Seek help! ZTE V880 flashing problem A few days ago, I flashed a rom with a flashing wizard, I don t

Children's shoes, not menu, it's home+volume+plus the power button,Three have been pressed for eight to ten seconds。

The upstairs method can be used.,There's another one.,That's the official package you used before.,Unzip the file and put it in the image folder of the memory card.,And then use your method to mean plus volume + add the boot key.,Try.,Good luck.。

Method: <>

2.Turn off the mobile phone, press [Home] + Volume Down + [Power Button] to enter fastboot mode, the interface will display the first screen of boot (W0 logo). Plug in the data cable when you are in the wo interface,At this time, the XP system will prompt you to install the driver,Specify the driver as the XP driver just now。

4.After double-clicking, it will be taught step by step.

Follow the prompts to press any key next.

Follow the prompts to press any key next.

Follow the prompts to press any key next.

The last two pictures are the same.,The latter one is proof of success.,After pressing any key, it will enter the mobile phone system.

<>5.The above tutorial is to flash into Chinese recovery, this is only the first step of flashing.

Flashing Steps:

Put your favorite flash pack in the root directory of your SD card (or anywhere on an SD card you find).

Turn off the phone, press the [Volume Up Button] + [Home Button] + [Power Button] at the same time. About 5 seconds to let go!

After the second part is successful, the mobile phone will enter the following interface, as shown in the figure [If you don't enter this interface, either the mobile phone enters the system, or you press the wrong one, and the mobile phone is turned off at this time. If the machine can't be turned off, directly deduct the battery and then press the second part to operate].

In this meeting of the operation method [volume up, down key up and down, small house key OK].

Select the two items in the ** below [Flash the machine later.] Also try to choose these two items] Note that after emptying, the phone can't enter the system before the ROM is flashed! Because the original system has been emptied!

Once you're in, choose the second one! Then find the flashing package inside your SD card, press the [Home] button to start flashing!

Once you've waited for the prompt to finish, press your phone's back button and select the first option (restart your phone now)! At this time, the phone will restart!

Then don't worry about it.,The first time you enter the system, it's going to be slow.,About 2-3 minutes (this time depends on the difference in the flashing package).

Oh Xiaobai's words will be the next flash wizard,One-click flashing is very simple,There is a v880 rom on it

All you need is two software, one of your favorite flashing packs! First of all, the next one-click root software in the Anzhi market requires permanent root permissions. Then in the next firmware manager, first flash that what recovery, then just select install from the memory card, find your flash package, and then confirm.

Then just wait! If it is stuck on the home page of the boot and does not move, then take off the board and reboot it! The main reason for getting stuck is due to the fact that you don't get permanent root!

I hope this is useful to you, and that's how I learned it step by step! Do it yourself, why bother to find someone else to brush the machine!!

It's fairly simple to use the Flash Wizard, but remember to back it up first.

You can check out the Android forum, where there are a lot of flashing tutorials and a lot of good ROMs.