Does Subaru burn engine oil? Do Subaru Foresters burn engine oil?

Hello as far as Japanese cars are concerned, burning engine oil is a normal phenomenon, Subaru is no exception, burning engine oil is mainly when the engine is working, a small part of the oil on the cylinder wall will burn, this amount is very small, and belongs to normal consumption, but it is also necessary to evaluate according to the condition of the car, always pay attention to check the consumption of refueling frequently, if the consumption is serious, then you need to be vigilant, if the engine runs to a certain time, due to the wear of cylinders, pistons and rings, a large amount of oil will occur, At this point, the engine needs to be repaired and restored.

When the engine is running, the oil applied to the cylinder wall will be burned off in very small amounts, which is normal oil consumption. Usually you should pay attention to check the height of the oil level, and replenish it in time when you find that it is insufficient.

After the engine runs for a certain period of time, due to the wear of cylinders, pistons and rings, a large amount of oil will be burned, and the engine needs to be repaired and restored.

This is a process common to all reciprocating engines. Subaru is no exception.

The general solution to burning engine oil is to overhaul the engine, which is more troublesome and expensive, and I didn't do it because I thought it was a little worthless. Replace it with imported G T Magic Red engine oil, this oil is of good quality, it is the base oil of four types of PAO, even if there is a burning of engine oil, it will not produce so much carbon deposits, it has a good impact on the power of the engine, and at the same time can protect the engine well, and the power increase is also good, which is a better solution.

This situation is to burn the oil, the general solution is to overhaul, but too troublesome, I did not do, with the imported G T magic red oil, the quality is very good, is the base oil of the four types of PAO, even if there is a burning oil situation will not produce any carbon deposits, the power image of the engine is small, can protect the engine well, now although the car still has the problem of burning oil, but the power is good, the car is normal to drive no problem.

If you want to completely solve the problem of burning engine oil, you can only overhaul it, but it is relatively troublesome and the cost is not low. Now I use imported G T magic red engine oil, the quality of this oil is very good, it is the base oil of four types of PAO, the quality is very good, even if there is a burning engine oil, it will not produce a lot of carbon deposits, it will not affect the power of the engine, the power improvement is also good, the car is very smooth, as long as the liquid level is checked at any time, it is not too low, and there is no problem with normal driving.

There are the following solutions:

First, if the burning of engine oil is serious, it can only be solved by overhauling, and the burning of engine oil is the gap between the piston ring and the cylinder wall.

The crankcase lubricating oil cannot be sealed, resulting in serious oil consumption in the vehicle, and the cylinder liner and piston ring need to be replaced, that is, overhauled.

Second, if the oil consumption is slow, you can use the channeling ring, that is, to replace the piston ring, under normal circumstances, the wear consumption of the piston ring will be higher than the cylinder wall, so when the oil is not serious, you can replace the piston ring to repair.

3. If the oil consumption is low and there is no time to deal with it, you can add oil essence to reduce the consumption of oil, and the specific operation steps are as follows

1. Open the oil cap.

2. Pour the oil essence into a small cup.

3. Open the engine compartment cover.

4. Add oil essence to the oil filler.

5. Screw on the oil filling port cap and it is completed.

Subaru Forester burns engine oil very sure that the piston rings are stuck

However, it is necessary to check whether there is a problem with the exhaust valve, whether there is a problem with the exhaust valve, whether there is a cylinder wall Chachala cylinder, and there is a serious cylinder without overhauling the engine, as long as the piston ring is repaired and released, because it is a horizontally opposed engine, the repair agent of the oil model and the fuel model will be repaired together and will soon be released, and the oil will not be burned later.

The main reason for piston ring stagnation

In fact, the treatment principle of piston ring stagnation should start from the oil circuit, the reason for the stagnation is the beginning of the oil circuit, the oil bearing temperature is 110 degrees, and the high temperature caused by the long-term unclean oil circuit makes the oil at a temperature of 120 degrees or higher for a long time, so that the oil will be exhausted in advance, the small hole of the oil ring is very small, and the oil inside will be dried and scabbed for a long time, and a cylinder stuck is 5000 kilometers of a liter of oil, at this time, the working conditions of other cylinders will also begin to be bad, and soon the 4 cylinders will be stuck. It becomes a liter of engine oil for 1000 kilometers or even hundreds of kilometers. Therefore, in order to solve the problem, we must start from the root oil circuit, which is the way to remove the root.

Solution

The company has a piston ring release oil and fuel used together to solve the problem, provided that the accessories are indeed not faulty.

The company has a general teaching you how to prevent burning engine oil to find the link.

The phenomenon of subaru foresters burning engine oil is a common problem, and some cars will burn a little engine oil, but maybe it depends on the character. I also use a forester, this car is very reliable in quality, sometimes there is a little problem, which is also normal, and this car has high requirements for engine oil. At present, I have been using GT engine oil, I feel that there is no phenomenon of burning engine oil, burning engine oil actually has a lot to do with the viscosity of engine oil, so you must be cautious when choosing engine oil, choose a higher quality engine oil.

There are several main conditions that can cause engine oil to burn:

1. The valve oil seal fails, and the oil participates in combustion after entering the combustion chamber by the valve oil seal, and the phenomenon is that when the cold car starts, blue smoke is emitted at the muffler. When the hot car state is reached, the phenomenon is significantly reduced. It is recommended to replace the valve seals with new ones. This case has the lowest repair cost.

2. The piston ring is worn out of tolerance, and the piston ring loses its due elasticity and tightness, and the excess oil in the cylinder barrel cannot be scraped off, which will be produced at the same time"Lower exhaust".Whether it's a hot or cold car, blue smoke will come out of the muffler. And you will find that there is a significant consumption of oil.

It is advisable to replace the cylinder barrel with a new piston ring after ensuring that the cylinder barrel is within the standard wear range.

3.The wear of the cylinder barrel is out of tolerance, and the phenomenon is the same as above. The main reason is that the roundness in the cylinder barrel and the size of the piston top dead center are out of tolerance, and at this step, only changing the piston ring can not solve the problemYou need to go to the boring shop to do the boring cylinder treatment, that is, overhaul.

Go to the 4S shop to find maintenance, and spend money to enjoy after-sales.

Don't buy a turbine car if you don't want to burn oil.

The engine overhaul was replaced ......

Causes of burning engine oil and how to prevent it.

The engine oil itself has a certain amount of consumption, and excessive consumption is the problem of burning engine oil. There are many factors that affect the burning of engine oil, such as: fuel quality, driving conditions, driving habits, maintenance habits, etc., the following reasons will aggravate the oil consumption and cause the burning of engine oil, so that the vehicle appears:

1. Carbon deposition occurs in the combustion chamber, which makes the gas ring of the piston ring stuck, and the sealing is poor.

2. Oil sludge is generated in the lubrication system, and the oil sludge blocks the oil return hole of the oil ring and weakens the oil scraping performance.

3. Wear occurs between the piston and the cylinder wall.

4. The valve seal is corroded and aging, and the sealing performance fails.

In addition, cars now have crankcase ventilation systems (exhaust valves), which can also exacerbate oil consumption if there is a problem.

Burning engine oil means that the engine oil enters the combustion chamber of the engine and participates in the combustion along with the mixture. The phenomenon of "burning engine oil" in the vehicle will damage the vehicle's oxygen sensor too quickly, resulting in an increase in carbon deposition in the combustion chamber, unstable idling, weak acceleration, increased fuel consumption, and excessive exhaust emissions.

Precautionary measures for burning engine oil:

1. Use high-quality engine oil

Engine oil is very easy to corrode and age in a long-term high temperature state, resulting in the oil film becoming thinner, and it is easier to escape to the combustion chamber to participate in combustion, so the use of high-quality engine oil can greatly delay this phenomenon.

2. Pay attention to the cleanliness of the fuel circuit

Fuel in the combustion process is indispensable to produce carbon deposits, and carbon deposits are the root cause of some car failures, such as the aging of valve seals, piston wall clearance, etc., all have a direct or indirect relationship with the formation of carbon deposits, considering the relationship between domestic oil products, it is necessary to use high-quality engine oil and (PNF) fuel additives to achieve, which is also the key to achieve no dismantling and repair to solve the problem of burning engine oil.

Audi burning engine oil is a problem of the engine itself, and it has nothing to do with engine oil, and the use of engine oil can not improve this problem, so it can only be said that the maintenance effect of better quality engine oil will be relatively better. My car burns engine oil for more than a year, all of which are continued with imported red engine oil, the quality of the engine oil is very good, it is the base oil of four types of PAO, the engine oil has no impurities, even if there is a case of burning engine oil, it will not produce carbon deposits, and the power of the engine is small, and the liquid molybdenum component in the engine oil can improve the engine power very well, reduce power loss, the car is almost the same as when the oil is not burned, pay attention to check the liquid level, and add less on the line.

The car burns engine oil is the problem of the engine, it is caused by the damage of the internal parts of the engine, but some of the oil produces less carbon deposits, which has little impact on the power of the engine, I am now using imported G T magic red engine oil, four types of PAO base oil, the quality is very good, even if there is a situation of burning engine oil, it will not have much impact on the engine, the liquid molybdenum composition of this oil has a good molecular structure, anti-wear protection, improve power, reduce fuel consumption, my car is Audi A3, Although there is still a situation of burning engine oil with this oil, the power is very good, and there is no problem with the car driving.

Generally, the car burns engine oil seriously, it is necessary to overhaul the solution, but the cost is indeed relatively high, my car burns engine oil for almost a year, all of them are continued with engine oil, before using the original engine oil is not good, it was replaced by imported G T magic red engine oil, four types of PAO base oil, the oil quality is very good, will not produce so much carbon deposits, and at the same time the protection of the engine and power improvement are very good, the car is not too much of a problem, and now the amount of oil burned is basically stable.

Hello, the engine fuel consumption is high, it is recommended that you go to the repair shop to check whether there is a problem with the engine sensor, and at the same time check whether the power of the engine has decreased.

Hello. The engine burns oil.

The words are mainly due to the engine.

Piston ring. The gap is too large, or.

Valve oil seals. Damage, in this case, it is recommended that you go to the repair shop as soon as possible to do a comprehensive inspection, and then the repair can be done.

Thanks for using and hope mine can help you!

If you don't understand something, feel free to ask, and I will give you a satisfactory answer!

Subaru has the phenomenon of burning engine oil, overhaul is really not worth it, I am now using imported G T magic red engine oil, the quality of this oil is very good, it is the base oil of four types of PAO, the quality is very good, even if there is a case of burning engine oil, it will not produce a lot of carbon deposits, it will not affect the power of the engine, the power improvement is also good, the car is very smooth, as long as the liquid level is checked at any time, it is not too low, and there is no problem with normal driving.

There are two ways to deal with burning oil, the first is the most fundamental way, which will be recommended by 4S shops, engine overhaul, but the cost is high, it takes a long time, and the warranty is not necessarily good; The second is the most popular method: check the oil level in time, add less oil, I have been adding it like this for more than a year, using G T magic red, good quality, less carbon deposit, power improvement can also be, and when the oil is not burned.

Audi has a lot of problems with burning engine oil, the common problem of this engine, with a better quality oil can not be improved, but a better quality oil is more comfortable to drive, now used G T magic red engine oil, four types of PAO base oil, the quality is very good, even if there is a case of burning engine oil, it will not produce carbon deposits, will not affect the engine power, and the liquid molybdenum composition of the engine oil has a good molecular structure, anti-wear protection, improve power, reduce fuel consumption, Although my car still burns the engine oil, the power is very good, and there is no problem with the car driving.

You can see for yourself! Open the air filter shell, the air intake chamber, and see if there is any oil, and then see if there is oil at the throttle! Let's check it out! It won't be a slight pull! There is generally no problem with the valve seal, hit the cylinder pressure!

I don't know how much you've run, change the ring, change the ring won't protect you, if it doesn't work, overhaul it.