Guitar restrings, tuning problems? 100

Updated on amusement 2024-04-07
11 answers
  1. Anonymous users2024-02-07

    The new strings are softer than the old strings, so it may be because the strings have become softer. It is also possible that you removed all the old strings at once when you were winding, causing the neck tension to suddenly become smaller and the neck to bend. Someone downstairs explained how to adjust the neck, if the new strings are soft, you can see the effect in a few days, and if you still play the product, you can directly raise the pillow

  2. Anonymous users2024-02-06

    I don't quite understand what the landlord means, the landlord may have too little experience in winding, and the extra part of the string can be cut off, for example, the landlord's string in the picture should not be wound so many turns at all (2-4 turns are enough).

    The owner tries to straighten the strings and wrap them around the pins. 1 string is thinner, you can make a few more turns (e.g. 5 turns), and then pass your head through the string shaft from above the winding string. Then rotate the pins until the strings are tight, and a more solid sound can be played.

    We found that in this process, the strings that were not very tight just now were already very tightly attached to the shaft, and even many more turns, and the remaining excess parts could be cut off for aesthetic reasons. The string is long enough that you don't have to fit the whole string just right!

    After the strings are finished, you can get a tuner to calibrate the piano, and it will be more convenient if you can listen.

    I don't know if the landlord is satisfied.

  3. Anonymous users2024-02-05

    If you don't play the frets before, you loosen the strings and then retune the strings to play the frets, which means that you haven't tuned to the standard pitch, you'd better follow a song that you know what key it is to play, and you will know if it has been tuned to the standard tone, such as "Ten Years" The song is in the key of G, that is, the guitar standard tone The third string empty string is the 1st tone of this song, you know the 1st tone, and the other tones of the song are confirmed through the relationship between chromatic and full tones, so if you play a different pitch from this song, it means that your guitar has not been tuned to the standard tone, I wonder how you tune the strings?

  4. Anonymous users2024-02-04

    Auditory problems, because the condition of sound is vibration, and the string is loose and the sound is the same as the sound produced when the string is tight at the beginning, which is impossible [the frequency of vibration is not the same].

    Therefore, it is recommended that you take the piano to a professional or piano shop to find someone to help.

  5. Anonymous users2024-02-03

    It's when you loosen the hyun, because the neck is not the pull of the six hyuns, and it is bent, you need to tune the neck, there is an inner hex screw in the resonance box, use it to tune the neck, tune slowly, and the rotation amplitude should not be too large! I wish you success.

  6. Anonymous users2024-02-02

    It has nothing to do with the remaining length. Is the string wrong? One out of 2, two out of 3 like that?

  7. Anonymous users2024-02-01

    Find the nearest piano shop It's hard to tell.

  8. Anonymous users2024-01-31

    Find an effect with tuning.

  9. Anonymous users2024-01-30

    Find a professional piano shop, you absolutely can't solve it yourself.

  10. Anonymous users2024-01-29

    The correct way to change guitar strings is as follows:

    1. The string plug has a groin, and the string passes through here. At one end of the string is a metal bean, which I call here the string bean. If the plug is removed, the bean should be able to pass through the hole where the plug is located (the hole in the bridge) into the body, then put the plug back into the hole in the bridge, with the groove facing the string, and put the other end of the string through the hole in the headstock, and wrap it around the knob.

    2. Tighten the string knob, pay attention to pressing the string plug with one hand during the twisting process, so as not to be pulled out of the piano body, at this time, the string bean is fixed in the piano body by the string plug, the tighter the string and the chord plug itself are fixed. If the metal bean can't be inserted through the bridge hole, the other end of the string must be threaded out of the sound hole from the inside out, so that the string bean can also be left in the body.

    3. Pay attention to the tightness of the string when changing the string, if it is too tight, even if you change it, it will break if you put it there, if you want to solve this problem, you will buy a string, this time with a hole of a 6-hole timpani, or hold down the **c 3 tone of a piano. It's the sound of the first string of the guitar, and it's in contrast to the tone played on the guitar.

    4. It is to tune the first string, when the second string is tuned, play the 5th fret of the second string, and by the way, play the empty string sound of the first string, if you want to be the same, you can do it, when you tune the third string, play the 5th fret of the third string, and by the way, play the empty string of the second string, if you want to be the same, you can play the 5th fret of the third string when you tune the fourth string, and by the way, play the empty string sound of the third string, if you want to be the same, just do it, and push it down like this.

    5. Remove the old strings, put them in and press them moderately to start with the thickest strings and start with the new strings, first on the thickest one: use the string reel to replace a new string, use the diagonal clamp to cut off the end of the leader, stuff the strings into the fixing hole on the bridge, lock the six-pin screws, do not cut the other end first, thread the headstock knob, measure the length, and pull the string up at the 12th fret to a distance of 3-5 cm from the fretboard.

    6. Wrap the string in the counterclockwise direction on the knob post and then penetrate it into the hole, the knob is tightened in the counterclockwise direction of the string winder, and the string on the string button should have 3 to 4 turns, from top to bottom. Use an electronic tuner to tune to the correct tone firstChange the B string, change the back tuning, and tune the two strings to the correct note.

    Benefits of learning guitar:

    1. Regulate the body and mind, maintain mental health, in today's era, we pay attention to the crises around us everywhere, and it seems that we can't stop enjoying life. When work is the most intense and busy, picking up a guitar and playing a song freely can be regarded as a good prescription for busy life. The body and mind need to be regulated, and the tense nerves can be relieved by **, which is the greatest value of the guitar.

    2. Improve self-cultivation, enjoyment, and good literacy is the best embodiment of a person's aesthetic taste. The guitar can help you exercise a good sense of musicality and aesthetics, so as to improve your artistic accomplishment, a simple instrument, and a beautiful instrument that allows us to enjoy the joy of life.

  11. Anonymous users2024-01-28

    First of all, an idea. The C chord in C key is a C chord in any key, in G key. It says that the C (chord) is still the same and does not have to be changed.

    To speak in your way, it must be said;

    The main chord in C is C, and when it comes to G, the main chord becomes G, and the method is different, which is correct.

    Sing in a fixed key.

    The inner sound of c is do, mi, sol and the notation is 135

    The inner sound of g is sol, si, re, and the score is 572

    The calculation method uses the name of the sound, and what chord is calculated by using that chord as the root note, such as fm, which is f (root note) + a (minor third) + c (pure fifth) (you see, so you have to learn the interval first).

    Major second = 2 semitones, minor third = 3 semitones, major third = 4, pure fourth = 5, pure fifth = 7

    c cd def fg ga ab, each note is a semitone (minor second).

    After the calculation, it can be converted with a fixed key singing method, and then recorded with a simple score.

    As for the calculation formula of the chord, and all kinds of three chords, 7 chords, increase and decrease You can check it on the Internet, or you can find it if you buy a book, I won't explain them one by one here, because it's too tm!

Related questions
3 answers2024-04-07

The first thing to do is to remove the strings: insert the winder into the twist and turn it by grasping the handle until the strings come loose. (If you don't have a stringer, you can only twist the piano slowly by hand). >>>More

7 answers2024-04-07

Method. 1. Use the guitar tuning flute to calibrate the six open strings, blow the tuning flute E tone, tune the first string to the empty tone, blow the B tone, tune the second string, and so on. >>>More

12 answers2024-04-07

Use the guitar tuning flute to calibrate the six open strings, blow the flute E tone, tune the first string to the empty tone, blow the B tone, tune the second string, and so on. Use the tone * or the A note of the harmonica or piano (6) to tune the open string of the fifth string of the guitar or the fifth A note of the first string. Then use this string as the standard tone to align the other strings. >>>More

9 answers2024-04-07

Here's a lot of introductions on the Internet.

11 answers2024-04-07

A few points to note when strumming:

1.When strumming the string, the movement of the right hand should be dominated by the wrist, and the forearm of the right hand is driven by the wave of the wrist. >>>More