The prompt of the firewall when the computer is turned on, and the firewall is displayed after the c

That's your system firewall is not turned on, right?,If you turn on the system's firewall in the control panel, there shouldn't be this prompt.,You have to turn it on and there's this prompt.,It is recommended that you turn off this prompt.,Anyway, you're all on! You can change the way the security center notifies me on the left side of the control panel, click on it and remove the small tick in front of the firewall, and there will be no prompt in the future.

You install 360 bar, boot prompt, you can start the project management, it is 360 can not recognize the system start project, if it is a malicious start project, you have to pay attention!

Use 360 to cancel abnormal services! This: nvcpldaemon you allow no problem!

Phenomenon: Name: NVCPLDAEMON

Path: C: Windows System32, NVSastartup

Company: Behavior Description: Added a system startup item.

Location: Hkey Local Machine Software, Microsoft Windows, CurrentVersion Run

Interpretation; Description:

NVCPLDAEMON (is an NVDIA graphics card-related file.)

Belongs to: NVIDIA Graphics Library Module

System DLL file: No.

Common errors: file not found, missing file, exception errors

Security level (0-5): 0

Spyware: No.

Adware: No.

This is the boot setup for the nvidia graphics card.

It doesn't matter if you refuse it or not.

Anyway, the graphics card effect has been adjusted now, but even if you reject it, it will still boot up in the future, because it is necessary for hardware boot. It doesn't have any effect on your machine.

The driver file of the graphics card,If you don't want it to start,Go to the start of running msconfig in the startup item to prohibit it,If it doesn't work here, go to the service item and check it out in front of it。

Needless to say, you click allow, normally, it's loading your graphics card driver.

nvidia, this is the brand of your graphics card.

This should be Rising, are you using Rising?

1. First, left-click win10 to start the dish finger sock list, and then click "Control Panel".

2. If you can't find it by left-clicking on the start menu, you can try right-clicking on the start menu.

3. After opening the control panel, click "Security & Maintenance" to enter.

4. After entering "Security and Maintenance", only the rubber can see the blue font of "Network Firewall" and "Close Network Firewall Messages" below on the right page. Click directly on the blue word to close it directly.

5. Of course, you can also select "Change Security and Maintenance Settings" on the left panel for more detailed modifications.