What happens when I change the front windshield and there is a wind whistle?

1. Reason: 1. The central control plastic board is not tightly buckled. Solution: Disassemble the center console.

Reason 2, the front windshield into the dust. Solution: Remove the adapter plate and clean it to remove the abnormal noise.

2. Solutions to abnormal noise under the front windshield: 1. See if there is any foreign object on the inside of the glass, and remove it if there is; 2. Whether the wiper outside the car is close to the glass, if there is a gap, it may vibrate and make a sound, and you can stuff some waste sponge in the gap; 3. The windshield strip is loose, and you can find professional technicians to repair it.

There are three ways:

1. Clean the dust of the sunroof slide rail and apply lubricating oil;

2. Tighten the loose screws;

3. Replace the sunroof seal.

1. Remove the dust on the sunroof slide rail, and apply some lubricating oil on the slide rails on the left and right sides of the skylight, especially the abnormal noise parts can be appropriately coated more.

2. Some loose fixing screws are tightened, and the chute is cleaned regularly.

3. Because the sunroof sealant is often exposed to the sun and rain, it should be replaced regularly.

If the vehicle is driving on bumpy roads, try not to open the sunroof, because if the vibration between the sunroof and the slide rail is too large, it will cause deformation of the sealing parts, and in severe cases, it may also cause damage to the motor. Therefore, when the vehicle passes over a bumpy road, it is best for the owner to close the window to avoid causing more damage to the vehicle.

Sunroof daily maintenance skills:

1. Pay more attention to the status of the sunroof guide.

It is necessary to get into the habit of checking the sunroof rails, and if you wait until there is an abnormal situation to remedy it, it will be too late.

2. The frequency of use of sunroofs should not be too high.

Although the sunroof is also part of the window, its mechanical structure is not the same as that of the door window, and it is also much more squeamish.

3. Don't open the sunroof immediately when the car is cold in winter.

Winters in the north are unusually cold, and after the car is parked overnight, the edge of the sunroof may be frozen with dew and cannot be opened for a while. At this time, you must not open the sunroof immediately, because the snow in the sunroof trench will increase the resistance of the sunroof opening, and blindly operating the sunroof will cause the sunroof switch motor to burn.

4. Check the drainage status of the skylight before the rainy season.

The sunroof actually "enters the car", but the water seeping into it will flow out of the car through the drainage hole of the sunroof bracket and will not enter the cabin. However, if you find that the edge of the sunroof in the cabin will seep or even leak after rain, then it is necessary to check whether the drainage hole of the sunroof is blocked.

This situation should be caused by the failure to seal the front windshield properly when it was replaced.

See if it's a problem with the seal.

Abnormal noises on the windshield are generally related to car wipers.

Abnormal noises on the windshield are generally related to car wipers. If it is an abnormal sound from the contact surface between the wiper blade and the glass, there are generally two reasons at this time: the wiper should be replaced, or the glass should be washed.

Among them, the most direct reason is the aging of the rubber strip of the wiper blade, which leads to hard deformation and cannot be fully bonded with the car glass, resulting in abnormal noise. This is where it comes to thinking about replacing the wiper blades.

Precautions for car wipers:

If the vehicle is parked in the open air for a long time and the car is not washed in time, it is easy to produce a layer of oil film on the windshield, and it is not clean to use the wipers to deal with it at this time. At this time, what you need to do is to clean the car glass in time.

The formation of oil film includes insect oil, gum, and exhaust emissions, etc., which will form a layer of transparent substance on the front windshield glass for a long time, which will have some impact on the line of sight. Many car owners will find that the front gear is dark after the car is used for a period of time, which is actually due to the influence of the oil film.

“1.Warm up the car enough to allow the engine water temperature to rise. When there is frost on the windshield in front of the vehicle, you can't use the wipers to scrape the ice, you should heat the car in situ, and never slow down to warm the car, after all, the view is blocked and you can't see anything.

You need to wait patiently for the water temperature of the engine to rise, and do not turn on the heater while waiting. 2。Warm air blows on the front windshield.

When the engine water temperature rises, turn on the heater and turn it to blow the windshield upwards to turn the heater on.

This sound is not the cause of the glass, I have also encountered, go to the 4S shop master told me that it is because the plastic on both sides of the protective glass is deformed by the sun, plus the hook inside the glass on the oil is dry, so it sounds, not a big deal, when you have time, go to the repair shop to add some oil, then the plastic does not have to care. Hope it helps, I hope it is adopted.

Summary. This is wind noise, which means that the glass is not glued well in some places, and the primer is unevenly applied or not fully pressed, resulting in air leakage in some places, and wind noise will be generated when driving.

Hello very nice for your question.

This is wind noise, which means that the glass is not glued well in some places, and the primer is unevenly applied or not fully pressed, resulting in air leakage in some places, and wind noise will be generated when driving.

The front windshield is over 60 and there is a wind whistle.

That's right, because when the speed is fast, the resistance is also greater, so the sound will be obvious.

You can go to the repair shop again to check, it should be that the glass was not sealed properly when it was replaced.

The windshield is not sealed properly when it is replaced, so this sound is definitely produced.

At low speeds, it is not easy to be detected, and as long as the speed comes up, it will be heard.

Yes, there is a fast speed.

Is there no other solution?

The explanation is that the very small holes are not sealed, and the glass is being re-made in the new one.

You can go to the place where you change the glass to find the other party to replace it again, and let him check it for you, and there is another way, you can fill a plastic bottle with soapy water yourself, and spray the glass with a few small holes in the bottle cap for a week, and check that the bubbling must not be sealed well.

Thank you! If you squeak first of all, you can see if the front windshield is not properly installed and sealed.

The front windshield is not properly installed and sealed.

You can do this, use a piece of soft stuff to try to hold up the front gear glass or find someone in the passenger seat to help you press the front gear glass, sew the corners with adhesive tape again, run to see if it still squeaks, if not, it means that the windshield is not sealed properly.

You can do this, use a piece of soft stuff to try to hold up the front gear glass or find someone in the passenger seat to help you press the front gear glass, sew the corners with adhesive tape again, run to see if it still squeaks, if not, it means that the windshield is not sealed properly.

Second, if it still rings, then see if the center console is loose, press him with your hand, see if it still rings, if it doesn't ring, it's it, just reinstall it.

Third, that is, when the wiper is changing the windshield, it is dirty, broken, and it is not fixed well when running, and it vibrates back and forth, resulting in a loud sound.

1. See if there is any foreign matter on the inside of the glass, and remove it if there is;

2. Whether the wiper outside the car is close to the glass, if there is a gap, it may vibrate and make a sound, and you can stuff some waste sponge in the gap;

3. If the windshield strip is loose, you can find professional and technical personnel to repair it (the new car should not, if it exists, you can apply to the vehicle for repair.) ）

Hello, the front windshield of the car produces abnormal noise, probably because there is some dust left in the place where the wiper cover and the windshield meet, resulting in a loose seal between the two, because of the friction between the deflector groove and the glass under the front windshield, so it will produce abnormal noise. I hope my answer can help you, and I hope to adopt it!

Clause.

1. The glass surface should be cleaned.

Clause. 2. Caused by the aging of the rubber of the wiper blades.

Hope it helps.

Answer dear --- possible reasons: 1. The connecting screws of the ground parts are loose and need to be tightened 2. The shock absorber is abnormal and needs to be replaced 3. The most serious thing is that the body has an abnormal sound, which needs to be replaced.

The question is that the front windshield shakes and there is an abnormal sound.

Answer my dear: If the glass makes a noise, it will leak. Open and check the car for loose parts, fenders, and bumpers under the machine cover. The sound is certainly not glass.

Honey - how to get rid of windshield noises.

A: 1Abnormal body noise.

This problem is usually due to the lack of stiffness of the body, which leads to the deformation of the vehicle during driving, the friction or shaking of the door and the frame, or the friction between the steel plates due to dewelding in some places. Methods such as sticking adhesive strips on doors and windows or padding rubber on friction parts may reduce or eliminate abnormal noises, 3 more

Is it normal for a manual transmission to have an abnormal sound inside the manual transmission when it is engaged in reverse gear?

Hello, happy to answer for you. 1. Reason: 1. The central control plastic board is not tightly buckled.

Solution: Disassemble the center console. Reason 2, the front windshield into the dust.

Solution: Remove the adapter plate and clean it to remove the abnormal noise. Second, the solution to the abnormal noise under the front windshield:

1. See if there is any foreign matter on the inside of the glass, and remove it if there is; 2. Whether the wiper outside the car is close to the glass, if there is a gap, it may vibrate and make a sound, and you can stuff some waste sponge in the gap; 3. The windshield strip is loose, and you can find professional technicians to repair it. Hope it helps you and I wish you happiness and happiness every day! 