Why do you have to check every time you turn on your computer after a sudden power failure? Didn t s

Updated on healthy 2024-04-18
10 answers
  1. Anonymous users2024-02-07

    The operating system has a self-protection function, yours belongs to an abnormal shutdown, the operating system will perform partition and file checks the next time you boot up, as for what you said every time, rest assured, just a few times, because sometimes he will scan partitions in batches, and this will happen in multiple partitions.

  2. Anonymous users2024-02-06

    It's hard disk detection.

    Only the one time the power is off is to be detected, and the next time it will not be.

    If it is ordinary, detect whether there is a small fault in the hard disk. Try it on a different computer.

    It is possible that there is a problem with the chip on the hard drive.

  3. Anonymous users2024-02-05

    Yes. After an illegal shutdown. If the data on the hard drive is not saved, the power will be lost. So it will self-test and repair when it is turned on.

  4. Anonymous users2024-02-04

    System Issues! Normal should have skipped.

  5. Anonymous users2024-02-03

    You wait for it to be checked all at once. Not next time. Don't move any keys when you turn it on.

  6. Anonymous users2024-02-02

    Illegal power-off monkeys have to self-check!

  7. Anonymous users2024-02-01

    My computer - tree - advanced - boot and failure recovery - turned off the top display time.

  8. Anonymous users2024-01-31

    Categories: Computer Messaging Network >> Operating System System Fault Problem Description:

    Because of the power outage, my computer now has to self-check every time it is turned on, how can I solve it??

    Analysis: The solution is very easy, please let the system self-test normally, when the self-test is completely over, it will not appear when the rock is equipped with the system in the future.

    Because the windows system for the stability of the system, when there is an abnormal shutdown, then the next boot system will scan the partition and files that were used last time, if the next system boot does not start normally, then the system will automatically record this information that has not been self-tested, until there is a normal self-test after the end of the process. The purpose of the program is to see if any files are missing or corrupted, and to reassemble the fragments of the files into a file for preservation.

    I hope that the landlord will not underestimate this program, because a large part of the computer with damaged hard disk is because of too much fragmentation on the disk, resulting in the increase in the working pressure of the head when reading the files on the hard disk, thereby increasing the probability of bad sectors of the hard disk, as well as the service life.

  9. Anonymous users2024-01-30

    In the case of automatic power off after powering on, it is very likely that the power supply or motherboard is faulty. The causes of the failure are varied, such as IC chips, capacitors burned out, a circuit problem, etc., generally speaking, such a fault is not possible to repair the individual can not be repaired, it is recommended to send it for repair or replace the relevant accessories, it is recommended to try to replace the power supply first. In addition, the power supply quality problems of the mains (such as low voltage, abnormal fluctuations, etc.) may also cause this fault phenomenon of power failure when the power is turned on.

    The power-off fault may also be caused by the following reasons: first, there is a problem with the power switch of the case, such as the failure of the reset spring, and the second is that the CPU has been overclocked late, or there is a problem with the CPU fan. Third, there are short-circuit faults in accessories such as optical drives and hard drives.

  10. Anonymous users2024-01-29

    The computer often surrenders to the friend with the reason for restarting:

    1: The CPU temperature is too high due to the poor cooling effect of the CPU fan.

    2: There is a conflict between the system and some software, which causes the system to be stable (the probability is very low) 3: There is a compatibility problem with the hardware.

    No self-test when powered on.

    None of the new machines come with a system. Generally, the ** merchant will tell you that you have installed the ghost version of the optimized system.

    In the optimized system, the system self-test is generally turned off.

    Sum it up. It could be hardware compatibility. It's a good idea to post your config. Branded.

Related questions
16 answers2024-04-18

You can first check what the maximum temperature of your CPU is in the BIOS, and then estimate that the power is almost out (about 2 hours) and restart. Take a look at what the current temperature is, and if it almost reaches the upper limit temperature, you can consider the CPU temperature. And are you sure your power supply is available, enough power? >>>More

15 answers2024-04-18

CHKDSK is a disk self-test program that comes with Windows, and this interface indicates that there are files on your hard disk that are corrupted. After this interface appears, you should not rush to turn it off, do not touch the computer, and let chkdsk run to finish. It usually runs out in 10 minutes. >>>More

5 answers2024-04-18

What is the configuration of the computer?

Overwatch Game Spec Requirements: >>>More

8 answers2024-04-18

Workarounds for malfunctions such as game cards or freezes: >>>More

17 answers2024-04-18

Normal shutdown" caused!

1。Try to boot the computer, after the computer brand is out, press F8, press Enter, Enter, enter the safe mode, and start advanced. >>>More