Baojun 730 rear brake pad more warranty less

Not warranted. This is a consumable part. It needs to be replaced when it runs out.

Zhonglian automobile brake pad manufacturer].

The following problems should be paid attention to in the daily inspection and maintenance of brake pads: 1Brake pads should be checked every 5,000 kilometers under normal driving conditions.

In the inspection, it is necessary to measure not only the remaining thickness, but also the state of brake pad wear. Compare whether the wear degree of the brake pads on both sides is the same, whether the return is free, etc., if abnormal conditions are found, they must be dealt with immediately. 2.

Brake pads are generally composed of two parts: steel back and friction material, and you must not wait for the friction material to wear out before replacing the brake pads. Some vehicles are equipped with a braking system alarm function, and once the wear limit is reached, the instrument will alarm to prompt replacement. Brake pads that have reached the limit of use must be replaced, even if they can be used for a period of time, it will reduce the effect of braking and affect the safety of driving.

3.When replacing, it is necessary to replace the qualified brake pads produced by regular manufacturers, only in this way can the braking effect between the brake pads and the brake disc be the best and the wear is minimal. 4.

When replacing the brake pads, the brake cylinder must be pushed back with a special tool. It cannot be hard pressed back with other crowbars, which can easily cause the brake caliper guide screw to bend and make the brake pads stuck. 5.

After replacing the brake pads, be sure to step on the brakes a few times to eliminate the gap between the brake pads and the brake disc, and the brake pads need to run in for 200 kilometers to achieve the best braking effect.

The cost of brake fluid for this car is about two hundred yuan.

1. For those vehicles that run for a long time, such as taxis, etc. Generally, high-quality antifreeze is replaced once a year, and those vehicles with short operating time can be replaced every two years or every 30,000 kilometers, and the brake fluid should be changed every two years.

1. Do not mix different types and brands of brake fluid. Due to the different formulations, mixing brake fluids will cause the brake oil index to drop prematurely.

2. When the brake oil absorbs water or has impurities, it should be replaced or filtered in time, otherwise it will cause insufficient braking pressure and affect the braking effect. This is particularly important due to the generally humid weather in southern China.

3. If the vehicle travels normally for 40,000 kilometers or the brake fluid is used continuously for more than 2 years, the brake fluid is easy to prevent antifreeze leakage or drop, and it needs to be added in time.

2. Precautions for changing brake fluid.

1. If gasoline, diesel or engine oil is accidentally mixed into the braking system using synthetic brake fluid, the braking effect will also be reduced due to the incompatibility between the oils.

2. If the vehicle travels normally for 40,000 kilometers or the brake fluid is used continuously for more than 2 years, the brake fluid is easy to deteriorate due to long use, so it is necessary to pay attention to timely replacement.

3. Vehicles equipped with brake fluid level alarm devices should observe whether the alarm indicator light is shining at any time, whether the performance of the alarm sensor is good, and when the brake fluid is insufficient, it should be added in time, and the stored brake fluid should be kept between the minimum capacity scale and the highest capacity scale of the bucket comic calibration.

4. In the normal driving of the vehicle, if the brake is light and heavy, the brake oil should be replaced in time, and the brake system should be cleaned with alcohol before replacement.

5. When the vehicle brakes deviate, the braking system should be comprehensively checked. If it is found that the leather bowl of the sub-pump is too inflated, it means that there may be a problem with the quality of the brake fluid. At this time, you should choose a better quality brake fluid to replace, and replace the leather bowl at the same time.

6. When changing seasons, especially in winter, if you find that the braking effect decreases, it may be that the level of brake fluid is not suitable for the winter climate.

7. Do not mix different types and brands of brake fluid, and add specific grades of brake fluid to the Heque brake system with special requirements. Due to the different brands and different types of brake fluid formulations, mixing brake fluids can cause a decrease in brake oil properties. Even those brands that are better miscible and indicate that they can be mixed or substituted are not satisfactory in use, so do not use them for a long time.

8. When water is mixed or inhaled in the brake oil, or the brake fluid is found to have impurities or sediments, it should be replaced or carefully filtered in time, otherwise it will cause insufficient braking pressure, which will affect the braking effect.

Summary. Hello, master, if the rear brake pads of this car are not evenly run-in, the key point is to check the brake cylinder. This symptom mainly affects the brake cylinder.

The return position is not good, resulting in the brake disc and brake pads have been in a state of running-in during the driving of the vehicle. Therefore, it will lead to uneven run-in of brake pads. The treatment method needs to disassemble the brake cylinder and wish it maintenance.

Generally, the general repair shop outside is about 150 200 yuan. There is a brake disc on the top one by one, and the treatment method is that the brake pads need to be replaced.

The brake disc has a groove left and right, and the front wheels are okay, mainly the rear wheels.

Hello, master, if the rear brake pads of this car are not evenly run-in, the focus of the round pin is to check the brake cylinder. This symptom mainly affects the brake cylinder. The return position is not good, resulting in the brake disc and hall brake pads have been in a state of orange volt running-in during the driving of the vehicle.

Therefore, it will lead to uneven run-in of brake pads. The treatment method needs to disassemble the brake cylinder and wish it maintenance. Generally, the general repair shop outside is about 150 200 yuan.

There is a brake disc on the top one by one, and the treatment method is that the brake pads need to be replaced.

The main thing is that he has only run 20,000 kilometers.

There are void marks on the brake disc, mainly the quality of the brake pads, and then the uneven run-in of the rear brake pads leakage, mainly the problem of brake pounds.

Summary. During the use of the brake disc of Baojun 730, if it is not maintained or replaced for a long time, there will be wear and oxidation, resulting in obvious burrs, cracks and other traces on the surface of the brake disc. These burrs not only produce noise, but also cause safety hazards such as brake failure and longer braking distances.

Therefore, in order to ensure driving safety, it is recommended that the owner regularly check the braking system (including brake discs, brake pads and other parts), and replace or repair it in time if any abnormalities are found. At the same time, the correct driving style can also extend the life of the brake disc and avoid excessive wear and tear.

During the use of the brake disc of Baojun 730, if it is not maintained or replaced for a long time, there will be wear and oxidation, resulting in obvious burrs, cracks and other traces on the surface of the brake disc. These burrs not only produce noise, but also cause safety hazards such as brake failure and longer braking distances. Therefore, in order to ensure the safety of spine driving, it is recommended that the owner regularly check the brake system (including socks and brake discs, brake pads and other parts), and replace or repair them in time if abnormalities are found.

At the same time, the correct driving style can also extend the life of the brake disc and avoid excessive wear and tear.

Fellow, I really didn't understand, I can be more specific.

During the use of the brake disc of Baojun 730, if it is not maintained or replaced for a long time, there will be wear and oxidation, resulting in obvious burrs, cracks and other traces on the surface of the brake disc. These burrs not only produce noise, but also cause safety hazards such as brake failure and longer braking distances. Therefore, in order to ensure the safety of spine driving, it is recommended that the owner regularly check the brake system (including socks and brake discs, brake pads and other parts), and replace or repair them in time if abnormalities are found.

At the same time, the correct driving style can also extend the life of the brake disc and avoid excessive wear and tear.

Generally speaking, the life of the brake pads of the front brake is 35,000 kilometers, and the life of the rear brake pads is 6-10w kilometers, so it is recommended to check the front brake pads every 30,000 kilometers.

The thickness of the new brake pad is generally about that, with the daily friction loss, when the naked eye observes that the thickness of the brake pad is only 1 3 brand new, it is necessary to increase the frequency of inspection, and be ready to replace the new brake pad at any time. There will be small raised signs on both sides of the brake pads, and when the brake pads are level with it (2-3mm), it means that it has reached the limit and must be replaced.