I was anxious about how to separate the metal enclosure of the IBM X60 keyboard from the entire keyb

Dizzy, don't dismantle it. Just run dry!

What to do if your laptop gets into water.

Everyone must be very anxious after the laptop enters the water, the light is not working properly, or the circuit is short-circuited and burned out before the power supply is unplugged, so that the hard-earned "book" is scrapped. So what should you do when the book gets into the water? What is the contingency?

Let's talk about this problem that everyone may encounter.

First of all, remember that no matter what program you are running, no matter who you are chatting with, once the laptop gets water, you should immediately unplug the power plug, remove the battery, and not use it to shut down properly, then it will be too late, immediately turn the laptop upside down, let most of the water flow out first, and then find some absorbent paper to suck the water outside the laptop first, and wait for further processing. Don't take chances and think that it doesn't matter, even if there is no problem now, then maybe one day the problem will come to you, and then it will be too late to regret it.

Generally speaking, most of the parts of the advanced water are keyboards, and the possibility of water entering the LCD screen is not very large. If too much water enters, it may flow down the keyboard to the motherboard. The next thing we do is to find a suitable screwdriver and other tools to disassemble the laptop for further inspection.

The structure of different models of notebooks is similar, first remove the keyboard, observe carefully, and only need to twist a few screws. If there is water, you can first use absorbent paper to blot the water, and then use a medical cotton ball dipped in anhydrous alcohol (do not use the hospital ** puncture and disinfection, which is 75% diluted with water) to gently wipe the circuit board, if it does not work once, you can wipe it 2-3 times repeatedly. You must not use clean water, because no matter what kind of water it contains, it contains certain chemicals, and after a long time, it will corrode the motherboard, and it will also make the laptop scrapped.

Because anhydrous alcohol is fully volatile, it is better to let it dry naturally after wiping. After such treatment, generally speaking, there will be no more problems, this is only what we can do under amateur conditions, if you are still a little uneasy, you can go to a special maintenance station, clean with an ultrasonic cleaner, so that the cleaning effect will be more thorough.

If it's x60, you don't have to open it.,Now IBM's keyboards are spill-proof keyboards.,I'm not afraid of water.,We've done experiments.,A glass of water is poured into it (of course, it's a shutdown state),The drainage hole at the bottom of the machine will drain the water.,But it's best to take a hot hair dryer and blow it well.,And then dry it before using it.,Don't worry.,If you're really IBM, there's no problem.。

The keyboard of the IBM book cannot be disassembled! It can be disassembled, but it can't be installed. If you can use it, use it first, and if you can't, just change it to a new one.

You can reinstall the hotkey driver to try, if it still doesn't work, it should be a hardware problem.

Then it's okay if you don't connect the AC power.

If you are in the insurance, you can wait for it directly, and if you can't get it, you can directly change to a new keyboard, how good!

By the way, let them do a full check-up, haha.

It is recommended that you contact the seller for consultation. Sometimes they won't suggest it, but it's up to them.

It's a matter of driving.

Go to Lenovo**.

It's okay, the driver is not installed, uninstall it and then install it, PS is not a one-click recovery?

You didn't have a sound card, did you? Drop the sound card and try it!

A machine that looks exactly the same.

Do you say that you can change it, and now you are wary of the fake SE of 5S shell