can buy a small switch, which is about 1500 yuan. You can link about 5 of them.

There is no need to pay for the equipment outside of the cost.

It's 150 yuan.

Not 1500Typo is wrong.

Is there a switch, but also a router in each room.

Yes, a network cable is also required for the link.

One network for multiple purposes, right? Yes.