Why is the Euro Leopard 110 tractor slow to ignite?

The tractor is slow to ignition, generally because the oil temperature is too low, and some people use fire to burn the tractor's head for a while in winter before ignition.

The ignition of the Oubao tractor is sluggish. It is because of the problem of the flint and steel of the tractor, which is slow to react at any time.

The reason why this tractor is slow to ignite is because the battery inside is not working, and if you can replace a battery, you can generally solve the problem.

If the ignition is sluggish, it is usually because there is too much dust in it, or it is too old.

The Opel 110 tractor is slow to ignite, which means that the one is the one in the lighter. Relatively slow. The second is that his oil sprays more slowly.

If the Oubao 110 tractor is slow to ignite, it may be that it was damaged during his ignition.

There may be many reasons for the slow ignition of the tractor, and you can only check it, see the specific reasons, and then repair it.

Well, the Opel 110 tractor is slow to ignite because of the use of its engine.

If the ignition of the tractor is sluggish when it starts, it means that there is a problem with the piezoelectric coil, or there is a problem with the ignition coil, and you should check it.

You go to the maintenance place to check, the situation is more, a sentence or two can not be clear, this is the best way, save trouble and time, I hope to help you, hope.

There should be a problem, there is a delay, and when I was looking for a major, I said that I would take a look at the climate.

I reported 110 tractors, why is it that the ignition is sluggish and may not be able to react all at once? Or maybe it's caused by poor contact, so you take a look.

Why is the Opel 110 tractor lighter? I think the Opel Zero Tractor Ignition is worth it because it's aged.

Why is the Opel 110 tractor slow to ignite, I am because of this. Because the quality of the Oubao tractor is very poor, he is slow to ignite.

The current OPPO 110 tractor is sluggish for a while, I think it's also because of their own line problems, we should all adjust it.

If the tractor is slow to ignite, it means that there is a problem with the quality, and you can find after-sales maintenance personnel to check it.

Buy a Foton car.

It is recommended not to buy it. 150 horsepower tractor, domestic can not exceed 35w at most, domestic is best to buy Dongfanghong.

It is recommended to buy imported Case. New Holland. Valmet. Dir.

However, ** is twice as much as the domestic one.

I have a friend who bought a Valmet 185 for 6w euros.

Hello! Check if the battery Bixin is seriously losing power? Is the positive and negative connection wires of the battery rusted by the loose hand wheel? Is there any loosening and rusting of the iron wire of the negative spring pole? FYI.

If the tractor is out of power, it is usually the fuse that is burned, and the fuse can be checked.

The main aspects of engine squeak and squeak are as follows:

1. Abnormal noise caused by engine knocking. It is mainly caused by the abnormal noise caused by the early ignition advance angle, the abnormal combustion of the fuel spontaneous combustion, the excessive carbon deposition in the combustion chamber, the overheating of the engine, and the low octane gasoline.

2. Abnormal sound caused by piston knocking on the cylinder. It is mainly caused by improper piston profile design, excessive cylinder clearance, piston assembly error, etc.;

3. The piston pin is abnormal. It is mainly caused by excessive piston pin wear and excessive fitting clearance;

4. Abnormal valve noise. It is mainly caused by excessive valve clearance;

5. Abnormal sound of bearings. It is mainly caused by the abnormal noise caused by the excessive mating clearance caused by the serious wear of the bearing.

The abnormal noise of the engine is mainly caused by abnormal combustion, improper size matching between moving parts, or improper design of dimensional tolerances, which are mainly caused by moving parts.

Dry farm engines are very worn, and almost always they are in full load. Remove the thermostat plug and keep the engine water tank clean.

The power take-off shaft of Foton Oubao 920 tractor is 1000 revolutions per minute.

Lovol Leopard FT920 tractor two-wheel drive, fan cab (8000 yuan), Lovol power 1004-4TRT or Quanchai 4112 engine (68kw), flat floor, 16+8 shuttle shift, meshing sleeve shift, with differential lock, class suspension, position adjustment strong pressure lifter, new generation hood, two-way hydraulic output, hydraulic steering, independent operation of the double-acting clutch, two-speed power output (760 1000r min, 540 1000r min, 540 760r min), front and rear tires (; Origin of the whole machine: Weifang.

(1) Adjustment of the wheel base.

If the width of the seeder is much larger than the tractor's track, the track does not need to be adjusted; However, if the width of the seeder is less than or close to the wheel base of the tractor, in order to ensure the quality of sowing and prevent the rear wheel of the tractor from pressing, the center distance of the rear wheel of the tractor should be adjusted before sowing, so that it happens to walk in the unsown land or in the ditch that has been sown.

Generally, it is adjusted by changing the installation direction and position of the rear wheel hub and the front and back of the spokes. With the adjustment of the rear wheel track, the front wheel track must be adjusted accordingly, and attention must be paid to the symmetry and overall balance of each wheel can not be destroyed. At the same time, pay attention to the pattern of the tire must not be reversed.

2) Adjust the hooking state of the machine.

When the tractor is hooked with the seeder, the center of the tool should be connected to the center of the tractor according to the required connection position to ensure the profiling performance of the seeder.

The hooking state of the seeder affects the soil penetration performance, the consistency and stability of the trenching depth, and even affects the amount of seeding due to the inclination of the seeder, so the hooking state of the seeder should be adjusted before sowing. There are two aspects of adjustment: front and rear level adjustment and left and right level adjustment

a.Trailed seeder adjustment. The traction seeder can be adjusted by changing the pin hole position of the traction ring on the traction plate, so that the seeder can be kept in a horizontal state before and after; By adjusting the height of the left and right wheels, the seeder can be kept left and right horizontal.

b.Suspension unit adjustment. For suspension units, it is possible to adjust the length of the upper tie rod of the tractor suspension device, adjust the front and rear levels of the unit.

If the unit is low in the front and high in the back, the length of the upper tie rod can be increased; If the unit is high in the front and low in the rear, the length of the upper tie rod is shortened. The left and right horizontal adjustment of the unit can be adjusted by adjusting the length of the right pull rod on the tractor suspension device, and the right pull rod is elongated, and the right side of the unit descends; Shorten the right tie rod and the right side of the unit rises. In order to maintain the profiling performance in the left and right directions of the implement, the tie rod joint of the tractor suspension device should be placed in the long hole, and the hydraulic lever should be placed in the floating position when working.

The turbocharger is broken, and it's normal to turn on the fire and think like a whistle, it's not normal for you to go in a bad direction.

There shouldn't be any big problems, probably in a few aspects:

1. The air filter is dirty or blocked;

2. The diesel engine respirator is partially blocked;

3. The sound of the belt.

Still, if it's not a hassle, it's best to have a professional take a look.

The tensioner wheel on the generator belt, the oil is immediately ready.

The cooling water circulation is poor, and the water is boiled at high temperature with a large throttle.

If the cylinder gasket is broken, there will also be a lack of water.