How do I get two local connections in my network connection?

Did you add any hardware?

I added an IEEE-1394 card to the PCI, and I had an extra 1394 connection in the online neighborhood.

1. First, right-click on the computer and select the "Device" option.

2. Then in the pop-up window, right-click on the PC and select "Add Obsolete Hardware" to open.

3. Then in the pop-up window, click "Next" in the lower right corner.

4. Then click on the option "Install the hardware I manually selected from the list" in the pop-up window to proceed to the next step.

5. Then in the interface that appears, click on "Network Adapter" and click Next.

6. Then select the corresponding network adapter, [Manufacturer]: Select Microsoft [Network Adapter]: Select Microsoft Loopback Adapter, click Next, and you're done.

1.First, set the IP DNS to automatically obtain IP2The problem described by the landlord should be like this: When you search outside the ap becomes the default, go home with not the default so you can't connect, because the default will automatically connect. Solution:

A: If it is an XP system: Start - Settings - There is a wireless network below - Open the right-click properties - There is the default AP number to delete in the options. Are you sure. Double-click the wireless network in the lower right corner, select the AP number you added, enter the password, and connect OK!

b:Win7 system starts to set up a network in it.。 In the upper left corner, there is an Advanced Network Adapter selected and clicked, and the Local-Right-Click Properties option Delete Default OK and then reconnect to the wireless APs on both sides of the home!

Finally, I wish the landlord all the best!

Disable redundant local connections

In fact, it is much easier to achieve full interoperability between the two networks.

1. First of all, you need to buy a router, which is very cheap, usually dozens to a hundred.

2. Let's assume that the network segment of network A is, the network segment of network B is, the router address is, the HTTP server of A is set, and the HTTP server address of B is set.

3. Connect the networks of the two network segments through the router Minzhi, and access the switches of the two networks, network A --- router --- network B (note that it cannot be plugged into the WAN port of the router Sun).

Access the router through the machine on network B, find the routing table in it, and add a routing table

ip: Subnet Mask: Gateway is set to:

After saving and exiting, set the subnet mask of all machines in the LAN to and the gateway to .

4. Try to pass.

Or access try If there is a modem with a route, then take the scatter to achieve the above functions, the connection is a little different, it should be:

The modem --- network A--- network B or connected to network B, and other settings are the same as routers.

If the FTP server is the same, you don't need to set it, if not, please set it to.

If you want two networks to interconnect, you only need to change the server IP address to the IP of the original network segment, and then change the routing table to the following:

Generally, there will be a table in the router.

If you don't have the above table, please add it!