The water drop wheel line cup must be on the full line to be thrown?

Not necessarily. But not too little, not too full.

In general, it is best to go on the line to the bottom of the cup along 2 to 3 mm. Not too much, of course, a little less.

In fact, it is a lot worse than the full line cup, and it doesn't matter, as long as the upper line is long enough, enough distance for you to throw, and there is still a certain amount of remaining line. There are few line cups, but it has some effect on the throwing distance. If there are fewer lines, you can use some nylon threads and carbon threads at the bottom of the cup to solve the problem, and in case of big fish and more lines, nylon or carbon threads can also come in handy.

If it's too full, it's easy to blow up the line.

The less the drop line, the better the throwing, and if the first line is less, the total weight of the line cup is light, and the throwing resistance is relatively small. Second, if there are a lot of lines, the line layer will be thicker, the thicker the line layer, the softer it is, the softer the upper line is easier to slightly stick to the lower line when closing the line, and the stronger the sticky, the greater the resistance when throwing the line. So the less the line, the farther it is thrown!

But the line is for fishing, and the less the line is under the reasonable demand of the target fish and the cast, the better.

Give yourself an accurate location of your water droplets. For example, the same eight-gear brake, the high-end wheel can also throw a more ideal distance while gaining sufficient braking power, otherwise it is possible to throw the bait because the brake is too large, and it will be directly smashed at close range to cause fried powder. Of course, this does not mean that the water droplets that are almost unusable, but that you can't blindly copy the experience, but you must have a clear understanding of your own equipment and use it reasonably.

2.Pay attention to the choice of bait. If it is a headwind, 18 grams of wave climb may not be as far as 12 grams of oblique cut, because the former has a large wind resistance, offsetting its weight advantage, but it is easy to fry powder.

3.The bait should be at the right distance from the tip of the rod. For beginners, try to control it as short as possible to make the transmission of force faster and more concentrated. Of course, this is based on the premise that there is no damage to the tip of the rod.

4.Take advantage of the elasticity of the tip of the rod to pop the bait out, rather than throwing it out by the arm and shaft, which is easier to fry.

5.When throwing the rod, the force can be large, but not violent, and the acceleration is too fast, which is easy to make the spool obtain too high muzzle velocity and cause frying.

6.Be good at using your thumb. In addition to the thumb can hold the wire cup when the bait falls into the water, it can also rely on the friction between it and the wire cup to control the speed during the whole throwing process, which may affect the throwing distance at the beginning, but can greatly reduce the probability of frying noodles.

7.Personally, I think it is better to choose a thinner nylon thread to practice, after all, the memory and cost of the thread also have to be considered.

1. It is best to use a cheap nylon fishing line when practicing throwing with a gun handle rod and a water drop wheel, so that even if the "fried powder" cannot be solved in the end, it will not be distressed. 2. First of all, after installing the fishing group, you must first debug the drop wheel, when I practice, I first adjust the magnetic brake to the maximum, use about 10 grams of bait, the lure rod is perpendicular to the ground, press the outlet switch, repeatedly debug the fine-tuning knob, find the bait after the landing of the line shaft stop, and do not reverse the best strength.

3. Throwing from above: Put the tip of the rod at 90 degrees behind you and throw it forward to the 10 o'clock position. 4. Practice from near to far, which can reduce the probability of "fried noodles" and find the feeling of throwing.

The first step is to press the pay-off button on the wheel, adjust the magnetic brake to the maximum, and adjust the bait to a position about 20 to 30 cm from the tip of the rod. Press your thumb lightly on the reel and prepare for the throwing action.

In the second step, the side rod throwing method is adopted. Throw from three o'clock to nine o'clock; or from two o'clock to eight o'clock; When Lua is about to fall into the water, press and hold the bobbin with your thumb to stop the line and brake in time, whether the brake is timely or not is the key to controlling the fried noodles, remember! The reason for the so-called fried noodles is mainly because Lua has fallen into the water, but the reel is still rotating rapidly, causing chaos or fried lines.

Only by braking in time at the moment when the bait falls into the water can you prevent frying powder. As long as you can't stop the car, you will definitely fry.

1. Don't throw away when you start practicing, as long as you can throw it smoothly, not frying powder is a victory for newcomers.

2. When novices are practicing, it is recommended to choose about 10 to 15 grams to practice throwing rods.

3. After a period of practice, generally after one or two hours, you can gradually increase the intensity of the rod throwing, so that your trillion liquid lure will be from near to far, and you will throw it farther and farther! After practicing throwing far, then practice throwing accurately, practicing throwing accuracy is a clever job, that is, to control the strength, but also to control the direction and the angle of the line, only repeated practice will achieve the effect of pointing where to hit.

Personal summary of 5 drop wheel throwing skills.

1. The wire cup winding should not be too full, about 2 3 or so.

2. Adjust and fine-tune mechanically first, and re-adjust mechanically every time you replace the bait of different weights, and mechanically fine-tune until the bait slowly falls.

3. Adjust the brakes again, adjust the magnetic force or centrifugal force to the maximum (if it is a double brake, all of them are adjusted to the maximum), and then slowly adjust the decrease if it does not explode, so that you can throw it farther.

4. The star-shaped force relief wrench should be adjusted well, and the unloading force is very critical when the fish is in the middle, especially for medium and large fish, I personally like to adjust the strength of about 2 catties.

5. Don't throw violently, so it's easy to blow up the line, and when the bait is about to fall into the water, hold down the line cup to prevent the line from being blown up, and practice throwing more to achieve the ability to flexibly control the line cup with your thumb, which is very effective in preventing the line from being blown up.

Abu Pmax's water droplets magnetic brakes have a total of 10 gears Can Brother Longdi elaborate on what weight Lua should adjust to several gears?

I'm on the same wheel as you and have the same problem. Not far away!

The mechanical and magnetic (centrifugal) brakes are adjusted tighter, and then the moment you stare at the moment when the lure enters the water, press the wire cup with your thumbThere is also the "rubbing cup" ("rubbing the line").

For anglers who play lure, especially those who are new to lure, the most troublesome thing when using the drop wheel is to drop the frying line. Especially when you have a lot of fun, blowing up the line once will affect your mood and delay time.

The reason for the frying of the line is that the speed of the line cup exceeds the flight speed of the fake 360 quiz bait, or the line cup is still rotating after the fake bait stops entering the water.

So in order to avoid this kind of situation, some anglers (such as the bastard brother who is new to Lua) will use two methods to solve it. One is to adjust the mechanical and magnetic (centrifugal) brakes tighter, and the other is to stare at the moment when the fake bait enters the water and press the wire cup with your thumb.

However, this method has limitations, and the first micro check level can not completely eliminate the fried line, improper strength or pressing the line cup is not timely, and the same fried line is doubtful life. Second, these methods will greatly affect the throwing distance, thereby reducing the combat efficiency. I also read a lot of articles, and found that they are all the same clichés, nothing more than adjusting the brakes and practicing more, which is not very helpful.

Later, at least two senior anglers who have played Lure for many years told me a little trick, which is simple and clear in the non-prosecution style, but after trying, the probability of Xiguang Fang and the class blowing up the line is greatly reduced, and it almost does not affect the throwing distance, this method is "rubbing the cup" ("rubbing the line").

Let's talk about how to operate first, that is, after throwing the end into the black Fan Jiehao, the thumb belly is like a group of "rubbing" on the edge or line of the ** cup, and exert a very subtle force on the line cup or fishing line. Don't underestimate this pressure, it can definitely make the rotation of the wire cup more stable.

When the speed of the lure decreases or falls into the water, the line cup will actually rotate a little more than one or two times, but the rotation caused by this inertia will not cause the line to stir together, that is, it will not blow the line. Moreover, it has very little impact on the casting distance, making it suitable for a variety of fishing scenarios.

For the Lure master, of course, there is no need to use such methods to write the Xun Mei professional control line cup. But for most lure players, especially novice players, this tip is very simple and practical, and friends who are troubled by the fried line can feel it.