What is the fault of the actual voltage of the adapter with an output voltage of 12V, which is about

If the input voltage is not enough or the number of miscellaneous coils in the 4-stage coil is not enough, the output voltage will not reach the rated value.

I don't know if the flyback topology is used, when the system outputs 6V, the chip power supply is not enough under normal circumstances. Take a look at whether it is good to connect the RCD absorption circuit in parallel on the two pins of the transformer connected to the high voltage.

At 10:30 a.m., the actual voltage of the gas distribution is about 6 volts, which is not partly due to the error of the voltage appearance or measurement.

This may be caused by the fact that there are parallel loads, so that the voltage division of the total responsibility voltage is divided.

This is a faulty circuit on the adapter.

Generally speaking, I think that if the output voltage of the adapter is actually in the voltage, it is possible that there is a problem with the fault inside.

Remember, the voltage can't be high, the current can be slightly larger, and the appliance you're talking about will burn out with a 24 V band, and you can use a 12 V 2A power supply with two appliances with a rated voltage of 12V and a rated current of 1A.

A bit of a 12V adapter, the actual voltage is about six banks. In this case, there may be certain regulations.

The output voltage of 12 volts is the actual voltage of Peggypa Well, this is what they may be, if the two stores do not meet the problem, there may be some faults.

The voltage of the 12V output is measured to be 58V.

Dear users, if you measure the voltage of 12V output and the measured voltage is 58V, there may be several reasons:1Problems with measuring instruments:

There may be faults or errors in the source guessing of the measuring instrument, resulting in inaccurate measurement results. It is advisable to replace the measurement with a new, reliable measuring instrument. 2.

Abnormal power supply output voltage: The abnormal output voltage of the power supply may be caused by damage to the internal components of the power supply or overload of the power supply. It is recommended to check whether the internal components of the power supply are normal, or replace the power supply with one that meets the requirements.

3.Wrong circuit connection: If the circuit is connected incorrectly, the voltage may be abnormal.

It is recommended to check whether the circuit connection is correct and ensure that the circuit connection is correct. 4.Excessive circuit load:

If the circuit is overloaded, it may cause voltage abnormalities. It is recommended to check if the circuit load is too large, and if it is, the circuit load needs to be reduced. In short, if you measure the voltage of the 12V output and the measured voltage is 58V, you need to carefully investigate the causes of cracking, find out the problem, and then take appropriate measures to fix it.