High voltage wires, rectification, there is a section that is not a leather wire, who should be resp

There is a section of the high-voltage wire rectification that is not a leather wire, and if there is a problem, it should be borne by the construction party responsible for safety.

If it is a worker and an employer, it is a work-related injury, and if it is a natural person with civil capacity, it is the responsibility of the natural person, but it depends on whether the power supply company is responsible. The leather wire you are talking about is the insulation layer, you have to find the relevant regulations, see if there are relevant regulations according to the geographical location of the power supply, the number of watts transmitted, and other factors, whether there are protective measures and warning signs, etc.

If you encounter this situation, you should call the ** of the power supply bureau, inform him that there is such a situation, see how he replies to you, if he ignores it, it is their responsibility to solve the problem of the power supply bureau.

Of course, the unit responsible for installation and the unit responsible for inspection and acceptance will share the problem. However, if an objection is raised at the time of acceptance, this is not the case.

I also think that in the process of rectification, there must be corresponding people responsible for this paragraph.

Of course, the rectification party is responsible, and the rectification is not good, but the testing party has to put it forward.

When this kind of problem occurs, the main responsibility is the main person in charge of the entire rectification process, and the effective and safe rectification measures must be implemented in order to be better completed.

It has a certain relationship with Guojiadian and the telecommunications company and the electrical company, because he has been responsible for this kind of thing, and he should be responsible.

There is a section of high-voltage wire rectification that is not a leather wire, it should be said that it is not qualified, so who installs the wiring will be responsible.

In terms of the responsibility for the laying of high-voltage lines, it is necessary to find out who laid the source and who is responsible.

Whoever constructs the construction and who contracts it should be responsible.

It's different from place to place, but it seems to be a few cents a pound on my side.

Generally, the pole is about ten meters high, and the two wires are 220V; (It is the kind of wire that is directly pulled to the home, with an insulation layer) a ten-meter-high pole, three wires: 380V; (Basically, they are connected to the community, divided into three colors: yellow, green and red, with an insulating layer).

More than ten meters high thick poles or small towers, with three wires as a group: 10kV; (No insulation).

Therefore, for the power overhead lines of 10kV and below in the distribution network, there can be insulated wires;

For power overhead lines of 35kV and above, there are currently no insulated wires.

Just use the ** wire, use the cable, in case it is stolen.

1. It is best not to use leather wires, or replace them with network cables, and make sure to use leather wires, not parallel, and twisted pairs.

2. You can choose to connect from the cable, the cable is copper, and the insulation and resistance are much smaller.

3. The traffic also depends on how far the computer room is from your home, which is not guaranteed.

Connect your ** wire directly from the cable. It won't have much of an impact.

The leather wire is too long, and it is not good to get home, and you said that the heavy cable is out, and it is basically impossible to get the main line.

Broadband signal transmission must be good cables Telecommunications do not know how far away Tietong I know that it will not be installed before more than 200 meters This hope is useful.